Manipulation workspace analysis using the Monte Carlo Method

Abstract The Monte Carlo method is used to determine the volume of the workspace of manipulators, the accessibility of the workspaces, and the effect of changes in the geometric parameters on the workspace volume. The method can form part of a routine for the optimal geometric synthesis of manipulators. The Monte Carlo method is shown to be very simple, and readily implemented. Several examples are presented.

[1]  A. Morecki,et al.  Theory and Practice of Robots and Manipulators , 1985 .

[2]  K. Sugimoto,et al.  Determination of Extreme Distances of a Robot Hand—Part 1: A General Theory , 1981 .

[3]  A. H. Soni,et al.  The effect of link parameter on the working space of general 3R robot arms , 1984 .

[4]  J. Rastegar.  Workspace Analysis of 4R Manipulators With Various Degrees of Dexterity , 1988 .

[5]  Ferdinand Freudenstein,et al.  On the Analysis and Synthesis of the Workspace of a Three-Link, Turning-Pair Connected Robot Arm , 1984 .

[6]  A Kumar,et al.  Mapping the Manipulator Workspace Using Interactive Computer Graphics , 1986 .

[7]  J. Spanos,et al.  Workspace Analysis of Regional Structures of Manipulators , 1985 .

[8]  Kenneth J. Waldron,et al.  The Workspaces of a Mechanical Manipulator , 1981 .

[9]  C-C D Lin,et al.  Optimization of the Workspace of a Three-Link Turning- Pair Connected Robot Arm , 1986 .

[10]  K. Sugimoto,et al.  Determination of Extreme Distances of a Robot Hand. Part 2: Robot Arms With Special Geometry , 1981 .

[11]  J. Rastegar,et al.  The effect of joint motion constraints on the workspace and number of configurations of manipulators , 1987 .

[12]  J. Rastegar,et al.  Methods to determine workspace, its subspaces with different numbers of configurations and all the possible configurations of a manipulator , 1987 .

[13]  J. Spanos,et al.  Workspace Analysis of Mechanical Manipulators Using Polynomial Discriminants , 1985 .

[14]  Ting W. Lee,et al.  Heuristic combinatorial optimization in the design of manipulator workspace , 1984, IEEE Transactions on Systems, Man, and Cybernetics.

[15]  Thomas B Sheridan.  Performance evaluation of programmable robots and manipulators , 1976 .

[16]  D. C. H. Yang,et al.  On the Workspace of Mechanical Manipulators , 1983 .

[17]  I. M. Sobolʹ.  The Monte Carlo method , 1974 .

[18]  Kenneth J. Waldron,et al.  Geometric Optimization of Serial Chain Manipulator Structures for Working Volume and Dexterity , 1986 .

[19]  D. C. H. Yang,et al.  On the Evaluation of Manipulator Workspace , 1983 .