Fabrication of three-dimensional helical microchannels with arbitrary length and uniform diameter inside fused silica.

We demonstrate an improved femtosecond laser irradiation followed by chemical etching process to create complex three-dimensional (3D) microchannels with arbitrary length and uniform diameter inside fused silica. A segmented chemical etching method of introducing extra access ports and a secondary power compensation is presented, which enables the fabrication of uniform 3D helical microchannels with length of 1.140 cm and aspect-ratio of 522. Based on this method, a micromixer which consists of a long helical microchannel and a y-tape microchannel was created inside the fused silica. We measured the mixing properties of the micromixer by injecting the phenolphthalein and NaOH solution through the two inlets of the y-tape microchannel. A rapid and efficient mixing was achieved in the 3D micromixer at a low Reynolds number.

[1]  P. Laporta,et al.  Fabrication of long microchannels with circular cross section using astigmatically shaped femtosecond laser pulses and chemical etching , 2006 .

[2]  A. deMello.  Control and detection of chemical reactions in microfluidic systems , 2006, Nature.

[3]  J. Si,et al.  Fabrication of three-dimensional microchannels inside silicon using a femtosecond laser , 2009 .

[4]  J. Nishii,et al.  Femtosecond laser-assisted three-dimensional microfabrication in silica. , 2001, Optics letters.

[5]  Yan Li,et al.  Femtosecond laser-induced breakdown in distilled water for fabricating the helical microchannels array. , 2011, Optics letters.

[6]  Y. Bellouard,et al.  Fabrication of high-aspect ratio, micro-fluidic channels and tunnels using femtosecond laser pulses and chemical etching. , 2004, Optics express.

[7]  F. He,et al.  Direct fabrication of homogeneous microfluidic channels embedded in fused silica using a femtosecond laser. , 2010, Optics letters.

[8]  M. Madou.  Fundamentals of microfabrication : the science of miniaturization , 2002 .

[9]  Koji Sugioka,et al.  Three-dimensional microfluidic channel with arbitrary length and configuration fabricated inside glass by femtosecond laser direct writing. , 2010, Optics letters.

[10]  V. Maselli,et al.  Integration of optical waveguides and microfluidic channels fabricated by femtosecond laser irradiation , 2007, 2007 Conference on Lasers and Electro-Optics (CLEO).

[11]  A. Bhagat,et al.  Continuous particle separation in spiral microchannels using Dean flows and differential migration. , 2008, Lab on a chip.

[12]  J. Nishii,et al.  Three-dimensional hole drilling of silica glass from the rear surface with femtosecond laser pulses. , 2001, Optics letters.

[13]  R. Osellame,et al.  Femtosecond laser microstructuring: an enabling tool for optofluidic lab‐on‐chips , 2011 .

[14]  Jason R. Grenier,et al.  Femtosecond laser written optofluidic sensor: Bragg Grating Waveguide evanescent probing of microfluidic channel. , 2009, Optics express.

[15]  Koji Sugioka,et al.  Control of the cross-sectional shape of a hollow microchannel embedded in photostructurable glass by use of a femtosecond laser. , 2003, Optics letters.

[16]  Victor M Ugaz,et al.  Fluid mixing in planar spiral microchannels. , 2006, Lab on a chip.

[17]  G. Whitesides.  The origins and the future of microfluidics , 2006, Nature.

[18]  R. Osellame,et al.  Shape control of microchannels fabricated in fused silica by femtosecond laser irradiation and chemical etching. , 2009, Optics express.

[19]  Koji Sugioka,et al.  Rapid prototyping of three-dimensional microfluidic mixers in glass by femtosecond laser direct writing. , 2012, Lab on a chip.