论文信息 - Generation Mechanism of Quadrant Glitches and Compensation for it in Feed Drive Systems of NC Machine Tools - 字舞流文

Generation Mechanism of Quadrant Glitches and Compensation for it in Feed Drive Systems of NC Machine Tools

Ryuta Sato | R. Sato

[1] Kok Kiong Tan,et al. Friction modeling and adaptive compensation using a relay feedback approach , 2001, IEEE Trans. Ind. Electron..

[2] J. F. Cuttino,et al. Analytical and Experimental Identification of Nonlinearities in a Single-Nut, Preloaded Ball Screw , 1997 .

[3] Masaomi Tsutsumi,et al. Modeling and Controller Tuning Techniques for Feed Drive Systems , 2005 .

[4] Yusuf Altintas,et al. High Speed CNC System Design. Part II : Modeling and Identification of Feed Drives , 2001 .

[5] Hyuk Lim,et al. Position control of X-Y table at velocity reversal using presliding friction characteristics , 2003, IEEE Trans. Control. Syst. Technol..

[6] Masayoshi Tomizuka,et al. Low Velocity Friction Compensation and Feedforward Solution Based on Repetitive Control , 1993 .

[7] Xuesong Mei,et al. Study on the compensation of error by stick-slip for high-precision table , 2004 .

[8] Yusuf Altintas,et al. High speed CNC system design. Part III: high speed tracking and contouring control of feed drives , 2001 .

[9] Atsushi Matsubara,et al. 320 A Stick Motion Compensation System with a Dynamic Model , 2004 .

[10] Takaaki Oiwa,et al. Study on Friction Model of Linear Ball Guideway for Precision Positioning , 2006 .

[11] Masaomi Tsutsumi,et al. Mathematical Model of Linear Motor Stage with Non-Linear Friction Characteristics , 2008 .