Multi-fluid reactive modeling of fluidized bed pyrolysis process

Abstract A multiphase reactive model of biomass pyrolysis process has been implemented by integrating the reaction kinetics of the thermo-chemical decomposition of biomass with the hydrodynamics of the fluidized bed. The model was validated with the experimental data of biomass pyrolysis in the presence of a sand bed. The simulation results were examined to analyze the effect of reactor temperature, superficial gas velocity and biomass particle size on the bed hydrodynamics and product yields. It was found that at temperatures higher than 500 °C, there was a significant conversion of primary tar into NCG (non-condensable gases) due to thermal cracking inside the reactor. However, the increase in superficial gas velocity led to higher concentration of tar due to lower residence time for tar cracking reactions. Any increase in biomass particle size reduced the yield of volatile products due to decrease in the rate of heat transfer, which in turn increased the yield of biochar.

[1]  Weihong Yang,et al.  Two-Dimensional Computational Fluid Dynamics Simulation of Biomass Gasification in a Downdraft Fixed-Bed Gasifier with Highly Preheated Air and Steam , 2013 .

[2]  Kai H. Luo,et al.  Modeling the thermochemical degradation of biomass inside a fast pyrolysis fluidized bed reactor , 2012 .

[3]  Sai Gu,et al.  CFD modelling of the fast pyrolysis of biomass in fluidised bed reactors: modelling the impact of biomass shrinkage. , 2009 .

[4]  D. Gidaspow,et al.  Hydrodynamics of circulating fluidized beds: Kinetic theory approach , 1991 .

[5]  H. Baum,et al.  Experimental and theoretical investigation of heat and mass transfer processes during wood pyrolysis , 2010 .

[6]  M. Syamlal,et al.  MFIX documentation theory guide , 1993 .

[7]  F. Berruti,et al.  A KINETIC MODEL FOR THE PRODUCTION OF LIQUIDS FROM THE FLASH PYROLYSIS OF BIOMASS , 1988 .

[8]  F. Behrendt,et al.  Euler–Lagrange/DEM simulation of wood gasification in a bubbling fluidized bed reactor , 2009 .

[9]  Rajamani Krishna,et al.  Comparative analysis of CFD models of dense gas–solid systems , 2001 .

[10]  Colomba Di Blasi,et al.  Analysis of Convection and Secondary Reaction Effects Within Porous Solid Fuels Undergoing Pyrolysis , 1993 .

[11]  Theodore J. Heindel,et al.  A CFD model for biomass fast pyrolysis in fluidized-bed reactors , 2010 .

[12]  Hong‐ming Yan,et al.  CFD Modeling of Biomass Combustion in Palm Oil Waste Boiler , 2004 .

[13]  Xiaoyi He,et al.  Thermodynamic Foundations of Kinetic Theory and Lattice Boltzmann Models for Multiphase Flows , 2002 .

[14]  Mathew J. Hagge,et al.  Modeling the combined impact of moisture and char shrinkage on the pyrolysis of a biomass particle , 2003 .

[15]  G. Jin.  Multiscale Coupling Framework for Modeling of Large-Size Biomass Particle Gasification in Fluidized Beds , 2013 .

[16]  J. Bellan,et al.  Yield Optimization and Scaling of Fluidized Beds for Tar Production from Biomass , 2001 .

[17]  A. Demirbas,et al.  An Overview of Biomass Pyrolysis , 2002 .

[18]  B. B. Krieger,et al.  Modelling and experimental verification of physical and chemical processes during pyrolysis of a large biomass particle , 1985 .

[19]  H. Arastoopour,et al.  Modeling of multitype particle flow using the kinetic theory approach , 2005 .

[20]  D. Jeffrey,et al.  Kinetic theories for granular flow: inelastic particles in Couette flow and slightly inelastic particles in a general flowfield , 1984, Journal of Fluid Mechanics.

[21]  R. Fox,et al.  Experimental validation and CFD modeling study of biomass fast pyrolysis in fluidized-bed reactors , 2012 .

[22]  Hong Yang,et al.  A phenomenological model of the mechanisms of lignocellulosic biomass pyrolysis processes , 2014, Comput. Chem. Eng..

[23]  P. Morf.  Secondary reactions of tar during thermochemical biomass conversion , 2001 .

[24]  D. Gidaspow,et al.  A bubbling fluidization model using kinetic theory of granular flow , 1990 .

[25]  Colomba Di Blasi,et al.  Physico-chemical processes occurring inside a degrading two-dimensional anisotropic porous medium , 1998 .

[26]  Shrikar Chakravarti,et al.  Natural gas enhanced biomass to liquids: Project development and modeling , 2012, Comput. Chem. Eng..

[27]  R. Fox,et al.  Multi-fluid CFD modeling of biomass gasification in polydisperse fluidized-bed gasifiers , 2014 .

[28]  F. Behrendt,et al.  An Eulerian modeling approach of wood gasification in a bubbling fluidized bed reactor using char as bed material , 2010 .

[29]  David F. Fletcher,et al.  Computational fluid dynamics modelling of an entrained flow biomass gasifier , 1998 .

[30]  R. Jackson,et al.  Frictional–collisional constitutive relations for granular materials, with application to plane shearing , 1987, Journal of Fluid Mechanics.

[31]  Mohamed Pourkashanian,et al.  A comprehensive biomass combustion model , 2000 .

[32]  C. Branca,et al.  Kinetics of primary product formation from wood pyrolysis , 2001 .

[33]  Colomba Di Blasi,et al.  Modeling chemical and physical processes of wood and biomass pyrolysis , 2008 .

[34]  D. Gunn.  Transfer of heat or mass to particles in fixed and fluidised beds , 1978 .

[35]  D. Fletcher,et al.  A CFD based combustion model of an entrained flow biomass gasifier , 2000 .