Oxidative coupling of methane (OCM) in a catalytic membrane reactor and comparison of its performance with other catalytic reactors

Abstract The oxidative coupling of methane (OCM) was studied in a catalytic membrane reactor (CMR), catalyst packed bed reactor (PBR) and catalyst packed bed membrane reactor (PBMR) respectively. The CMR consists of a mixed ionic-electronic conducting membrane (MIECM) Ba 0.5 Ce 0.4 Gd 0.1 Co 0.8 Fe 0.2 O 3− δ (BCGCF) coating on the outer surface of ceramic tubular support using sol–gel method. The inner surface of the membrane tube was coated with 3 components (Na-W-Mn) catalyst using mixture slurry dip coating method. Prior to the OCM reaction, separation of oxygen from the mixture of nitrogen and oxygen similar to air composition was performed in the membrane reactor. In the absence of chemical reaction, the oxygen permeation flux was 0.6 cm 3 /min cm 2 at 900 °C with sweep gas flow rate 100 cm 3 /min. The oxygen permeation flux increased significantly during the oxidative coupling of methane reaction. 67.4% of C 2+ selectivity and methane conversion of 51.6% with oxygen permeation flux 1.4 cm 3 /min cm 2 was obtained at 850 °C with sweep gas flow rate of 100 cm 3 /min. The performances of PBR and PBMR using Na-W-Mn/SiO 2 were compared with the performance of CMR. The catalytic membrane reactor performed best among three reactors with C 2+ yield of 34.7%. The deterioration of the catalytic membrane performance after reaction was investigated by SEM and XRD analyses.

[1]  V. Kharton,et al.  Oxygen permeability of LaGa0.65Ni0.20Mg0.15O3−δ ceramics: effect of synthesis method , 2003 .

[2]  Zongping Shao,et al.  Performance of a mixed-conducting ceramic membrane reactor with high oxygen permeability for methane conversion , 2001 .

[3]  R. Dittmeyer,et al.  Studies on oxidative coupling of methane using high-temperature proton-conducting membranes , 1997 .

[4]  Huanling Song,et al.  Comparative study on oxidation of methane to ethane and ethylene over Na2WO4–Mn/SiO2 catalysts prepared by different methods , 2006 .

[5]  Subhash Bhatia,et al.  Process optimization of oxidative coupling of methane for ethylene production using response surface methodology , 2007 .

[6]  Y. S. Lin,et al.  Oxygen permeation and oxidative coupling of methane in yttria doped bismuth oxide membrane reactor , 2000 .

[7]  Y. S. Lin,et al.  Optimum operation of oxidative coupling of methane in porous ceramic membrane reactors , 2003 .

[8]  Yaping Lu,et al.  Oxygen-permeable dense membrane reactor for the oxidative coupling of methane. , 2000 .

[9]  M. Menéndez,et al.  Development of ceramic membrane reactors with a non-uniform permeation pattern. Application to methane oxidative coupling , 1994 .

[10]  Jerry Y. S. Lin,et al.  Oxygen permeation through oxygen ionic or mixed-conducting ceramic membranes with chemical reactions , 2004 .

[11]  Miguel Menéndez,et al.  Methane oxidative coupling using porous ceramic membrane reactors. I: Reactor development , 1994 .

[12]  Miguel Menéndez,et al.  Methane oxidative coupling using porous ceramic membrane reactors—II. Reaction studies , 1994 .

[13]  Zongping Shao,et al.  Investigation of the permeation behavior and stability of a Ba0.5Sr0.5Co0.8Fe0.2O3−δ oxygen membrane , 2000 .

[14]  A. Veen,et al.  Influence of oxygen supply rates on performances of catalytic membrane reactors , 2007 .

[15]  Haihui Wang,et al.  Oxidative coupling of methane in Ba0.5Sr0.5Co0.8Fe0.2O3−δ tubular membrane reactors , 2005 .

[16]  Selective oxidative coupling of methane with membrane reactor , 1992 .

[17]  Kus Hidajat,et al.  Oxidative coupling of methane in a solid oxide membrane reactor , 1997 .

[18]  Yi Hua Ma,et al.  Oxidative coupling of methane in a modified γ-alumina membrane reactor , 2000 .