Experimental and Numerical Analysis of an Active Pre-Chamber Engine Fuelled with Natural Gas

<div class="section abstract"><div class="htmlview paragraph">Increasingly stringent pollutant and CO<sub>2</sub> emission standards require the car manufacturers to investigate innovative solutions to further improve the fuel economy and environmental impact of their fleets. Nowadays, NO<sub>x</sub> emissions standards are stringent for spark-ignition (SI) internal combustion engines (ICEs) and many techniques are investigated to limit these emissions. Among these, an extremely lean combustion has a large potential to simultaneously reduce the NO<sub>x</sub> raw emissions and the fuel consumption of SI ICEs. Engines with pre-chamber ignition system are promising solutions for realizing a high air-fuel ratio which is both ignitable and with an adequate combustion speed.</div><div class="htmlview paragraph">In this work, the combustion characteristics of an active pre-chamber system are experimentally investigated using a single-cylinder research engine. The engine under exam is a large bore heavy-duty unit with an active pre-chamber fuelled with compressed natural gas.</div><div class="htmlview paragraph">In first stage, an experimental campaign was carried out for four different conditions of load and air/fuel ratio, at the same engine speed, then a 3D CFD analysis was realised to evaluate the in-cylinder turbulence and pre-chamber pressure traces. Global engine operating parameters as well as cylinder pressure traces, inside main combustion chamber and pre-chamber, were recorded and analysed. Based on the available 3D and experimental data, a phenomenological model of this unconventional combustion system is developed and validated.</div><div class="htmlview paragraph">The model is implemented in a commercial 1D code. The proposed numerical approach shows the ability to simulate the experimental data with good accuracy, with no case-dependent tuning. The model demonstrates to correctly describe the behaviour of a pre-chamber combustion system under the four operating conditions and to capture the physics behind such an innovative combustion system concept.</div></div>

[1]  F. Bozza,et al.  Development of a phenomenological model for the description of RCCI combustion in a dual-fuel marine internal combustion engine , 2022, Applied Energy.

[2]  T. Lucchini,et al.  A 3D-CFD Methodology for Combustion Modeling in Active Prechamber SI Engines Operating with Natural Gas , 2022, SAE Technical Paper Series.

[3]  F. Bozza,et al.  Experimental and 0D Numerical Investigation of Ultra-Lean Combustion Concept to Improve the Efficiency of SI Engine , 2021 .

[4]  F. Bozza,et al.  A phenomenological model for the description of unburned hydrocarbons emission in ultra-lean engines , 2021, International Journal of Engine Research.

[5]  Haiwen Ge,et al.  CFD Optimization of the Pre-Chamber Geometry for a Gasoline Spark Ignition Engine , 2021, Frontiers in Mechanical Engineering.

[6]  F. Bozza,et al.  Toward Predictive Combustion Modeling of CNG SI Engines in 1D Simulation Tools , 2020 .

[7]  Pablo Garcia Valladolid,et al.  Experimental and Numerical Assessment of Active Pre-chamber Ignition in Heavy Duty Natural Gas Stationary Engine , 2020 .

[8]  Fabio Bozza,et al.  1D Numerical and Experimental Investigations of an Ultralean Pre-Chamber Engine , 2019 .

[9]  Fabio Bozza,et al.  A Quasi-Dimensional Model of Pre-Chamber Spark-Ignition Engines , 2019, SAE Technical Paper Series.

[10]  Fabio Bozza,et al.  A Refined 0D Turbulence Model to Predict Tumble and Turbulence in SI Engines , 2018, SAE International Journal of Engines.

[11]  F. Bozza,et al.  Refinement of a 0D Turbulence Model to Predict Tumble and Turbulent Intensity in SI Engines. Part I: 3D Analyses , 2018 .

[12]  L. Qiao,et al.  Ignition of Ultra-Lean Premixed H 2 /air using Multiple Hot Turbulent Jets Generated by Pre-chamber Combustion , 2018 .

[13]  L. Qiao,et al.  A Numerical Investigation of Ignition of Ultra-Lean Premixed H 2 /Air Mixtures by Pre-Chamber Supersonic Hot Jet , 2017 .

[14]  Konstantinos Boulouchos,et al.  Fundamental Aspects of Jet Ignition for Natural Gas Engines , 2017 .

[15]  H. Eichlseder,et al.  Experimental and simulative investigation of flame–wall interactions and quenching in spark-ignition engines , 2016, Automotive and Engine Technology.

[16]  Kenji Hiraoka,et al.  Phenomenological 0-Dimensional Combustion Model for Spark-Ignition Natural Gas Engine Equipped with Pre-Chamber , 2016 .

[17]  B. Johansson,et al.  CFD Simulations of Pre-Chamber Jets' Mixing Characteristics in a Heavy Duty Natural Gas Engine , 2015 .

[18]  Arkadiusz Jamrozik,et al.  Lean combustion by a pre-chamber charge stratification in a stationary spark ignited engine , 2015 .

[19]  Paul J. Litke,et al.  Combustion Visualization, Performance, and CFD Modeling of a Pre-Chamber Turbulent Jet Ignition System in a Rapid Compression Machine , 2015 .

[20]  D. Veynante,et al.  Numerical study of laminar flame properties of diluted methane-hydrogen-air flames at high pressure and temperature using detailed chemistry , 2011 .

[21]  Stefan Pischinger,et al.  Ignition Systems for Highly Diluted Mixtures in SI-Engines , 1999 .

[22]  John B. Heywood,et al.  Modeling the Spark Ignition Engine Warm-Up Process to Predict Component Temperatures and Hydrocarbon Emissions , 1991 .

[23]  D. A. Santavicca,et al.  The Fractal Nature of Premixed Turbulent Flames , 1990 .

[24]  N. Ishikawa.  Bulk and wall flame quenching in nonuniform concentration fields , 1984 .

[25]  John B. Heywood,et al.  Flame photographs in a spark-ignition engine☆ , 1984 .

[26]  C. Westbrook,et al.  Simplified Reaction Mechanisms for the Oxidation of Hydrocarbon Fuels in Flames , 1981 .

[27]  James C. Keck,et al.  EXPERIMENTAL AND THEORETICAL INVESTIGATION OF TURBULENT BURNING MODEL FOR INTERNAL COMBUSTION ENGINES , 1974 .

[28]  J. Heywood,et al.  Experimental and Theoretical Study of Nitric Oxide Formation in Internal Combustion Engines , 1970 .

[29]  Vincenzo De Bellisa,et al.  Hierarchical 1D/3D approach for the development of a turbulent combustion model applied to a VVA turbocharged engine. Part II: combustion model , 2014 .