Accurate Spectral Testing With Arbitrary Noncoherency in Sampling and Simultaneous Drifts in Amplitude and Frequency

Accurate spectral testing plays a crucial role in modern high-precision analog-to-digital converters’ (ADCs’) evaluation process. One of the challenges is to be able to cost-effectively test the continually higher resolution ADCs accurately. Due to its stringent test requirement, the standard test method for ADCs can be difficult to implement with low cost. This paper proposes an algorithm that relaxes the requirements of precise control over source amplitude and frequency, and of the need to achieve coherent sampling. The algorithm divides the output data into segments, and estimates drift fundamental via Newton iteration. By removing the estimated drift fundamental and replacing with a coherent, nondrift fundamental in time domain, accurate spectral results can be achieved. Various simulation results have validated the accuracy of the proposed algorithm. The proposed algorithm is capable of tolerating various test condition variations such as any-level of noncoherency, various input frequency range and different numbers of segmentations. In addition, several measurement results from different ADCs have verified the accuracy of the proposed algorithm, which is able to accurately obtain spectral performance of an 18 b high-resolution ADC. Such algorithm relaxes the standard test requirement such as precise control over source frequency and amplitude, which dramatically reduces the test setup complexity and cost.

[1]  Kui Fu Chen.  Estimating Parameters of a Sine Wave by Separable Nonlinear Least Squares Fitting , 2010, IEEE Transactions on Instrumentation and Measurement.

[2]  Daniel Belega,et al.  Choice of the cosine-class windows for ADC dynamic testing by spectral analysis , 2007 .

[3]  Degang Chen,et al.  A novel robust and accurate spectral testing method for non-coherent sampling , 2011, 2011 IEEE International Test Conference.

[4]  P. Carbone,et al.  Windows for ADC dynamic testing via frequency-domain analysis , 2000, Proceedings of the 17th IEEE Instrumentation and Measurement Technology Conference [Cat. No. 00CH37066].

[5]  Error analysis of the parameters of a least-squares determined curve when both variables have uncertainties , 1991 .

[6]  Degang Chen,et al.  Accurate spectral testing with non-coherent sampling for large distortion to noise ratios , 2016, 2016 IEEE 34th VLSI Test Symposium (VTS).

[7]  Li Xu,et al.  Accurate spectral testing of analog-to-digital converters with frequency drift using phase correction and averaging , 2015, 2015 IEEE International Symposium on Circuits and Systems (ISCAS).

[8]  D. Dallet,et al.  Non Coherent Spectral Analysis of ADC using FFT Windows: an Alternative Approach , 2005, 2005 IEEE Intelligent Data Acquisition and Advanced Computing Systems: Technology and Applications.

[9]  Degang Chen,et al.  New Strategies in Removing Noncoherency From Signals With Large Distortion-to-Noise Ratios , 2016, IEEE Transactions on Circuits and Systems II: Express Briefs.

[10]  Gordon W. Roberts,et al.  An Introduction to Mixed-Signal IC Test and Measurement , 2000 .

[11]  L. Griffiths.  Rapid measurement of digital instantaneous frequency , 1975 .

[12]  Rik Pintelon,et al.  An efficient nonlinear least square multisine fitting algorithm , 2002, IEEE Trans. Instrum. Meas..

[13]  Degang Chen,et al.  FIRE: A Fundamental Identification and Replacement Method for Accurate Spectral Test Without Requiring Coherency , 2013, IEEE Transactions on Instrumentation and Measurement.

[14]  Yasuo Sato,et al.  Recent Improvements in the Analysis of Surface Wave Observations , 1969 .

[15]  M. Ackroyd.  Short‐Time Spectra and Time‐Frequency Energy Distributions , 1971 .

[16]  Daniel Belega,et al.  Estimation of the Effective Number of Bits of ADCs using the Interpolated DFT method , 2010, 2010 IEEE Instrumentation & Measurement Technology Conference Proceedings.

[17]  Tamás Dabóczi,et al.  ADC Testing Using a Resonator-Based Observer: Processing Very Long Time Records and/or Testing Systems With Limited Stability , 2013, IEEE Transactions on Instrumentation and Measurement.

[18]  Paul R. White,et al.  THE ANALYSIS OF NON-STATIONARY SIGNALS USING TIME-FREQUENCY METHODS , 1996 .

[19]  F. Harris.  On the use of windows for harmonic analysis with the discrete Fourier transform , 1978, Proceedings of the IEEE.

[20]  Rik Pintelon,et al.  An improved sine-wave fitting procedure for characterizing data acquisition channels , 1995 .

[21]  István Kollár,et al.  Four-parameter fitting of sine wave testing result: iteration and convergence , 2004, Comput. Stand. Interfaces.

[22]  Tamas Daboczi.  Increasing the robustness of the resonator based ADC testing , 2013, 2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC).

[23]  Alan V. Oppenheim,et al.  Discrete-time Signal Processing. Vol.2 , 2001 .

[24]  O. Solomon.  The use of DFT windows in signal-to-noise ratio and harmonic distortion computations , 1993, 1993 IEEE Instrumentation and Measurement Technology Conference.

[25]  L. Cohen,et al.  Time-frequency distributions-a review , 1989, Proc. IEEE.