A simple characterization methodology for the identification of the visco-elastic behavior of thermoset adhesives during cure

[1]  N. Rudolph,et al.  Moduli development of epoxy adhesives during cure , 2019, Polymer Testing.

[2]  M. Lévesque,et al.  Viscoelastic behavior of an epoxy resin during cure below the glass transition temperature: Characterization and modeling , 2018, Journal of Composite Materials.

[3]  N. Boyard,et al.  Bulk modulus evolution of thermoset resins during crosslinking: Is a direct and accurate measurement possible? , 2017 .

[4]  S. Berger,et al.  Evaluation of the flexural resistance and stress contraction of a silorane-based composite submitted to different protocols of polymerization , 2014, Applied Adhesion Science.

[5]  N. Noda,et al.  Strength analysis of adhesive joints of riser pipes in deep sea environment loadings , 2013, Applied Adhesion Science.

[6]  J. Reis,et al.  Thermal behavior of DGEBA (Diglycidyl Ether of Bisphenol A) adhesives and its influence on the strength of joints , 2013, Applied Adhesion Science.

[7]  S. Horn,et al.  Influence of partial cross‐linking degree on basic physical properties of RTM6 epoxy resin , 2013 .

[8]  Robert D. Adams,et al.  Development of a dilatometer and measurement of the shrinkage behaviour of adhesives during cure , 2013 .

[9]  Yasir Nawab,et al.  Chemical shrinkage characterization techniques for thermoset resins and associated composites , 2013, Journal of Materials Science.

[10]  N. Boyard,et al.  Characterization of the cure shrinkage, reaction kinetics, bulk modulus and thermal conductivity of thermoset resin from a single experiment , 2013, Journal of Materials Science.

[11]  P. Gromala,et al.  Characterization of adhesives and interface strength for automotive applications , 2012, 2012 13th International Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microelectronics and Microsystems.

[12]  Huei-Huang Lee,et al.  Modeling of Viscoelastic Behavior of an Epoxy Molding Compound During and After Curing , 2011, IEEE Transactions on Components, Packaging and Manufacturing Technology.

[13]  François Trochu,et al.  Numerical analysis of cure temperature and internal stresses in thin and thick RTM parts , 2005 .

[14]  S. Palmer,et al.  The Development of Shear and Compression Elastic Moduli in Curing Epoxy Adhesives Measured Using Non‐Contact Ultrasonic Transducers , 2003 .

[15]  Patrick T. Mather,et al.  Viscoelastic Properties of an Epoxy Resin during Cure , 2001 .

[16]  M. S. Kiasat,et al.  Determination of visco-elastic properties during the curing process of underfill materials , 2000, 2000 Proceedings. 50th Electronic Components and Technology Conference (Cat. No.00CH37070).

[17]  John A. Nairn,et al.  Energy release rate analysis for adhesive and laminate double cantilever beam specimens emphasizing the effect of residual stresses , 2000 .

[18]  Robert S. Chambers,et al.  Verification of the capability for quantitative stress prediction during epoxy cure , 1997 .

[19]  R. Farris,et al.  Evolution of residual stresses in three-dimensionally constrained epoxy resins , 1990 .

[20]  Jean-Louis Chaboche,et al.  Mechanics of Solid Materials , 1990 .

[21]  A. M. Lindrose.  Ultrasonic wave and moduli changes in a curing epoxy resin , 1978 .

[22]  K. Jansen,et al.  Characterization and modeling the thermo-mechanical cure-dependent properties of epoxy molding compound , 2012 .

[23]  M. Presser,et al.  Experimental investigation of the influence of residual stress due to curing shrinkage on the interphase formation in adhesively bonded joints , 2011 .

[24]  D. Dillard.  Advances in structural adhesive bonding , 2010 .

[25]  Paul Steinmann,et al.  A small-strain model to simulate the curing of thermosets , 2009 .

[26]  M. Aarnts,et al.  Modeling of viscoelastic behavior of dental chemically activated resin composites during curing. , 2001, Journal of biomedical materials research.

[27]  A. Johnston,et al.  An integrated model of the development of process-induced deformation in autoclave processing of composite structures , 1997 .