Effect of Total Oxygen Content on the Machinability of Low Carbon Resulfurized Free Cutting Steel

The effect of total oxygen content on the machinability of low carbon resulfurized free cutting steel was studied by means of machinability tests, metallographic, and scanning electron microscopy observation. The results showed that the total oxygen content had a notable effect on the machinability of SAE 1215 steel. The best machinability of the steel in terms of tool life and surface roughness could be obtained by controlling the total oxygen content at 0.0105 and 0.0125 wt%. When total oxygen content in the steel was less than 0.0105 wt%, the machinability of the steel was increased with the increase of total oxygen content because of the significant reduction of the aspect ratio of MnS inclusions. However, when total oxygen content in the steel was more than 0.0125 wt%, the machinability of the steel was deteriorated dramatically with the increase of total oxygen content, which was attributed to that the amount and the size of oxide inclusions (MnO–Al2O3, MnO–SiO2, and 2MnO–SiO2) with high hardness and high melting point both had a significant increase, and some MnS inclusions were also wrapped by the MnO–SiO2 and 2MnO–SiO2 hard oxides. Furthermore, the tool wear would reach the maximum when total oxygen in the steel rose to 0.0150 wt%.

[1]  Hae-geon Lee,et al.  Phase Equilibria of the MnO–SiO2–Al2O3–MnS System , 2010 .

[2]  J. Fujiwara,et al.  Cutting Mechanism of Sulfrized Free-Machining Steel , 2009 .

[3]  Yu. D. Yashin,et al.  High-Machineability Steels , 2005 .

[4]  A. Pelton,et al.  Thermodynamic evaluation and optimization of the MnO-Al2O3 and MnO-Al2O3-SiO2 systems and applications to inclusion engineering , 2004 .

[5]  H. Hänninen,et al.  Effects of the composition, shape factor and area fraction of sulfide inclusions on the machinability of re-sulfurized free-machining steel , 1996 .

[6]  Kohichi Isobe,et al.  The Effect of Oxygen Content on the Formation Behavior of Sulfides of MnS System and the Machinability of Low Carbon Resulphurized Steel , 1994 .

[7]  K. Ishida,et al.  Morphology Control of MnS in Steel during Solidification , 1994 .

[8]  H. Yaguchi.  Scanning electron microscopy and electron microprobe analysis of built-up edges in low carbon resulfurized free-machining steel , 1986 .

[9]  H. Yaguchi.  Effect of MnS inclusion size on machinabilty of low-carbon, leaded, resulfurized free-machining steel , 1986 .

[10]  J. Bellot.  Steels with improved machinability , 1980 .

[11]  S. Ramalingam,et al.  Oxide inclusions and tool wear in machining , 1979 .

[12]  V. D. Kal’ner,et al.  Hardness conversion tables , 1977 .

[13]  M. Flemings,et al.  Sulfide inclusions in steel , 1975 .

[14]  S. Ramalingam,et al.  Free Machining Steels—The Behavior of Type I MnS Inclusions in Machining , 1974 .