PREDICTION OF SURFACE ROUGHNESS IN WIRE ELECTRICAL DISCHARGE MACHINING USING DESIGN OF EXPERIMENTS AND NEURAL NETWORKS

[1]  N. Tosun,et al.  The Effect of Cutting Parameters on Wire Crater Sizes in Wire EDM , 2003 .

[2]  Can Cogun,et al.  The Effect of Cutting Parameters on Workpiece Surface Roughness in Wire EDM , 2003 .

[3]  A Joghataei,et al.  MODELING STRUCTURE-ACTUATOR SYSTEMS BY NEURAL NETWORKS , 2005 .

[4]  E. Rezaei,et al.  ROTOR RESISTANCE IDENTIFICATION USING NEURAL NETWORKS FOR INDUCTION MOTOR DRIVES IN THE CASE OF INSENSITIVITY TO LOAD VARIATIONS , 2006 .

[5]  Can Cogun,et al.  An investigation on wire wear in WEDM , 2003 .

[6]  Yunn-Shiuan Liao,et al.  A study on the machining-parameters optimization of wire electrical discharge machining , 1997 .

[7]  Chih-Chung Chou,et al.  The effect of heterogeneous second phase on the machinability evaluation of spheroidal graphite cast irons in the WEDM process , 2008 .

[8]  Sami Ekici,et al.  An adaptive neuro-fuzzy inference system (ANFIS) model for wire-EDM , 2009, Expert Syst. Appl..

[9]  R. Ramakrishnan,et al.  Modeling and multi-response optimization of Inconel 718 on machining of CNC WEDM process , 2008 .

[10]  Nihat Tosun,et al.  A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi method , 2004 .

[11]  Kamlakar P Rajurkar,et al.  Analysis and optimization of parameter combinations in wire electrical discharge machining , 1991 .

[12]  N. Murugan,et al.  Prediction and optimization of weld bead volume for the submerged arc process - Part 1 , 2000 .

[13]  Bijoy Bhattacharyya,et al.  Modeling and optimization of wire electrical discharge machining of γ-TiAl in trim cutting operation , 2008 .

[14]  Trevor A Spedding,et al.  Parametric optimization and surface characterization of wire electrical discharge machining process , 1997 .

[15]  S. K. Choudhury,et al.  Role of temperature and surface finish in predicting tool wear using neural network and design of experiments , 2003 .

[16]  Y. S. Tarng,et al.  Determination of optimal cutting parameters in wire electrical discharge machining , 1995 .

[17]  Günter Spur,et al.  Anode Erosion in Wire-EDM – A Theoretical Model , 1993 .

[18]  T. C. Lee,et al.  Processing of advanced ceramics using the wire-cut EDM process , 1997 .

[19]  Y. G. Srinivasa,et al.  A back-propagation algorithm applied to tool wear monitoring , 1994 .