High strength and high ductility of electrodeposited nanocrystalline Ni with a broad grain size distribution

A nanocrystalline nickel with a broad grain size distribution was prepared by direct current electrodeposition, which exhibited high ultimate strength of 1440–1916 MPa and good ductility of 5.6–11.3% under tensile test at a wide strain rate range (1.35E−6 to 1.35 s −1 ) and room temperature. The good ductility of nc Ni can be attributed to the increased strain hardening ability induced by the inhomogeneous microstrucutre. Two distinguished strain rate sensitivity (0.016 and 0.045) and flow stress activation volume (26b 3 and 11b 3 ) were obtained at normal and high strain rate and low strain rate, respectively. The intrinsic microstructure and extrinsic deformation conditions (low strain rate) lead to the transition in the deformation mechanism from the dislocation mediated deformation to both grain boundary and dislocation deformation with decreasing strain rate. The high near-uniform elongation at low strain rate can be explained by its corresponding high m value. The variation of fracture surface morphology with strain rates also implies the underlying deformation mechanism transition. © 2007 Elsevier B.V. All rights reserved.

[1]  Raymond F. Smith,et al.  Ultrahigh Strength in Nanocrystalline Materials Under Shock Loading , 2005, Science.

[2]  A. Mukherjee,et al.  Deformation of nanocrystalline materials by molecular-dynamics simulation: relationship to experiments? , 2005 .

[3]  Q. Jiang,et al.  Layered nanostructured Ni with modulated hardness fabricated by surfactant-assistant electrodeposition , 2007 .

[4]  E. Lavernia,et al.  Microstructural investigation of nanocrystalline bulk Al–Mg alloy fabricated by cryomilling and extrusion , 2004 .

[5]  S. Suresh,et al.  Mechanistic models for the activation volume and rate sensitivity in metals with nanocrystalline grains and nano-scale twins , 2005 .

[6]  K. Jacobsen,et al.  A Maximum in the Strength of Nanocrystalline Copper , 2003, Science.

[7]  Huajian Gao,et al.  Mechanism-based strain gradient plasticity— I. Theory , 1999 .

[8]  E. Ma.  Watching the Nanograins Roll , 2004, Science.

[9]  Evan Ma,et al.  Tensile properties of in situ consolidated nanocrystalline Cu , 2005 .

[10]  Ning Wang,et al.  Room temperature creep behavior of nanocrystalline nickel produced by an electrodeposition technique , 1997 .

[11]  H. V. Swygenhoven,et al.  Grain Boundaries and Dislocations , 2002 .

[12]  Xuemei Cheng,et al.  Deformation Twinning in Nanocrystalline Aluminum , 2003, Science.

[13]  T. Nieh,et al.  Effects of annealing and impurities on tensile properties of electrodeposited nanocrystalline Ni , 2004 .

[14]  M. Yoshimura,et al.  Diffusion of OH^− during hydration of YBa_2Cu_3O_7-y by exposing to water vapor , 1990 .

[15]  H. V. Swygenhoven,et al.  PLASTIC BEHAVIOR OF NANOPHASE METALS STUDIED BY MOLECULAR DYNAMICS , 1998 .

[16]  A. Sergueeva,et al.  Simultaneously Increasing the Ductility and Strength of Ultra‐Fine‐Grained Pure Copper , 2006 .

[17]  Philippe Spätig,et al.  Deformation behaviour and microstructure of nanocrystalline electrodeposited and high pressure torsioned nickel , 2005 .

[18]  M. Victoria,et al.  Nanocrystalline electrodeposited Ni: microstructure and tensile properties , 2002 .

[19]  P. Krysl,et al.  Deformation mechanism transitions in nanoscale fcc metals , 2003 .

[20]  Subra Suresh,et al.  Some critical experiments on the strain-rate sensitivity of nanocrystalline nickel , 2003 .

[21]  R. Scattergood,et al.  Studies of deformation mechanisms in ultra-fine-grained and nanostructured Zn , 2002 .

[22]  Amit K. Ghosh,et al.  On reported anomalies in relating strain-rate sensitivity(m) to ductility , 1976 .

[23]  Q. Jiang,et al.  Enhanced tensile ductility in an electrodeposited nanocrystalline Ni , 2006, 2006 IEEE Conference on Emerging Technologies - Nanoelectronics.

[24]  R. Valiev,et al.  Nanostructuring of metals by severe plastic deformation for advanced properties , 2004, Nature materials.

[25]  Lei Lu,et al.  Ultrahigh Strength and High Electrical Conductivity in Copper , 2004, Science.

[26]  D. Wolf,et al.  Deformation-mechanism map for nanocrystalline metals by molecular-dynamics simulation , 2004, Nature materials.

[27]  E. Ma,et al.  Instabilities and ductility of nanocrystalline and ultrafine-grained metals , 2003 .

[28]  D. G. Morris,et al.  Ductility of Nanostructured Materials , 1999 .

[29]  Fenghua Zhou,et al.  High tensile ductility in a nanostructured metal , 2002, Nature.

[30]  C. Gu,et al.  High Strength Nanocrystalline Ni‐Co Alloy with Enhanced Tensile Ductility , 2006 .

[31]  H. Conrad.  Grain size dependence of the plastic deformation kinetics in Cu , 2003 .

[32]  Yonghao Zhao,et al.  Simultaneously Increasing the Ductility and Strength of Nanostructured Alloys , 2006 .

[33]  K. Lu,et al.  INTERFACE CONTROLLED DIFFUSIONAL CREEP OF NANOCRYSTALLINE PURE COPPER , 1999 .

[34]  E. W. Hart.  Theory of the tensile test , 1967 .

[35]  Bernard Baudelet,et al.  Necking development and strain to fracture under uniaxial tension , 1986 .

[36]  Imao Tamura,et al.  Tensile deformation of two-ductile-phase alloys: Flow curves of α-γ FeCrNi alloys , 1976 .

[37]  Subra Suresh,et al.  Mechanical behavior of nanocrystalline metals and alloys , 2003 .

[38]  Hongqi Li,et al.  Transition of deformation and fracture behaviors in nanostructured face-centered-cubic metals , 2004 .

[39]  S. Phillpot,et al.  Deformation twinning in nanocrystalline Al by molecular-dynamics simulation , 2002 .