Most blades available for commercial-grade wind turbines incorporate a straight, span-wise profile and airfoil-shaped cross-sections. These blades are found to be very efficient at low and medium wind speeds compared with the potential energy that can be extracted. This paper explores the possibility of increasing the efficiency of the blades by modifying the blade design to incorporate a swept edge. The design intends to maintain efficiency at low to medium wind speeds by selecting the appropriate orientation and size of the airfoil cross-sections based on an oncoming wind speed and given constant rotation rate. The torque generated from a blade with straight-edge geometry is compared with that generated from a blade with a swept edge as predicted by CFD simulations. To validate the simulations, the experimental curve of the NTK500/41 turbine using LM19.1 blades is reproduced using the same computational conditions. In addition, structural deformations, stress distributions and structural vibration modes are compared between these two different turbine blade surfaces.
[1]
Steven A. Lane,et al.
Investigation of the sound transmission into an advanced grid-stiffened structure
,
2003
.
[2]
Martin Otto Laver Hansen,et al.
Aerodynamics of wind turbines : rotors, loads and structure
,
2000
.
[3]
F. Menter.
Improved two-equation k-omega turbulence models for aerodynamic flows
,
1992
.
[4]
Francesco Cambuli,et al.
Numerical Prediction of Horizontal Axis Wind Turbine Flow
,
2006
.
[5]
F. Menter.
ZONAL TWO EQUATION k-w TURBULENCE MODELS FOR AERODYNAMIC FLOWS
,
1993
.
[6]
Kurt Schaldemose Hansen,et al.
Online wind turbine measurement laboratory
,
2006
.
[7]
N Niels,et al.
Airfoil characteristics for wind turbines
,
1999
.
[8]
Esteban Ferrer,et al.
Wind turbine blade tip comparison using CFD
,
2007
.
[9]
Jeppe Johansen,et al.
Wind turbine airfoil catalogue
,
2001
.