论文信息 - Zonal Compensation for Work-Piece Elastic Deformation through Fixture Layout Optimization

Zonal Compensation for Work-Piece Elastic Deformation through Fixture Layout Optimization

Work-piece elastic deformation caused by clamping force from fixture will lead to part bending or distorting, which is critical to lower its quality performance. In this paper, a novel zonal compensation method is proposed to compensate the work-piece elastic deformation through fixture layout optimization based on High Definition Metrology (HDM). The zonal surface flatness data of work-piece in fixture is obtained with densely optical measurement firstly. Then, they are reorganized according to the accuracy requirement based on the zonal distribution. Finally, the surface flatness compensation model based on fixture layout is made. The practicality and effectiveness of this new approach was verified using the case of Aluminum alloy 6061 part milling.

Zhao Liang Jiang | Yu Mei Liu | Yun Xiao Shan

[1] Jianbin Xue,et al. Deformation control through fixture layout design and clamping force optimization , 2008 .

[2] Erhan Budak,et al. Analytical models for high performance milling. Part I: Cutting forces, structural deformations and tolerance integrity , 2006 .

[3] Zhao Liang Jiang,et al. Analysis of the Workpiece Elastic Deformation Holding in Fixture with High Definition Metrology , 2010 .

[4] Liu Zhanqiang,et al. Deformations of thin-walled plate due to static end milling force , 2008 .

[5] Aun-Neow Poo,et al. Error compensation in machine tools — a review: Part I: geometric, cutting-force induced and fixture-dependent errors , 2000 .