Analysis of wound filter performance from DREF yarn spun at different suction pressure

Abstract Wound filters are quite popular in the domestic water purification systems. The performance of these filters is based on the distinctive yarn and winding variables. Yarn used for filtration application is normally produced on DREF spinning system. Several researchers have reported the influence of DREF spinning variables on yarn properties. However none of them are in context of filtration application. Since elucidation of influence of winding parameters on the filter performance has already been reported; it thus becomes intriguing to explore the influence of spinning suction pressure on filtration behavior. Yarn spun at different suction pressures was used to produce wound filter cartridges, keeping winding variables unchanged. Filters wound using yarn spun at higher spinning suction pressure resulted in greater pressure drop but showed better micron rating. However the pressure drop encountered also affects the retention capacity of the wound filter. The outcome of this study helps in establishing the relation between spinning suction pressure and performance parameters of wound filters. Design expert® software was used to develop regression equations to predict performance of wound filter for the given spinning suction pressure which is of practical significance for yarn and filter manufacturers, without performing filter test.