Simulation of matrix converter based DC-DC converter

This paper presents simulation of DC-DC converter with matrix converter as its basic topology. The proposed converter performs the four quadrant chopper operation. This topology can perform many different converter functions. This DC-DC converter can be utilized in speed control of dc motor in electric automobiles and traction where supply is dc voltage. The simulation model was developed in MATLAB/Simulink environment. Pulse width modulation technique is used for output synthesis of the converter. The analysis of converter was done considering resistive and inductive both loads separately.

[1]  S. P. Natarajan,et al.  DUAL CONVERTER CONTROLLED SINGLE PHASE MATRIX CONVERTER FED DC DRIVE , 2012 .

[2]  A. Lindemann,et al.  Bidirectional Switch Commutation for a Matrix Converter Supplying a Series Resonant Load , 2009, IEEE Transactions on Power Electronics.

[3]  U. Ammann,et al.  Predictive Approach to Increase Efficiency and Reduce Switching Losses on Matrix Converters , 2009, IEEE Transactions on Power Electronics.

[4]  Ebrahim Babaei,et al.  A new generalized direct matrix converter , 2001, ISIE 2001. 2001 IEEE International Symposium on Industrial Electronics Proceedings (Cat. No.01TH8570).

[5]  Muhammad H. Rashid,et al.  Power electronics handbook , 2001 .

[6]  Thomas A. Lipo,et al.  New control strategy for matrix converter , 1989, 20th Annual IEEE Power Electronics Specialists Conference.

[7]  A. Zuckerberger,et al.  Single-phase matrix converter , 1997 .

[8]  Jung G. Cho,et al.  Soft-switched matrix converter for high frequency direct AC-to-AC power conversion , 1992 .