Estimation of the In-Cylinder Air/Fuel Ratio of an Internal Combustion Engine by the Use of Pressure Sensors

This thesis investigates the use of cylinder pressure measurements for estimation of the in-cylinder air/fuel ratio in a spark ignited internal combustion engine. An estimation model which uses the net heat release profile for estimating the cylinder air/fuel ratio of a spark ignition engine is developed. The net heat release profile is computed from the cylinder pressure trace and quantifies the conversion of chemical energy of the reactants in the charge into thermal energy. The net heat release profile does not take heat- or mass transfer into account. Cycle-averaged air/fuel ratio estimates over a range of engine speeds and loads show an RMS error of 4.1% compared to measurements in the exhaust. A thermochemical model of the combustion process in an internal combustion engine is developed. It uses a simple chemical combustion reaction, polynomial fits of internal energy as function of temperature, and the first law of thermodynamics to derive a relationship between measured cylinder pressure and the progress of the combustion process. Simplifying assumptions are made to arrive at an equation which relates the net heat release to the cylinder pressure. Two methods for estimating the sensor offset of a cylinder pressure transducer are developed. Both methods fit the pressure data during the pre-combustion phase of the compression stroke to a polytropic curve. The first method assumes a known polytropic exponent, and the other estimates the polytropic exponent. The first method results in a linear least-squares problem, and the second method results in a nonlinear least-squares problem. The nonlinear least-squares problem is solved by separating out the nonlinear dependence and solving the single-variable minimization problem. For this, a finite difference Newton method is derived. Using this method, the cost of solving the nonlinear least-squares problem is only slightly higher than solving the linear least-squares problem. Both methods show good statistical behavior. Estimation error variances are inversely proportional to the number of pressure samples used for the estimation as predicted by the central limit theorem.

[1]  Chen-Fang Chang,et al.  Cylinder-Pressure-Based Engine Control Using Pressure-Ratio-Management and Low-Cost Non-Intrusive Cylinder Pressure Sensors , 2000 .

[2]  Jeffrey K. Ball,et al.  Combustion analysis and cycle-by-cycle variations in spark ignition engine combustion Part 1: An evaluation of combustion analysis routines by reference to model data , 1998 .

[3]  R. Fletcher.  Practical Methods of Optimization , 1988 .

[4]  Frederic Anton Matekunas,et al.  The Nature of Turbulent Flame Propagation in a Homogeneous Spark-Ignited Engine , 1980 .

[5]  R. H. Thring,et al.  Homogeneous-Charge Compression-Ignition (HCCI) Engines , 1989 .

[6]  B. Mcbride,et al.  FORTRAN 4 computer program for calculation of thermodynamic and transport properties of complex chemical systems , 1973 .

[7]  J. David Powell,et al.  Engine control using cylinder pressure : past, present, and future , 1993 .

[8]  J. M. Novak,et al.  The Prediction of Ignition Delay and Combustion Intervals for a Homogeneous Charge, Spark Ignition Engine , 1978 .

[9]  P. Tunestal,et al.  In-cylinder measurement for engine cold-start control , 1999, Proceedings of the 1999 IEEE International Conference on Control Applications (Cat. No.99CH36328).

[10]  Roger Fletcher,et al.  Practical methods of optimization; (2nd ed.) , 1987 .

[11]  Marek T. Wlodarczyk,et al.  In-Cylinder Fiber-Optic Pressure Sensors for Monitoring and Control of Diesel Engines , 1998 .

[12]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .

[13]  Patricia V. Russo.  Pollution and Policy , 1979 .

[14]  A. J. Haagen-Smit.  Chemistry and Physiology of Los Angeles Smog , 1952 .

[15]  James C. Keck,et al.  EXPERIMENTAL AND THEORETICAL INVESTIGATION OF TURBULENT BURNING MODEL FOR INTERNAL COMBUSTION ENGINES , 1974 .

[16]  M. Metghalchi,et al.  Burning Velocities of Mixtures of Air with Methanol, Isooctane, and Indolene at High Pressure and Temperature , 1982 .

[17]  Lloyd Withrow,et al.  Motion Pictures of Engine Flames Correlated with Pressure Cards , 1938 .

[18]  Andrew L. Emtage,et al.  The Calculation of Heat Release Energy from Engine Cylinder Pressure Data , 1998 .

[19]  John B. Heywood,et al.  Heat Release Analysis of Engine Pressure Data , 1984 .

[20]  J. David Powell,et al.  Air-fuel ratio control in spark-ignition engines using estimation theory , 1995, IEEE Trans. Control. Syst. Technol..

[21]  D. S. Bayard,et al.  An algorithm for state-space frequency domain identification without windowing distortions , 1992, [1992] Proceedings of the 31st IEEE Conference on Decision and Control.

[22]  J. Karl Hedrick,et al.  Sliding Mode Fuel-Injection Controller: Its Advantages , 1991 .

[23]  Song-Charng Kong,et al.  Modeling Combustion in Compression Ignition Homogeneous Charge Engines , 1992 .

[24]  J. David Powell,et al.  Engine Air-Fuel Ratio Control Using an Event-Based Observer , 1993 .

[25]  J. D. Powell,et al.  Closed Loop Control of Spark Advance Using a Cylinder Pressure Sensor , 1976 .

[26]  J. K. Hedrick,et al.  A Nonlinear Controller Design Method for Fuel-Injected Automotive Engines , 1988 .

[27]  John B. Heywood,et al.  PERFORMANCE AND NOx EMISSIONS MODELING OF A JET IGNITION PRECHAMBER STRATIFIED CHARGE ENGINE. , 1976 .

[28]  Rolf Isermann,et al.  Methods for engine supervision and control based on cylinder pressure information , 1999 .

[29]  Β. L. HO,et al.  Editorial: Effective construction of linear state-variable models from input/output functions , 1966 .

[30]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[31]  Jacqueline Scherpen,et al.  A in noise free o p t i m i z a t i o n 1 L £ szl , 2000 .

[32]  Michael F. J. Brunt,et al.  Evaluation of Techniques for Absolute Cylinder Pressure Correction , 1997 .

[33]  David R. Lancaster,et al.  MEASUREMENT AND ANALYSIS OF ENGINE PRESSURE DATA , 1975 .

[34]  Jer-Nan Juang,et al.  An eigensystem realization algorithm for modal parameter identification and model reduction. [control systems design for large space structures] , 1985 .

[35]  Bengt Johansson,et al.  Experiments and simulation of a six-cylinder homogeneous charge compression ignition (HCCI) engine , 2000 .

[36]  Andrew L. Emtage,et al.  Evaluation of Burn Rate Routines and Analysis Errors , 1997 .

[37]  R. G. Stone,et al.  Mechanical engineering department , 1976 .

[38]  Antonio Lecuona,et al.  Evaluation of Pressure and Crank Angle Errors from Reciprocating Engine Indicator Diagrams , 1986 .

[39]  R. H. Roy,et al.  Estimating In-Cylinder Precombustion Mixture Temperatures Using Acoustic Resonances , 1996 .

[40]  J. David Powell,et al.  Identification and air-fuel ratio control of a spark ignition engine , 1995, IEEE Trans. Control. Syst. Technol..

[41]  Andrew L. Randolph,et al.  Methods of Processing Cylinder-Pressure Transducer Signals to Maximize Data Accuracy , 1990 .

[42]  Peter Wibberley,et al.  An Investigation of Cylinder Pressure as Feedback for Control of Internal Combustion Engines , 1989 .

[43]  J. M. Rife,et al.  Knock in Spark Ignition Engines , 1981 .

[44]  J. D. Powell,et al.  Fuel-Air Ratio Determination From Cylinder Pressure Time Histories , 1985 .

[45]  N. D. Whitehouse,et al.  Prediction of Heat Release in a Quiescent Chamber Diesel Engine Allowing for Fuel/Air Mixing , 1974 .

[46]  Stephen Yurkovich,et al.  Comparative analysis of closed loop AFR control during cold start , 1998, Proceedings of the 1998 American Control Conference. ACC (IEEE Cat. No.98CH36207).

[47]  D. Foster,et al.  Compression-Ignited Homogeneous Charge Combustion , 1983 .

[48]  Yukiyasu Tanaka,et al.  A Study on Gasoline Engine Combustion by Observation of Intermediate Reactive Products during Combustion , 1979 .

[49]  Lars Eriksson,et al.  Ionization current interpretation for ignition control in internal combustion engines , 1997 .

[50]  J. Karl Hedrick,et al.  An observer-based controller design method for improving air/fuel characteristics of spark ignition engines , 1998, IEEE Trans. Control. Syst. Technol..

[51]  J. D. Powell,et al.  Closed loop, knock adaptive spark timing control based on cylinder pressure , 1978 .