Transient Fuel Modeling and Control for Cold Start Intake Cam Phasing
暂无分享,去创建一个
Eric Warren Curtis | Mrdjan J. Jankovic | Stephen William Magner | John Batteh | Peter C. Moilanen | M. Jankovic | Jim Wallace | E. Curtis | J. Batteh | Peter Moilanen | S. Magner | J. Wallace
[1] Rudolf H. Stanglmaier,et al. Investigation of Intake Timing Effects on the Cold Start Behavior of a Spark Ignition Engine , 1999 .
[2] Brian Spalding,et al. Combustion and mass transfer , 1979 .
[3] Eric Warren Curtis,et al. Macroscopic Model of the D86 Fuel Volatility Procedure , 1998 .
[4] John B. Heywood,et al. Liquid Gasoline Behavior in the Engine Cylinder of a SI Engine , 1994 .
[5] Eric Warren Curtis,et al. The Effects of Injector Targeting and Fuel Volatility on Fuel Dynamics in a PFI Engine During Warm-up: Part II - Modeling Results , 1998 .
[6] Walter W. Yuen,et al. Deposition of Fuel Droplets in Horizontal Intake Manifolds and the Behavior of Fuel Film Flow on Its Walls , 1984 .
[7] John B. Heywood,et al. Intake Port Phenomena in a Spark-Ignition Engine at Part Load , 1991 .
[8] Toru Kidokoro,et al. Development of PZEV exhaust emission Control system , 2003 .
[9] C. F. Aquino. Transient A/F Control Characteristics of the 5 Liter Central Fuel Injection Engine , 1981 .
[10] J. R. Mondt,et al. Predicted Cold Start Emission Reductions Resulting from Exhaust Thermal Energy Conservation to Quicken Catalytic Converter Lightoff , 1993 .
[11] Eric Warren Curtis,et al. The Effects of Injector Targeting and Fuel Volatility on Fuel Dynamics in a PFI Engine During Engine Warm-up: Part I - Experimental Results , 1998 .
[12] Eric Warren Curtis,et al. A New Port and Cylinder Wall Wetting Model to Predict Transient Air/Fuel Excursions in a Port Fuel Injected Engine , 1996 .
[13] Yann Chamaillard,et al. A Model for Residual Gas Fraction Prediction in Spark Ignition Engines , 2002 .
[14] R. H. Thring,et al. Reduced Cold-Start Emissions Using Rapid Exhaust Port Oxidation (REPO) in a Spark-Ignition Engine , 1997 .
[15] S. Skippon,et al. Effects of Fuel Composition on In-Cylinder Air/Fuel Ratio During Fuelling Transients in an SI Engine, Measured Using Differential Infra-Red Absorption , 1996 .
[16] Eric Warren Curtis,et al. Modeling Transient Fuel Effects with Alternative Fuels , 2005 .
[17] Wai K. Cheng,et al. Mixture Preparation and Hydrocarbon Emissions Behaviors in the First Cycle of SI Engine Cranking , 2002 .
[18] Eric Warren Curtis,et al. Analytical Assessment of Simplified Transient Fuel Tests for Vehicle Transient Fuel Compensation , 2005 .
[19] Eric Warren Curtis,et al. The Occurrence of Flash Boiling in a Port Injected Gasoline Engine , 1998 .
[20] Elbert Hendricks,et al. The Analysis of Mean Value SI Engine Models , 1989 .
[21] Elbert Hendricks,et al. Nonlinear Transient Fuel Film Compensation (NTFC) , 1993 .
[22] Charles F. Aquino,et al. Transient A/F characteristics for cold operation of a 1.6 liter engine with sequential fuel injection , 1988 .
[23] Eric Warren Curtis,et al. Modeling intake valve warm-up , 1997 .
[24] Eric Warren Curtis,et al. Modeling Transient Fuel Effects with Variable Cam Timing , 2003 .
[25] Keiso Takeda,et al. A New Method to Analyze Fuel Behavior in a Spark Ignition Engine , 1995 .
[26] Peter James Maloney,et al. An Event-Based Transient Fuel Compensator with Physically Based Parameters , 1999 .
[27] G. Woschni. A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .