Evaluating and overcoming the impact of second echo in Brillouin echoes distributed sensing.

The detrimental impact of the second echo phenomenon that commonly exists in Brillouin echoes distributed sensing (BEDS) methods is thoroughly investigated by further developing the analytical model of the Brillouin gain on the probe wave. The presented analysis not only points out that the most severe impact imposed by the second echo occurs when the length of the heated/stressed fiber section is exactly equal to the spatial resolution, but also quantifies the systematic error on the estimated Brillouin frequency shift, the maximum of which could reach up to 8.5 MHz. A novel parabolic-amplitude four-section pulse is proposed, which can compensate the impact of the second echo optically, without using extra measurement time and post-processing. The key parameters of the proposed pulse are optimized by combining an upgraded mathematical model and the iterative algorithm. The experimental results show a good agreement with the analysis about the behavior of the second echo, and demonstrate that the proposed technique is capable of providing sub-meter spatial resolution and the natural linewidth of Brillouin gain spectrum simultaneously, while completely eliminating the impact of the second echo.

[1]  K. Shimizu,et al.  Development of a distributed sensing technique using Brillouin scattering , 1995 .

[2]  Anthony W. Brown,et al.  Characterization of the Brillouin-loss spectrum of single-mode fibers by use of very short (<10-ns) pulses. , 1999, Optics letters.

[3]  David J. Webb,et al.  Transient response in high-resolution Brillouin-based distributed sensing using probe pulses shorter than the acoustic relaxation time. , 2000, Optics letters.

[4]  X. Bao,et al.  Coherent probe-pump-based Brillouin sensor for centimeter-crack detection. , 2005, Optics letters.

[5]  Zuyuan He,et al.  Distributed strain measurement with millimeter-order spatial resolution based on Brillouin optical correlation domain analysis. , 2006, Optics letters.

[6]  Yahei Koyamada.  Proposal and Simulation of Double-Pulse Brillouin Optical Time-Domain Analysis for Measuring Distributed Strain and Temperature with cm Spatial Resolution in km-Long Fiber , 2007, IEICE Trans. Commun..

[7]  Anthony W. Brown,et al.  Dark-Pulse Brillouin Optical Time-Domain Sensor With 20-mm Spatial Resolution , 2007, Journal of Lightwave Technology.

[8]  X. Bao,et al.  Differential pulse-width pair BOTDA for high spatial resolution sensing. , 2008, Optics express.

[9]  M. Tur,et al.  High spatial resolution distributed sensing in optical fibers by Brillouin gain-profile tracing. , 2010, Optics express.

[10]  Moshe Tur,et al.  High Spatial and Spectral Resolution Long-Range Sensing Using Brillouin Echoes , 2010, Journal of Lightwave Technology.

[11]  Moshe Tur,et al.  Distributed Brillouin sensing with sub-meter spatial resolution: modeling and processing. , 2011, Optics express.

[12]  Marcelo A. Soto,et al.  Double-pulse Brillouin distributed optical fiber sensors: analytical model and experimental validation , 2012, Other Conferences.

[13]  A. Zadok,et al.  Random‐access distributed fiber sensing , 2012 .

[14]  Marcelo A. Soto,et al.  Time gated phase-correlation distributed Brillouin fibre sensor , 2013, Other Conferences.

[15]  Luc Thévenaz,et al.  Modeling and evaluating the performance of Brillouin distributed optical fiber sensors. , 2013, Optics express.

[16]  Yosef London,et al.  High-resolution long-range distributed Brillouin analysis using dual-layer phase and amplitude coding. , 2014, Optics express.

[17]  Yair Antman,et al.  High-resolution long-reach distributed Brillouin sensing based on combined time-domain and correlation-domain analysis. , 2014, Optics express.

[18]  Yosef London,et al.  Brillouin analysis with 8.8 km range and 2 cm resolution , 2015, International Conference on Optical Fibre Sensors.