Multi-walled carbon nanotubes–cellulose paper for a chemical vapor sensor

Abstract This paper reports the multi-walled carbon nanotubes (MWCNTs)–cellulose paper as a chemical vapor sensor. Cellulose solution was prepared by dissolving cotton pulp in LiCl/N,N-dimethylacetamide solution. MWCNTs were covalently grafted to cellulose by reacting imidazolides–MWCNTs with cellulose solution. Using this product, the MWCNTs/cellulose (M/C) paper was fabricated, followed by mechanical stretching to align MWCNTs with cellulose chains. Characteristics of the M/C paper were analyzed in terms of scanning electron microscope images, Young's modulus and electrical resistance. The M/C paper was investigated as a chemical sensor that can detect vaporized analyte molecules, such as, methanol, ethanol, 1-butanol and 1-propanol. Their electrical responses on the sensor were evaluated by not only comparing their relative resistance response (AR) depending on the concentration, but also checking signal reversibility under cyclic exposure of each analyte. Due to sensitive and reversible expansion/contraction of the M/C paper in response to analytes, the M/C paper showed reversible and fast response with the following rank of AR: methanol

[1]  Sungryul Yun,et al.  A bending electro-active paper actuator made by mixing multi-walled carbon nanotubes and cellulose , 2007 .

[2]  Sungryul Yun,et al.  Discovery of Cellulose as a Smart Material , 2006 .

[3]  Seung-Chul Ha,et al.  Gas sensor measurement system capable of sampling volatile organic compounds (VOCs) in wide concentration range , 2007 .

[4]  Nguyen Van Hieu,et al.  Thin film polypyrrole/SWCNTs nanocomposites- based NH3 sensor operated at room temperature , 2009 .

[5]  P. Su,et al.  Electrical and humidity sensing properties of carbon nanotubes-SiO2-poly(2-acrylamido-2-methylpropane sulfonate) composite material , 2006 .

[6]  Hwa-Jeong Lee,et al.  Enhancement of the field-effect mobility of poly(3-hexylthiophene)/functionalized carbon nanotube hybrid transistors , 2008 .

[7]  Yves Grohens,et al.  Conductive Polymer nano-bioComposites (CPC): Chitosan-carbon nanoparticle a good candidate to design polar vapour sensors , 2009 .

[8]  Lynn Fuller,et al.  A chemical sensor for chloromethanes using a nanocomposite of multiwalled carbon nanotubes with poly(3-methylthiophene) , 2005 .

[9]  Peng Liu,et al.  Modifications of carbon nanotubes with polymers , 2005 .

[10]  Zhen Zheng,et al.  A facile approach to covalently functionalized carbon nanotubes with biocompatible polymer , 2007 .

[11]  Guilherme Andrade Marson,et al.  An efficient, one‐pot acylation of cellulose under homogeneous reaction conditions , 2000 .

[12]  Sungryul Yun,et al.  Paper transistor made with covalently bonded multiwalled carbon nanotube and cellulose , 2009 .

[13]  D. Klemm,et al.  Cellulose: fascinating biopolymer and sustainable raw material. , 2005, Angewandte Chemie.

[14]  Sungryul Yun,et al.  Effect of solvent mixture on properties and performance of electro-active paper made with regenerated cellulose , 2008 .

[15]  Jaehwan Kim,et al.  Electro-active paper actuators , 2002 .

[16]  J. M. Ballingall,et al.  The operation of metalorganic bubblers at reduced pressure , 1990 .

[17]  Sungryul Yun,et al.  Covalently bonded multi-walled carbon nanotubes-cellulose electro-active paper actuator , 2009 .

[18]  Yang Li,et al.  A composite of polyelectrolyte-grafted multi-walled carbon nanotubes and in situ polymerized polyaniline for the detection of low concentration triethylamine vapor , 2008, Nanotechnology.

[19]  Jianbo Lu,et al.  Carbon nanotubes/poly(ε-caprolactone) composite vapour sensors , 2009 .

[20]  Hiroshi Kawarada,et al.  Enhancement of field emission characteristics of tungsten emitters by single-walled carbon nanotube modification , 2006 .

[21]  Hiroshi Shimizu,et al.  Multiwalled carbon nanotubes grafted with polyhedral oligomeric silsesquioxane and its dispersion in poly(l-lactide) matrix , 2008 .

[22]  Li Niu,et al.  A highly selective chemical gas sensor based on functionalization of multi-walled carbon nanotubes with poly(ethylene glycol) , 2007 .

[23]  J. Mays,et al.  Polymer-grafted multiwalled carbon nanotubes through surface-initiated polymerization. , 2004, Angewandte Chemie.

[24]  Jaehwan Kim,et al.  Piezoelectricity of wet drawn cellulose electro-active paper , 2009 .

[25]  John Aurie Dean,et al.  Lange's Handbook of Chemistry , 1978 .

[26]  Graham Williams,et al.  Trimethylindium transport studies: the effect of different bubbler designs , 2004 .