CFD Prediction of Erosion Wear in Centrifugal Slurry Pumps for Dilute Slurry Flows

The paper discusses numerical prediction of erosion wear trends in centrifugal pump casing pumping dilute slurries. The casing geometry is considered two-dimensional. Discrete Phase Model (DPM) in FLUENT 6.1® is utilized to obtain dilute slurry flow field through the pump casing employing two-way coupling. Standard k — e model is used for turbulence. Effect of several operational parameters viz. pump flow rate, pump speed (RPM), particle diameter and various geometry conditions viz. tongue curvature, slope of the discharge pipe and casing width is studied. Qualitative trends of erosion wear is described for these operational and geometric parameters with an idea to lower the wear rates and to make the wear pattern along the casing wall as uniform as possible. For example, with increase in pump flow rate, wear rates tends to even out whereas with increased casing width, wear rates are found to decrease.

[1]  Farid Bakir,et al.  Numerical Modelization of the Flow in Centrifugal Pump: Volute Influence in Velocity and Pressure Fields , 2005 .

[2]  Krishnan V. Pagalthivarthi,et al.  Determination of wear coefficients for erosive wear prediction through Coriolis wear testing , 2005 .

[3]  Srdjan Nesic,et al.  Particle tracking and erosion prediction in three-dimensional bends , 2000 .

[4]  H. Clark,et al.  Measurements of specific energies for erosive wear using a Coriolis erosion tester , 2000 .

[5]  Kiyoshi Minemura,et al.  Measurement of erosion due to particle impingement and numerical prediction of wear in pump casing , 1996 .

[6]  J. Fontaine,et al.  A lagrangian model for solid particles in turbulent flows , 1993 .

[7]  Roland Clift,et al.  Slurry Transport Using Centrifugal Pumps , 1992 .

[8]  K. Minemura,et al.  Calculation of the Three-Dimensional Behaviour of Spherical Solid Particles Entrained in a Radial-Flow Impeller Pump , 1990 .

[9]  Yoshinobu Morikawa,et al.  Numerical simulation of gas-solid two-phase flow in a two-dimensional horizontal channel , 1987 .

[10]  S. A. Morsi,et al.  An investigation of particle trajectories in two-phase flow systems , 1972, Journal of Fluid Mechanics.

[11]  Anders Sellgren,et al.  Prediction of slurry pump component wear and cost , 2005 .

[12]  Carlos F.M. Coimbra,et al.  Fundamental aspects of modeling turbulent particle dispersion in dilute flows , 1996 .

[13]  Kv Pagalthivarthi,et al.  Applications of Materials Wear Testing to Solids Transport via Centrifugal Slurry Pumps , 1992 .

[14]  K. V. Pagalthivarthi,et al.  PARTICULATE MOTION AND CONCENTRATION FIELDS IN CENTRIFUGAL SLURRY PUMPS , 1990 .

[15]  M. C. Roco,et al.  STUDY ON CASING PERFORMANCES IN CENTRIFUGAL SLURRY PUMPS , 1985 .

[16]  J. Bitter.  A study of erosion phenomena part I , 1963 .