All-polymer photovoltaic devices of poly(3-(4-n-octyl)-phenylthiophene) from Grignard Metathesis (GRIM) polymerization.

The synthesis of poly[3-(4-n-octyl)-phenylthiophene] (POPT) from Grignard Metathesis (GRIM) is reported. GRIM POPT is found to have favorable electronic, optical, and processing properties for organic photovoltaics (OPVs). Space-charge limited current and field effect transistor measurements for POPT yielded hole mobilities of 1 x 10(-4) cm(2)/(V s) and 0.05 cm(2)/(V s), respectively. Spincasting GRIM POPT from chlorobenzene yields a thin film with a 1.8 eV band gap, and PC(61)BM:POPT bulk heterojection devices provide a peak performance of 3.1%. Additionally, an efficiency of 2.0% is achieved in an all-polymer, bilayer OPV using poly[2-methoxy-5-(2'-ethylhexyloxy)-1,4-(1-cyanovinylene)phenylene] (CNPPV) as an acceptor. This state-of-the-art all-polymer device is analyzed in comparison to the analogous poly(3-hexylthiophene) (P3HT)/CNPPV device. Counter to expectations based on more favorable energy level alignment, greater active layer light absorption, and similar hole mobility, P3HT/CNPPV devices perform less well than POPT/CNPPV devices with a peak efficiency of 0.93%.

[1]  Göran Gustafsson,et al.  Electroluminescence from Substituted Poly(thiophenes) : From Blue to Near-Infrared , 1995 .

[2]  O. Inganäs,et al.  PHOTOPHYSICS OF SUBSTITUTED POLYTHIOPHENES , 1999 .

[3]  Bumjoon J. Kim,et al.  The influence of poly(3-hexylthiophene) regioregularity on fullerene-composite solar cell performance. , 2008, Journal of the American Chemical Society.

[4]  Mats Andersson,et al.  University of Groningen Polymer photovoltaic devices from stratified multilayers of donor-acceptor blends , 2022 .

[5]  Stefan C J Meskers,et al.  Compositional and electric field dependence of the dissociation of charge transfer excitons in alternating polyfluorene copolymer/fullerene blends. , 2008, Journal of the American Chemical Society.

[6]  Richard D. McCullough,et al.  Enhanced electrical conductivity in regioselectively synthesized poly(3-alkylthiophenes) , 1992 .

[7]  Benjamin C. Duck,et al.  Poly(2,3-dihexylthieno[3,4-b]pyrazine) via GRIM Polymerization: Simple Preparation of a Solution Processable, Low-Band-Gap Conjugated Polymer , 2008 .

[8]  J. Fréchet,et al.  Polymer-fullerene composite solar cells. , 2008, Angewandte Chemie.

[9]  Weimin Zhang,et al.  Charge carrier formation in polythiophene/fullerene blend films studied by transient absorption spectroscopy. , 2008, Journal of the American Chemical Society.

[10]  O. Inganäs,et al.  Correlation between oxidation potential and open-circuit voltage of composite solar cells based on blends of polythiophenes/ fullerene derivative , 2004 .

[11]  Yang Yang,et al.  High-efficiency solution processable polymer photovoltaic cells by self-organization of polymer blends , 2005 .

[12]  Manikandan Jayaraman,et al.  Self-orienting head-to-tail poly(3-alkylthiophenes): new insights on structure-property relationships in conducting polymers , 1993 .

[13]  M. Berggren,et al.  Regioselective polymerization of 3-(4-octylphenyl)thiophene with FeCl3 , 1994 .

[14]  T. Yokozawa,et al.  Catalyst-transfer polycondensation. mechanism of Ni-catalyzed chain-growth polymerization leading to well-defined poly(3-hexylthiophene). , 2005, Journal of the American Chemical Society.

[15]  C. Brabec,et al.  Influence of disorder on the photoinduced excitations in phenyl substituted polythiophenes , 2001 .

[16]  Photovoltaic Devices Based on Photo Induced Charge Transfer in Polythiophene:CN-PPV Blends , 2003 .

[17]  S. Jenekhe,et al.  Efficient Solar Cells from Layered Nanostructures of Donor and Acceptor Conjugated Polymers , 2004 .

[18]  Q. Pei,et al.  Poly[3-(4-octylphenyl)thiophene], a new processible conducting polymer , 1992 .

[19]  O. Inganäs,et al.  Structural ordering in phenyl-substituted polythiophenes , 2000 .

[20]  Mats Andersson,et al.  Laminated fabrication of polymeric photovoltaic diodes , 1998, Nature.

[21]  W. Mammo,et al.  Electrochemical bandgaps of substituted polythiophenesElectronic supplementary information (ESI) available: cyclic voltammograms not given within the article. See http://www.rsc.org/suppdata/jm/b3/b301403g/ , 2003 .

[22]  S. Jenekhe,et al.  Efficient photovoltaic cells from semiconducting polymer heterojunctions , 2000 .

[23]  D. M. Leeuw,et al.  Stability of n-type doped conducting polymers and consequences for polymeric microelectronic devices , 1997 .

[24]  D. Neher,et al.  Efficient Polymer Solar Cells Based on M3EH−PPV , 2005 .

[25]  V. Mihailetchi,et al.  Photocurrent generation in polymer-fullerene bulk heterojunctions. , 2004, Physical review letters.

[26]  R. Friend,et al.  Electronic structures of interfacial states formed at polymeric semiconductor heterojunctions. , 2008, Nature materials.