Cleaner production of carbon adsorbents by utilizing agricultural waste corn cob.

In the present study, the porous carbon products from agricultural waste corn cob were manufactured by using the combined activation methods. Under the experimental conditions in the activation temperature ranges of 500‐800°C with less pollution characteristics of potassium hydroxide:potassium carbonate (KOH:K2CO3) as chemical agents and subsequent gasification (i.e. physical activation) at the soaking time of 1 h, the influence of activation temperature on the final products was studied by examining their physical characterizations such as BET surface area, total pore volume and true density. The experimental results show that an elevated temperature is favorable for producing carbon products with high surface area and total pore volume. Also, the values of the true density and the porosity increase with increase in the activation temperature. Comparing the results of physical characterizations of the carbon products with those of commercial activated carbons indicates that the activated carbons prepared from agricultural waste corn cob by using a cleaner process is an available route for the biomass utilization and bioresource recycling. The high-surface-area carbon products thus obtained are very promising adsorbents for pollution control and for other applications. © 2001 Elsevier Science B.V. All rights reserved.

[1]  S. J. Gregg,et al.  Adsorption Surface Area and Porosity , 1967 .

[2]  P. Aggarwal,et al.  The production of active carbon from corn cobs by chemical activation , 1997 .

[3]  W. Tsai,et al.  Preparation and characterization of activated carbons from corn cob , 1997 .

[4]  Roger Perry,et al.  Low-cost adsorbents for waste and wastewater treatment: a review , 1992 .

[5]  G. Mckay.  Use of adsorbents for the removal of pollutants from wastewaters , 1996 .

[6]  W. Tsai,et al.  Surface chemistry of activated carbons and its relevance for effects of relative humidity on adsorption of chlorinated organic vapors , 1994 .

[7]  S. A. Watson,et al.  Corn: chemistry and technology. , 1987 .

[8]  Ching-Yuan Chang,et al.  Adsorption of methylene chloride vapor on activated carbons , 1994 .

[9]  D. Do,et al.  The preparation of activated carbon from macadamia nutshell by chemical activation , 1997 .

[10]  D. Do,et al.  The preparation of active carbons from coal by chemical and physical activation , 1996 .

[11]  THE AMERICAN ASSOCIATION OF CEREAL CHEMISTS. , 1942, Science.

[12]  N. Perotti,et al.  Corn cob as a bacterial substrate for the production of forage protein , 1988 .

[13]  P. Silverberg.  Activated carbon for the hole cleanup job , 1999 .

[14]  T. Otowa,et al.  Production and adsorption characteristics of MAXSORB: High-surface-area active carbon , 1993 .

[15]  Robert H. Essenhigh,et al.  Pyrolysis and Combustion of Corncobs in a Fluidized Bed: Measurement and Analysis of Behavior , 1995 .

[16]  K. Kobe,et al.  Chemical engineering kinetics , 1956 .

[17]  Á. Calafat,et al.  Factors affecting the preparation of activated carbons from coconut shell catalized by potassium , 1991 .

[18]  Kenneth E. Noll,et al.  Adsorption technology for air and water pollution control , 1991 .

[19]  S. Lowell,et al.  Powder surface area and porosity , 1984 .

[20]  W. Heschel,et al.  On the suitability of agricultural by-products for the manufacture of granular activated carbon , 1995 .

[21]  S. L. Lee,et al.  A LOW COST ADSORBENT FROM AGRICULTURAL WASTE CORN COB BY ZINC CHLORIDE ACTIVATION , 1998 .

[22]  T. Wigmans,et al.  Industrial aspects of production and use of activated carbons , 1989 .