Multi-response optimization of diesel engine performance parameters using thumba biodiesel-diesel blends by applying the Taguchi method and grey relational analysis

This paper presents an experimental study that involves an application of the Taguchi method and grey relational analysis to determine the optimum factor level to obtain optimum multiple-performance characteristics of a diesel engine run with different low-percentage thumba biodiesel-diesel blends. Four factors, namely, low-percentage thumba biodiesel-diesel blend, compression ratio, nozzle opening pressure and injection timing were each considered at three levels. An L9 orthogonal array was used to collect data for various engine performance- and emission-related responses under different engine loads. The signal-to-noise (S/N) ratio and grey relational analysis were used for data analysis. The results of the study revealed that the combination of a blend consisting of 30% thumba biodiesel (B30), a compression ratio of 14, a nozzle opening pressure of 250 bar and an injection timing of 20° produces maximum multiple performance of a diesel engine with minimum multiple emissions from the engine.

[1]  Arshad Noor Siddiquee,et al.  Grey relational analysis coupled with principal component analysis for optimisation design of the process parameters in in-feed centreless cylindrical grinding , 2010 .

[2]  N. Kahraman,et al.  Internal combustion engines fueled by natural gas—hydrogen mixtures , 2004 .

[3]  R. Velraj,et al.  Performance and exhaust emission characteristics of a CI engine fueled with Pongamia pinnata methyl ester (PPME) and its blends with diesel , 2008 .

[4]  K. Murugesan,et al.  Performance optimization of Jatropha biodiesel engine model using Taguchi approach , 2009 .

[5]  Avinash Kumar Agarwal,et al.  Biodiesel Development and Characterization for Use as a Fuel in Compression Ignition Engines , 2001 .

[6]  D. Laforgia,et al.  Biodiesel fueled IDI engines: performances, emissions and heat release investigation. , 1995 .

[7]  Sharanappa Godiganur,et al.  6BTA 5.9 G2-1 Cummins engine performance and emission tests using methyl ester mahua (Madhuca indica) oil/diesel blends , 2009 .

[8]  T. R. Bement,et al.  Taguchi techniques for quality engineering , 1995 .

[9]  J. H. Van Gerpen,et al.  The effect of timing and oxidation on emissions from biodiesel-fueled engines. , 2001 .

[10]  M. Babu,et al.  Biodiesel development from high acid value polanga seed oil and performance evaluation in a CI engine , 2007 .

[11]  Haji Hassan Masjuki,et al.  Investigations on Preheated Palm Oil Methyl Esters in the Diesel Engine , 1996 .

[12]  Dooseuk Choi,et al.  Combustion and emission characteristics of BD20 reformed by ultrasonic energy for different injection delay and EGR rate in a diesel engine , 2009 .

[13]  Hifjur Raheman,et al.  Performance of compression ignition engine with mahua (Madhuca indica) biodiesel , 2007 .

[14]  Spencer C. Sorenson,et al.  Combustion of Soybean Oil Methyl Ester in a Direct Injection Diesel Engine , 1993 .

[15]  G. Nagarajan,et al.  Effect of injection pressure on performance, emission and combustion characteristics of high linolenic linseed oil methyl ester in a DI diesel engine , 2009 .

[16]  Hifjur Raheman,et al.  Performance of diesel engine with biodiesel at varying compression ratio and ignition timing , 2008 .

[17]  H. Raheman,et al.  Diesel engine emissions and performance from blends of karanja methyl ester and diesel , 2004 .

[18]  J. Deng,et al.  Introduction to Grey system theory , 1989 .

[19]  Yasuhisa Fujiwara,et al.  Evaluating waste vegetable oils as a diesel fuel , 2000 .

[20]  N. Usta.  An experimental study on performance and exhaust emissions of a diesel engine fuelled with tobacco seed oil methyl ester , 2005 .