Flow pattern characterization for R-245fa in minichannels: Optical measurement technique and experimental results

Abstract An optical measurement method using image processing for two-phase flow pattern characterization in minichannel is developed. The bubble frequency, the percentage of small bubbles as well as their velocity are measured. A high-speed high-definition video camera is used to measure these parameters and to identify the flow regimes and their transitions. The tests are performed in a 3.0 mm glass channel using saturated R-245fa at 60 °C (4.6 bar). The mass velocity is ranging from 100 to 1500 kg/m2 s, the heat flux is varying from 10 to 90 kW/m2 and the inlet vapor quality from 0 to 1. Four flow patterns (bubbly flow, bubbly–slug flow, slug flow and annular flow) are recognized. The comparison between the present experimental intermittent/annular transition lines and five transition lines from macroscale and microscale flow pattern maps available in the literature is presented. Finally, the influence of the flow pattern on the heat transfer coefficient is highlighted.

[1]  Vladimir Klimenko,et al.  PREDICTION OF HEAT TRANSFER FOR TWO-PHASE FORCED FLOW IN CHANNELS OF DIFFERENT ORIENTATION , 1990 .

[2]  Pedram Hanafizadeh,et al.  Experimental investigation of air–water, two-phase flow regimes in vertical mini pipe , 2011 .

[3]  Owen C. Jones,et al.  The interrelation between void fraction fluctuations and flow patterns in two-phase flow , 1975 .

[4]  John R. Thome,et al.  Void fraction prediction in annular two-phase flow , 2012 .

[5]  G. Ribatski,et al.  Evaluation of flow patterns and elongated bubble characteristics during the flow boiling of halocarbon refrigerants in a micro-scale channel , 2010 .

[6]  Goichi Matsui,et al.  Automatic identification of flow regimes in vertical two-phase flow using differential pressure fluctuations , 1986 .

[7]  S. Rouhani,et al.  CALCULATION OF VOID VOLUME FRACTION IN THE SUBCOOLED AND QUALITY BOILING REGIONS , 1970 .

[8]  Bruno Bauwens,et al.  Mapping of horizontal refrigerant two-phase flow patterns based on clustering of capacitive sensor signals , 2010 .

[9]  J. Thome,et al.  Macro-to-microchannel transition in two-phase flow: Part 1 – Two-phase flow patterns and film thickness measurements , 2011 .

[10]  A. Matheen.  Heat Transfer Laboratory , 2006 .

[11]  R. Shah,et al.  Fluid Flow and Heat Transfer at Micro- and Meso-Scales With Application to Heat Exchanger Design , 2000 .

[12]  Ziping Feng,et al.  Two-phase flow in microchannels , 2002 .

[13]  Dusan P. Sekulic,et al.  Classification of Heat Exchangers , 2007 .

[14]  S. Zivi.  Estimation of Steady-State Steam Void-Fraction by Means of the Principle of Minimum Entropy Production , 1964 .

[15]  P. Kew,et al.  Correlations for the prediction of boiling heat transfer in small-diameter channels , 1997 .

[16]  Linyan Xu,et al.  Gas/liquid two-phase flow regime identification by ultrasonic tomography , 1997 .

[17]  J. Thome,et al.  Heat transfer, pressure drop, and flow pattern recognition during condensation inside smooth, helical micro-fin, and herringbone tubes , 2007 .

[18]  John R. Thome,et al.  Experimental investigation of velocity and length of elongated bubbles for flow of R-134a in a 0.5 mm microchannel , 2008 .

[19]  S. Rouhani,et al.  Two-phase flow patterns: A review of research results , 1983 .

[20]  J. Thome,et al.  Investigation of Flow Boiling in Horizontal Tubes: Part II, Development of a New Heat Transfer Model for Stratified-Wavy, Dryout and Mist Flow Regimes , 2005 .

[21]  J. Thome,et al.  Flow Boiling in Horizontal Tubes. Part 1; Development of a Diabatic Two–Phase Flow Pattern Map , 1998 .

[22]  Goichi Matsui,et al.  Identification of flow regimes in vertical gas-liquid two-phase flow using differential pressure fluctuations , 1984 .

[23]  Frank Y. Shih,et al.  Recognition of gas–liquid two-phase flow patterns based on improved local binary pattern operator , 2010 .

[24]  Mikio Suo,et al.  Two phase flow in capillary tubes , 1964 .

[25]  K. Aziz,et al.  A flow pattern map for gas—liquid flow in horizontal pipes , 1974 .

[26]  John R. Thome,et al.  Characterization of diabatic two-phase flows in microchannels: Flow parameter results for R-134a in a 0.5 mm channel , 2006 .

[27]  I. Zun,et al.  Unified mechanistic multiscale mapping of two-phase flow patterns in microchannels , 2013 .

[28]  A. Dukler,et al.  A model for predicting flow regime transitions in horizontal and near horizontal gas‐liquid flow , 1976 .

[29]  Isao Kataoka,et al.  Turbulence structure of air-water bubbly flow—I. measuring techniques , 1975 .

[30]  Ovadia Shoham,et al.  Flow pattern characterization in two phase flow by electrical conductance probe , 1980 .

[31]  D. Chisholm.  Two-Phase Flow in Pipelines and Heat Exchangers , 1983 .

[32]  John R. Thome,et al.  Flow pattern-based flow boiling heat transfer model for microchannels , 2013 .

[33]  Said I. Abdel-Khalik,et al.  Gas–liquid two-phase flow in microchannels Part I: two-phase flow patterns , 1999 .

[34]  John R. Thome,et al.  Elongated bubbles in microchannels. Part I: Experimental study and modeling of elongated bubble velocity , 2008 .