Corrosion products and corrosion-induced cracks of low-alloy steel and low-carbon steel in concrete

[1]  M. Liu,et al.  Corrosion resistances of passive films on low‐Cr steel and carbon steel in simulated concrete pore solution , 2016 .

[2]  W. Jin,et al.  Corrosion-induced concrete cracking model considering corrosion product-filled paste at the concrete/steel interface , 2016 .

[3]  Wei Sun,et al.  Influence of chloride concentration and pre-passivation on the pitting corrosion resistance of low-alloy reinforcing steel in simulated concrete pore solution , 2016 .

[4]  R. François,et al.  Influence of steel–concrete interface defects induced by top-casting on development of chloride-induced corrosion in RC beams under sustained loading , 2016 .

[5]  M. Liu,et al.  Corrosion behavior of Cr modified HRB400 steel rebar in simulated concrete pore solution , 2015 .

[6]  T. Nishimura.  Nano Structure of the Rust Formed on Chromium Bearing Steel in Concrete after Wet and Dry Corrosion Test , 2015 .

[7]  Gustavo Duffo,et al.  Application of gamma-ray radiography and gravimetric measurements after accelerated corrosion tests of steel embedded in mortar , 2015 .

[8]  Erik Schlangen,et al.  Corrosion induced cover cracking studied by X-ray computed tomography, nanoindentation, and energy dispersive X-ray spectrometry (EDS) , 2015 .

[9]  M. Kunz,et al.  Spatial distribution of crystalline corrosion products formed during corrosion of stainless steel in concrete , 2015 .

[10]  C. Gervais,et al.  Degradation mechanisms of reinforcing iron rebars in monuments: the role of multiscale porosity in the formation of corrosion products investigated by X-ray tomography , 2015 .

[11]  A. Alhozaimy,et al.  Time-dependent variation of the electrochemical impedance for thermo-mechanically treated versus plain low alloy steel rebars in contact with simulated concrete pore solution , 2014 .

[12]  Dubravka Bjegović,et al.  In situ 3D monitoring of corrosion on carbon steel and ferritic stainless steel embedded in cement paste , 2014 .

[13]  Zhang Jianchu.  Microstructure and Properties of 20MnSiCrV Corrosion Resistant Rebar in Continuous Cooling Transformation , 2014 .

[14]  Y. Qian,et al.  The influence of chromium content on the electrochemical behavior of weathering steels , 2013 .

[15]  A. Scott,et al.  Chloride Resistance of 9% Cr Steel in a Simulated Pore Solution , 2013 .

[16]  V. L'Hostis,et al.  Characterisation of the steel concrete interface submitted to chloride‐induced‐corrosion , 2013 .

[17]  Zhen-Yu Liu,et al.  Effects of Cr, Ni and Cu on the Corrosion Behavior of Low Carbon Microalloying Steel in a Cl- Containing Environment , 2013 .

[18]  W. Jin,et al.  Critical thickness of rust layer at inner and out surface cracking of concrete cover in reinforced concrete structures , 2012 .

[19]  A. Mukherjee,et al.  Corrosion Prevention of Reinforced Concrete with Microbial Calcite Precipitation , 2012 .

[20]  J. Singh,et al.  The nature of rusts and corrosion characteristics of low alloy and plain carbon steels in three kinds of concrete pore solution with salinity and different pH , 2012 .

[21]  John Forbes Olesen,et al.  Monitoring reinforcement corrosion and corrosion-induced cracking using non-destructive x-ray attenuation measurements , 2011 .

[22]  Philippe Dillmann,et al.  The evolution of the corrosion of iron in hydraulic binders analysed from 46- and 260-year-old buildings , 2010 .

[23]  J. Scully,et al.  Literature Review of Commercially Available Alloys That Have Potential as Low-Cost, Corrosion-Resistant Concrete Reinforcement , 2010 .

[24]  W. Jin,et al.  On the penetration of corrosion products from reinforcing steel into concrete due to chloride-induced corrosion , 2010 .

[25]  Hans Beushausen,et al.  Corrosion in cracked and uncracked concrete – influence of crack width, concrete quality and crack reopening , 2010 .

[26]  P. Novák,et al.  Threshold chloride concentration for stainless steels activation in concrete pore solutions , 2010 .

[27]  S. Caré,et al.  Times to cracking in reinforced mortar beams subjected to accelerated corrosion tests , 2010 .

[28]  Y. Li,et al.  Weatherability of 09CuPCrNi steel in a tropical marine environment , 2009 .

[29]  P. Monteiro,et al.  Electrochemical and in-situ SERS Study of Passive Film Characteristics and Corrosion Performance of 9%Cr Microcomposite Steel in Highly Alkaline Environments , 2009 .

[30]  Carolyn M. Hansson,et al.  Potential pitfalls in assessing chloride-induced corrosion of steel in concrete , 2009 .

[31]  Philippe Dillmann,et al.  Characterization of long‐term corrosion of rebars embedded in concretes sampled on French historical buildings aged from 50 to 80 years , 2009 .

[32]  Quang Thanh Nguyen,et al.  Mechanical Properties of the Rust Layer Induced by Impressed Current Method in Reinforced Mortar , 2008 .

[33]  Carolyn M. Hansson,et al.  The influence of longitudinal cracks on the corrosion protection afforded reinforcing steel in high performance concrete , 2008 .

[34]  Surendra P. Shah,et al.  Comparison of Two Accelerated Corrosion Techniques for Concrete Structures , 2007 .

[35]  J. Wit,et al.  Investigation of Corrosion and Cathodic Protection in Reinforced Concrete II. Properties of Steel Surface Layers , 2007 .

[36]  T. Noguchi,et al.  Corrosion Resistance of Cr-bearing Rebar in Concrete with Chloride Ion Content , 2006 .

[37]  G. Duffó,et al.  A study of steel rebars embedded in concrete during 65 years , 2004 .

[38]  B. G. Callaghan,et al.  The performance of a 12% chromium steel in concrete in severe marine environments , 1993 .