Numerical modeling of a proton exchange membrane fuel cell with tree-like flow field channels based on an entropy generation analysis

Abstract This paper presents a three-dimensional numerical modeling of a PEM fuel cell with tree-like flow field channels. Four different tree-like configurations are considered for the study based on a statistical analysis of the veins of the leaves of different trees. The number of bifurcations of the vein and their inclination are considered as parameters for the characterization. Four different configurations are the most recurrent, corresponding to one level of bifurcation at 37° and 74° and two levels of bifurcation at 37° and 74°. The model considers a complete solution of the mass, momentum, energy, and electrochemical equations. An entropy generation analysis is developed as a post processing once the solution of the models is obtained. Because new geometries for the channel configuration in the bipolar plates are introduced, special attention is considered for the entropy generation due to mass flow. Results indicate that the configuration with two levels of bifurcation at 37° is efficient at removing water from the cathode channels, resulting in a good current density production. In addition, a better performance of the PEM fuel cell (higher current density production and lower entropy production) is obtained by increasing the number of bifurcations.

[1]  Stefano Cordiner,et al.  Fuel cell based power systems to supply power to Telecom Stations , 2014 .

[2]  Abel Hernandez-Guerrero,et al.  Entropy Generation Analysis for a PEM Fuel-Cell With a Biomimetic Flow Field , 2009 .

[3]  Ned Djilali,et al.  Computational modelling of polymer electrolyte membrane (PEM) fuel cells: Challenges and opportunities , 2007 .

[4]  Abdul-Ghani Olabi,et al.  Design of experiment study of the parameters that affect performance of three flow plate configurations of a proton exchange membrane fuel cell , 2010 .

[5]  Abel Hernandez-Guerrero,et al.  Current density and polarization curves for radial flow field patterns applied to PEMFCs (Proton Exchange Membrane Fuel Cells) , 2010 .

[6]  Dimos Poulikakos,et al.  Tree network channels as fluid distributors constructing double-staircase polymer electrolyte fuel cells , 2004 .

[7]  José C. Páscoa,et al.  Analysis of PEM (Polymer Electrolyte Membrane) fuel cell cathode two-dimensional modeling , 2014 .

[8]  Stefano Cordiner,et al.  Energy management in a domestic microgrid by means of model predictive controllers , 2016 .

[9]  Hong Liu,et al.  Experimental Study and Comparison of Various Designs of Gas Flow Fields to PEM Fuel Cells and Cell Stack Performance , 2014, Front. Energy Res..

[10]  Stefano Cordiner,et al.  Domestic distributed power generation: Effect of sizing and energy management strategy on the environmental efficiency of a photovoltaic-battery-fuel cell system , 2014 .

[11]  Arunachala Mada Kannan,et al.  Nature inspired flow field designs for proton exchange membrane fuel cell , 2013 .

[12]  Tao Chen,et al.  Development of bipolar plates with different flow channel configurations based on plant vein for fuel cell , 2013 .

[13]  M. Dassisti,et al.  Advances in stationary and portable fuel cell applications , 2016 .

[14]  Stefano Cordiner,et al.  A Study of Energy Management in Domestic Micro-grids Based on Model Predictive Control Strategies☆ , 2014 .

[15]  Dimos Poulikakos,et al.  Polymer Electrolyte Fuel Cells With Porous Materials as Fluid Distributors and Comparisons With Traditional Channeled Systems , 2004 .

[16]  Byungki Ahn,et al.  Parametric study of the channel design at the bipolar plate in PEMFC performances , 2008 .

[17]  A. Olabi,et al.  Three-dimensional proton exchange membrane fuel cell model: Comparison of double channel and open pore cellular foam flow plates , 2017 .

[18]  Peiwen Li,et al.  Numerical investigation of the performance of symmetric flow distributors as flow channels for PEM fuel cells , 2012 .

[19]  Lingai Luo,et al.  Experimental investigation of the flow distribution of a 2-dimensional constructal distributor , 2008 .

[20]  C D Murray,et al.  The Physiological Principle of Minimum Work: I. The Vascular System and the Cost of Blood Volume. , 1926, Proceedings of the National Academy of Sciences of the United States of America.

[21]  Pablo Cañizares,et al.  Three-dimensional model of a 50 cm2 high temperature PEM fuel cell. Study of the flow channel geometry influence , 2010 .

[22]  G. Lebon,et al.  Extended irreversible thermodynamics , 1993 .

[23]  Francisco Elizalde-Blancas,et al.  Constructal flow distributor as a bipolar plate for proton exchange membrane fuel cells , 2011 .

[24]  S. Dutta,et al.  Three-dimensional numerical simulation of straight channel PEM fuel cells , 2000 .

[25]  J. Wang,et al.  Flow‐Field Designs of Bipolar Plates in PEM Fuel Cells: Theory and Applications , 2012 .

[26]  M. Abdollahzadeh,et al.  Influence of cathode flow pulsation on performance of proton exchange membrane fuel cell with interdigitated gas distributors , 2016 .

[27]  Xabier Garikano,et al.  Influence of geometric parameters of the flow fields on the performance of a PEM fuel cell. A review , 2012 .

[28]  Ay Su,et al.  A three-dimensional full-cell CFD model used to investigate the effects of different flow channel designs on PEMFC performance , 2007 .

[29]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[30]  A. Olabi,et al.  Optmisation of bipolar plate through computational fluid dynamic simulation and modelling using nickle open pore cellular foam material , 2017 .

[31]  Jae Hwan Ahn,et al.  Effects of clamping force on the water transport and performance of a PEM (proton electrolyte membrane) fuel cell with relative humidity and current density , 2015 .

[32]  A. Bejan.  Shape and Structure, from Engineering to Nature , 2000 .

[33]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[34]  Stefano Cordiner,et al.  A study on the energy management in domestic micro-grids based on Model Predictive Control strategies☆ , 2015 .

[35]  Ahmed Al Makky,et al.  Computational Fluid Dynamic simulation and modelling (CFX) of flow plate in PEM fuel cell using aluminum open cellular foam material , 2017, 2017 IEEE Texas Power and Energy Conference (TPEC).

[36]  F. Elizalde-Blancas,et al.  Multiple concentric spirals for the flow field of a proton exchange membrane fuel cell , 2011 .

[37]  D. Poulikakos,et al.  Pyramidal direct methanol fuel cells , 2006 .

[38]  Ralph E. White,et al.  A water and heat management model for proton-exchange-membrane fuel cells , 1993 .

[39]  M.K.S. Sastry,et al.  PEMFC Flow Channel Geometry Optimization: A Review , 2012 .

[40]  Adrian Bejan,et al.  Design with constructal theory , 2008 .

[41]  Jin Hyun Nam,et al.  Effective diffusivity and water-saturation distribution in single- and two-layer PEMFC diffusion medium , 2003 .

[42]  Zhixiang Liu,et al.  Numerical simulation for rib and channel position effect on PEMFC performances , 2010 .

[43]  Hongtan Liu,et al.  Effect of pressure difference between adjacent channels in an adjustable flow field in PEM fuel cells , 2017 .

[44]  A. Bejan.  Entropy Generation Minimization: The Method of Thermodynamic Optimization of Finite-Size Systems and Finite-Time Processes , 1995 .

[45]  Jianren Fan,et al.  Three-dimensional numerical analysis of proton exchange membrane fuel cells (PEMFCs) with conventional and interdigitated flow fields , 2004 .

[46]  S. Maharudrayya,et al.  Pressure losses in laminar flow through serpentine channels in fuel cell stacks , 2004 .

[47]  Chaoyang Wang,et al.  Three-dimensional analysis of transport and electrochemical reactions in polymer electrolyte fuel cells , 2004 .

[48]  Alexandra M.F.R. Pinto,et al.  Numerical simulations of two-phase flow in an anode gas channel of a proton exchange membrane fuel cell , 2015 .

[49]  Christopher Hebling,et al.  Investigation of fractal flow-fields in portable proton exchange membrane and direct methanol fuel cells , 2004 .

[50]  D'arcy W. Thompson.  On growth and form i , 1943 .

[51]  Chao-Yang Wang,et al.  Computational Fluid Dynamics Modeling of Proton Exchange Membrane Fuel Cells , 2000 .