Further Studies of Psychophysically Determined Maximum Acceptable Weights and Forces

The effects of lifting boxes without handles, pulling long distances, carrying different size boxes, combining three handling tasks, and lifting with extended horizontal reach were studied using a psychophysical methodology. Six male industrial workers performed 42 variations of lifting, lowering, pushing, pulling, and carrying tasks. Lifting boxes without handles produced consistent decreases (median, 16%) in maximum acceptable weights when compared with lifting boxes with handles. Lifting with extended horizontal reach (approximately 48 cm) produced consistent decreases (median, 48%) in maximum acceptable weights when compared with lifting close to the body (approximately 17 cm). No significant heart rate or oxygen consumption differences occurred in either of these variables. No significant differences in maximum acceptable weight of carry were observed among box sizes; however, the maximum acceptable force of pulling was lower for longer (15.2 m) pulling tasks. The maximum acceptable weight for combination tasks was similar to that of the limiting component.

[1]  M M Ayoub,et al.  Psychophysical modelling for combined manual materials-handling activities. , 1986, Ergonomics.

[2]  Claire C. Gordon,et al.  2012 Anthropometric Survey of U.S. Army Personnel: Methods and Summary Statistics , 2014 .

[3]  Stover H. Snook,et al.  The Ergonomics Society The Society's Lecture 1978. THE DESIGN OF MANUAL HANDLING TASKS , 1978 .

[4]  Stover H. Snook,et al.  The Effects of Size, Distance, Height and Frequency on Manual Handling Performance , 1978 .

[5]  S. Snook,et al.  Maximum weights and work loads acceptable to female workers. , 1974, Occupational health nursing.

[6]  S H Snook,et al.  A Study of Size, Distance, Height, and Frequency Effects on Manual Handling Tasks , 1983, Human factors.

[7]  Kodak Ergonomic Design for People at Work , 1989 .

[8]  Colin G. Drury,et al.  A Survey of Industrial Box Handling , 1982 .

[9]  S. Snook The design of manual handling tasks. , 1978, Ergonomics.

[10]  S H Snook,et al.  The effects of task duration on psychophysically-determined maximum acceptable weights and forces. , 1990, Ergonomics.

[11]  D B Chaffin,et al.  Ergonomics guide for the assessment of human static strength. , 1975, American Industrial Hygiene Association journal.

[12]  S. Snook,et al.  A study of three preventive approaches to low back injury. , 1978, Journal of occupational medicine. : official publication of the Industrial Medical Association.

[13]  S H Snook Approaches to the control of back pain in industry: job design, job placement and education/training. , 1988, Occupational medicine.

[14]  P. Åstrand,et al.  Textbook of Work Physiology , 1970 .

[15]  M. Key National Institute for Occupational Safety and Health; occupational exposure to inorganic lead: request for comments and information; republication--NIOSH. Request for comments and information relevant to occupational exposure to inorganic lead. , 1997, Federal register.

[16]  C G Drury,et al.  Symmetric and asymmetric manual materials handling, Part 2: Biomechanics. , 1989, Ergonomics.

[17]  D. Anton Occupational biomechanics , 1986 .

[18]  D. Butler,et al.  Wayfinding by Newcomers in a Complex Building , 1993 .

[19]  S J Morrissey,et al.  Maximum acceptable weights in load carriage. , 1988, Ergonomics.

[20]  S H Snook,et al.  The cost of compensable low back pain. , 1990, Journal of occupational medicine. : official publication of the Industrial Medical Association.

[21]  S H Snook,et al.  The effects of heat stress on manual handling tasks. , 1974, American Industrial Hygiene Association journal.

[22]  S H Snook,et al.  The Effects of Age and Physique on Continuous-Work Capacity , 1971, Human factors.

[23]  Quinn McNemar,et al.  Statistical Analysis in Psychology and Education. , 1967 .

[24]  C G Drury,et al.  Symmetric and asymmetric manual materials handling. Part 1: Physiology and psychophysics. , 1989, Ergonomics.

[25]  Ciriello Vm,et al.  The effects of task duration on psychophysically-determined maximum acceptable weights and forces , 1990 .

[26]  D. Spengler,et al.  Back Injuries in Industry: A Retrospective Study: II. Injury Factors , 1986, Spine.