A clip-and-restore technique for phase desensitization in a 1.2V 65nm CMOS oscillator for cellular mobile and base stations

Base-station (BTS) RX oscillator phase noise requirements between 600kHz and 3MHz are difficult to satisfy using a fully monolithic VCO fabricated in bulk-CMOS technology. The GSM-900-BTS and the DCS-1800-BTS RX specifications at 800kHz of -147dBc/Hz and -138dBc/Hz, respectively, are considered the most difficult to meet. In GSM mobile stations (MS), the transmit and receive bands are 20MHz apart, which sets a stringent TX phase noise requirement of -162dBc/Hz at 20MHz offset [1]. A VCO satisfying this inadvertently meets the relatively relaxed RX specification.

[1]  R.B. Staszewski,et al.  A digitally controlled oscillator system for SAW-less transmitters in cellular handsets , 2006, IEEE Journal of Solid-State Circuits.

[2]  Ali M. Niknejad,et al.  A 4-port-inductor-based VCO coupling method for phase noise reduction , 2011, IEEE Custom Integrated Circuits Conference 2010.

[3]  Pietro Andreani,et al.  A 1.4mW 4.90-to-5.65GHz Class-C CMOS VCO with an Average FoM of 194.5dBc/Hz , 2008, 2008 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[4]  T.H. Lee,et al.  Oscillator phase noise: a tutorial , 1999, IEEE Journal of Solid-State Circuits.

[5]  R. A. Hadaway,et al.  Monolithic transformers for silicon RF IC design , 1998, Proceedings of the 1998 Bipolar/BiCMOS Circuits and Technology Meeting (Cat. No.98CH36198).

[6]  C. Hedenas,et al.  A Colpitts Oscillator Design for a GSM Base Station Synthesizer , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.