Size-dependent plasticity in an Nb25Mo25Ta25W25 refractory high-entropy alloy

Abstract High-entropy alloys (HEAs) are evolving multi-component intermetallic systems, wherein multiple principal elements tend to form single solid-solution-like phases with a strong tendency to solid solution strengthening. In this study, an Nb25Mo25Ta25W25 refractory HEA was synthesized by arc melting and well homogenized at 1800 °C. Single-crystalline HEA pillars in two orientations ([0 0 1] and [3 1 6]) and with diameters ranging from 2 μm to 200 nm were produced by focused ion beam milling and compressed using a flat-punch tip in a nanoindenter. The HEA pillar samples can reach extraordinarily high strength levels of ∼4–4.5 GPa, which is ∼3–3.5 times higher than that of the bulk HEA; meanwhile the ductility is significantly improved. Compared to pure Nb, Mo, Ta and W pillars, the HEA pillars exhibit higher strengths than any of them in both absolute and normalized values, and the HEA pillars also show relatively low compressive size effects, as evaluated by the log–log slope of strength vs. pillar diameter. The higher strength levels and lower size dependence for the HEA could be attributed to the increased lattice resistance caused by localized distortion at atomic length scales. The correlation between normalized strengths, length scales and temperatures for body-centered cubic structured pillars is illustrated, and the relevance of a size-effect slope as well as the additivity of strengthening mechanisms is critically discussed.

[1]  V. Vítek.  Structure of dislocation cores in metallic materials and its impact on their plastic behaviour , 1992 .

[2]  Julia R. Greer,et al.  Tensile and compressive behavior of tungsten, molybdenum, tantalum and niobium at the nanoscale , 2010 .

[3]  Michael D. Uchic,et al.  Contribution to size effect of yield strength from the stochastics of dislocation source lengths in finite samples , 2007 .

[4]  S. Lee,et al.  Size dependence of the yield strength of fcc and bcc metallic micropillars with diameters of a few micrometers , 2012 .

[5]  D. Dimiduk,et al.  Scale-Free Intermittent Flow in Crystal Plasticity , 2006, Science.

[6]  N. Ashcroft,et al.  Vegard's law. , 1991, Physical review. A, Atomic, molecular, and optical physics.

[7]  P. Liaw,et al.  Refractory high-entropy alloys , 2010 .

[8]  Christopher R. Weinberger,et al.  Surface-controlled dislocation multiplication in metal micropillars , 2008, Proceedings of the National Academy of Sciences.

[9]  Julia R. Greer,et al.  Comparing the strength of f.c.c. and b.c.c. sub-micrometer pillars: Compression experiments and dislocation dynamics simulations , 2008 .

[10]  Jien-Wei Yeh,et al.  High-Entropy Alloys – A New Era of Exploitation , 2007 .

[11]  Oleg N. Senkov,et al.  Low-Density, Refractory Multi-Principal Element Alloys of the Cr-Nb-Ti-V-Zr System: Microstructure and Phase Analysis (Postprint) , 2013 .

[12]  Blythe G. Clark,et al.  Influence of orientation on the size effect in bcc pillars with different critical temperatures , 2011 .

[13]  G. Dehm.  Miniaturized single-crystalline fcc metals deformed in tension: New insights in size-dependent plasticity , 2009 .

[14]  Takeshi Egami,et al.  Local Atomic Structure of a High-Entropy Alloy: An X-Ray and Neutron Scattering Study , 2013, Metallurgical and Materials Transactions A.

[15]  Julia R. Greer,et al.  Size dependence of mechanical properties of gold at the micron scale in the absence of strain gradients , 2005 .

[16]  O. Kraft,et al.  Size dependent mechanical behaviour of tantalum , 2011 .

[17]  T. Shun,et al.  Nanostructured High‐Entropy Alloys with Multiple Principal Elements: Novel Alloy Design Concepts and Outcomes , 2004 .

[18]  D. Dimiduk,et al.  Sample Dimensions Influence Strength and Crystal Plasticity , 2004, Science.

[19]  D. Miracle,et al.  Mechanical properties of Nb25Mo25Ta25W25 and V20Nb20Mo20Ta20W20 refractory high entropy alloys , 2011 .

[20]  C. Woodward,et al.  An experimental investigation of intermittent flow and strain burst scaling behavior in LiF crystals during microcompression testing , 2010 .

[21]  T. Nieh,et al.  Incipient plasticity and dislocation nucleation of FeCoCrNiMn high-entropy alloy , 2013 .

[22]  R. Spolenak,et al.  Deformation behavior of silver submicrometer-pillars prepared by nanoimprinting , 2009 .

[23]  F. Nabarro,et al.  Dislocations in solids , 1979 .

[24]  W. Clegg,et al.  Discussion of the dependence of the effect of size on the yield stress in hard materials studied by microcompression of MgO , 2011 .

[25]  Amin H. Almasri,et al.  Experimental nanoindentation of BCC metals , 2010 .

[26]  Shou-Yi Chang,et al.  Anomalous decrease in X-ray diffraction intensities of Cu–Ni–Al–Co–Cr–Fe–Si alloy systems with multi-principal elements , 2007 .

[27]  Toshio Suzuki,et al.  Plastic homology of bcc metals , 1999 .

[28]  D. Dimiduk,et al.  Plasticity of Micrometer-Scale Single-Crystals in Compression: A Critical Review (PREPRINT) , 2008 .

[29]  G. Sheldrick.  A short history of SHELX. , 2008, Acta crystallographica. Section A, Foundations of crystallography.

[30]  D. Hull,et al.  Introduction to Dislocations , 1968 .

[31]  D. Dimiduk,et al.  Estimating the strength of single-ended dislocation sources in micron-sized single crystals , 2007 .

[32]  Yi Cui,et al.  Critical-temperature/Peierls-stress dependent size effects in body centered cubic nanopillars , 2013 .

[33]  Jien-Wei Yeh,et al.  Diffusion barrier properties of AlMoNbSiTaTiVZr high-entropy alloy layer between copper and silicon , 2008 .

[34]  Lianmao Peng,et al.  Debye–Waller Factors and Absorptive Scattering Factors of Elemental Crystals , 1996 .

[35]  G. A. Malygin.  Influence of the Peierls relief on size effects in plastic deformation of micro- and nanocrystals of body-centered cubic metals , 2012 .

[36]  J. Yeh,et al.  Effect of temperature on mechanical properties of Al0.5CoCrCuFeNi wrought alloy , 2010 .

[37]  E. Ma,et al.  A new regime for mechanical annealing and strong sample-size strengthening in body centred cubic molybdenum. , 2011, Nature communications.

[38]  Julia R. Greer,et al.  Plasticity in small-sized metallic systems: Intrinsic versus extrinsic size effect , 2011 .

[39]  S. Han,et al.  Size effects on strength and plasticity of vanadium nanopillars , 2010 .

[40]  B. Derby,et al.  A universal scaling law for the strength of metal micropillars and nanowires , 2009 .

[41]  J. Wang.  Prediction of Peierls stresses for different crystals , 1996 .

[42]  A. Ngan,et al.  Stochastic nature of plasticity of aluminum micro-pillars , 2008 .

[43]  T. Shun,et al.  Multi‐Principal‐Element Alloys with Improved Oxidation and Wear Resistance for Thermal Spray Coating , 2004 .

[44]  R. Spolenak,et al.  Deformation behavior of gold nano-pillars prepared by nanoimprinting and focused ion-beam milling , 2011 .

[45]  J. Yeh,et al.  Mechanical performance of the AlxCoCrCuFeNi high-entropy alloy system with multiprincipal elements , 2005 .

[46]  Michael D. Uchic,et al.  Size-affected single-slip behavior of pure nickel microcrystals , 2005 .

[47]  V. Vítek,et al.  Plastic anisotropy in b.c.c. transition metals , 1998 .

[48]  Julia R. Greer,et al.  Tensile and compressive behavior of gold and molybdenum single crystals at the nano-scale , 2009 .

[49]  O. Kraft,et al.  Plasticity in Confined Dimensions , 2010 .

[50]  G. Dehm,et al.  In situ observation of dislocation nucleation and escape in a submicrometre aluminium single crystal. , 2009, Nature materials.

[51]  E. Arzt.  Size effects in materials due to microstructural and dimensional constraints: a comparative review , 1998 .