Abstract Micromilling is one of the technologies widely used to manufacture microstructures and tooling inserts for microinjection moulding and hot embossing. A number of manufacturing constraints remain that limit the application of this technology. One of these constraints is that the existing machining strategies are not appropriate for the manufacture of features that are common in micro parts. This paper discusses an approach for optimizing these strategies. The aim is to provide users of computer aided manufacturing (CAM) systems with tools enabling them to generate cutter paths that take into account the specific conditions arising during micromilling. The paper studies the advantages and disadvantages of using different machining strategies for micromilling and then verifies their capabilities experimentally. Also, an approach is proposed for storing and re-using expert knowledge about micromachining strategies associated with different feature types.
[1]
Byoung Kyu Choi,et al.
Modeling the surface swept by a generalized cutter for NC verification
,
1998,
Comput. Aided Des..
[2]
E. Lepa,et al.
Principles of machining by cutting, abrasion and erosion
,
1976
.
[3]
Gábor Lukács,et al.
Pocket machining based on contour-parallel tool paths generated by means of proximity maps
,
1994,
Comput. Aided Des..
[4]
Martin Held,et al.
Voronoi diagrams and offset curves of curvilinear polygons
,
1998,
Comput. Aided Des..
[5]
Taylan Altan,et al.
Manufacturing of Dies and Molds
,
2001
.
[6]
Christophe Tournier,et al.
Machining of free-form surfaces and geometrical specifications
,
1999
.
[7]
Ciro A. Rodríguez,et al.
Influence of tool path strategy on the cycle time of high-speed milling
,
2003,
Comput. Aided Des..
[8]
Arthur Flutter,et al.
A machining strategy for toolmaking
,
2001,
Comput. Aided Des..