Identifying interactive effects of task demands in lifting on estimates of in vivo low back joint loads.

This investigation examined interactions between the magnitude of external load, movement speed and (a)symmetry of load placement on estimates of in vivo joint loading in the lumbar spine during simulated occupational lifting. Thirty-two participants with manual materials handling experience were included in the study. Three-dimensional motion data, ground reaction forces, and activation of six bilateral trunk muscle groups were captured while participants performed lifts with two loads at two movement speeds and using two load locations. L4-L5 joint compression and shear force-time histories were estimated using an EMG-assisted musculoskeletal model of the lumbar spine. Results from this investigation provide strong evidence that known mechanical low back injury risk factors should not be viewed in isolation. Rather, injury prevention efforts need to consider the complex interactions that exist between external task demands and their combined influence on internal joint loading.

[1]  W S Marras,et al.  Variability in spine loading model performance. , 1999, Clinical biomechanics.

[2]  Jack P Callaghan,et al.  Compressive force magnitude and intervertebral joint flexion/extension angle influence shear failure force magnitude in the porcine cervical spine. , 2012, Journal of biomechanics.

[3]  P Lacouture,et al.  Effects of movement for estimating the hip joint centre. , 2007, Gait & posture.

[4]  Gerald A. Smith,et al.  Padding point extrapolation techniques for the Butterworth digital filter. , 1989, Journal of biomechanics.

[5]  W S Marras,et al.  Spine loading during asymmetric lifting using one versus two hands. , 1998, Ergonomics.

[6]  Steven A. Lavender,et al.  The effects of initial lifting height, load magnitude, and lifting speed on the peak dynamic L5/S1 moments , 2003 .

[7]  Idsart Kingma,et al.  Effect of initial horizontal object position on peak L5/S1 moments in manual lifting is dependent on task type and familiarity with alternative lifting strategies , 2011, Ergonomics.

[8]  Patrick G. Dempsey A survey of lifting and lowering tasks , 2003 .

[9]  J H van Dieën,et al.  Asymmetric low back loading in asymmetric lifting movements is not prevented by pelvic twist. , 1998, Journal of biomechanics.

[10]  Sean Gallagher,et al.  Examining the Interaction of Force and Repetition on Musculoskeletal Disorder Risk , 2013, Hum. Factors.

[11]  W S Marras,et al.  Trunk Strength during Asymmetric Trunk Motion , 1989, Human factors.

[12]  G B Andersson,et al.  The effects of lifting speed on the peak external forward bending, lateral bending, and twisting spine moments. , 1999, Ergonomics.

[13]  R. Norman,et al.  1986 Volvo Award in Biomechanics: Partitioning of the L4 - L5 Dynamic Moment into Disc, Ligamentous, and Muscular Components During Lifting , 1986, Spine.

[14]  M. Schwartz,et al.  A new method for estimating joint parameters from motion data. , 2004, Journal of biomechanics.

[15]  Jacob Cohen Statistical Power Analysis for the Behavioral Sciences , 1969, The SAGE Encyclopedia of Research Design.

[16]  H M Toussaint,et al.  An EMG technique for measuring spinal loading during asymmetric lifting. , 2001, Clinical biomechanics.

[17]  S. McGill,et al.  Frequency response of spine extensors during rapid isometric contractions: effects of muscle length and tension. , 1998, Journal of electromyography and kinesiology : official journal of the International Society of Electrophysiological Kinesiology.

[18]  J. Cholewicki,et al.  Mechanical stability of the in vivo lumbar spine: implications for injury and chronic low back pain. , 1996, Clinical biomechanics.

[19]  M K Chung,et al.  Effects of posture, weight and frequency on trunk muscular activity and fatigue during repetitive lifting tasks. , 1995, Ergonomics.

[20]  Jack P Callaghan,et al.  Physical fitness improvements and occupational low-back loading – an exercise intervention study with firefighters , 2014, Ergonomics.

[21]  Jack P Callaghan,et al.  FMS™ scores and low-back loading during lifting--whole-body movement screening as an ergonomic tool? , 2014, Applied ergonomics.

[22]  A Garg,et al.  Revised NIOSH equation for the design and evaluation of manual lifting tasks. , 1993, Ergonomics.

[23]  Jack P Callaghan,et al.  The rule of 1s for padding kinematic data prior to digital filtering: influence of sampling and filter cutoff frequencies. , 2009, Journal of electromyography and kinesiology : official journal of the International Society of Electrophysiological Kinesiology.

[24]  W. G. Allread,et al.  The Role of Dynamic Three-Dimensional Trunk Motion in Occupationally-Related Low Back Disorders: The Effects of Workplace Factors, Trunk Position, and Trunk Motion Characteristics on Risk of Injury , 1993, Spine.

[25]  Jack P Callaghan,et al.  Can the Functional Movement Screen™ be used to capture changes in spine and knee motion control following 12 weeks of training? , 2017, Physical therapy in sport : official journal of the Association of Chartered Physiotherapists in Sports Medicine.

[26]  At L Hof,et al.  Handling of impact forces in inverse dynamics. , 2006, Journal of biomechanics.

[27]  W S Marras,et al.  A Comprehensive Evaluation of Trunk Response to Asymmetric Trunk Motion , 1992, Spine.

[28]  R. Norman,et al.  Shear Happens! Suggested guidelines for ergonomists to reduce the risk of low back injury from shear loading , 1998 .

[29]  B. Bernard,et al.  Musculoskeletal disorders and workplace factors: a critical review of epidemiologic evidence for work-related musculoskeletal disorders of the neck, upper extremity, and low back , 1997 .

[30]  S. McGill Electromyographic activity of the abdominal and low back musculature during the generation of isometric and dynamic axial trunk torque: Implications for lumbar mechanics , 1991, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[31]  Jack P Callaghan,et al.  The Impact of Posture and Prolonged Cyclic Compressive Loading on Vertebral Joint Mechanics , 2012, Spine.

[32]  S. McGill The biomechanics of low back injury: implications on current practice in industry and the clinic. , 1997, Journal of biomechanics.

[33]  W S Marras,et al.  Biomechanical risk factors for occupationally related low back disorders. , 1995, Ergonomics.

[34]  J R Potvin,et al.  Trunk Muscle and Lumbar Ligament Contributions to Dynamic Lifts with Varying Degrees of Trunk Flexion , 1991, Spine.