A generic multielement microsystem for portable wireless applications

An open-architecture microsystem that can be populated with a variety of sensors and actuators is described. The microsystem is designed for low-power wireless applications where small size and high sensor accuracy are important. It consists of an in-module microcontroller connected to multiple front-end transducers through an intramodule sensor bus. An external interface allows internally processed data to be output through either a hard-wired input/output port or a radio-frequency transmitter. The present microsystem is configured for environmental monitoring and measured temperature, barometric pressure, relative humidity, and acceleration/vibration. It occupies less than 10 cc, consumes an average of 530 /spl mu/W from 6 V, and transmits data up to 50 m. System features such as active power management, the intramodule sensor bus, generic bus interface circuitry, and in-module sensor compensation based on bivariate polynomials are discussed.

[1]  K. Najafi,et al.  A high sensitivity z-axis torsional silicon accelerometer , 1996, International Electron Devices Meeting. Technical Digest.

[2]  Robert H. Dennard,et al.  CMOS scaling for high performance and low power-the next ten years , 1995, Proc. IEEE.

[3]  Kenzo Watanabe,et al.  A switched-capacitor interface for intelligent capacitive transducers , 1986, IEEE Transactions on Instrumentation and Measurement.

[4]  S. Hao,et al.  1 chip integrated software calibrated CMOS pressure sensor with MCU, A/D convertor, D/A convertor, digital communication port, signal conditioning circuit and temperature sensor , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[5]  A. B. Frazier,et al.  Metallic microstructures fabricated using photosensitive polyimide electroplating molds , 1993 .

[6]  James D. Meindl,et al.  Low power microelectronics: retrospect and prospect , 1995, Proc. IEEE.

[7]  Lawrence E. Larson.  RF and Microwave Circuit Design for Wireless Communications , 1996 .

[8]  Asad A. Abidi,et al.  Low-power radio-frequency ICs for portable communications , 1995, Proc. IEEE.

[9]  B.J. Hosticka,et al.  A smart pressure transducer with on-chip readout, calibration and nonlinear temperature compensation based on spline-functions , 1997, 1997 IEEE International Solids-State Circuits Conference. Digest of Technical Papers.

[10]  Franco Maloberti,et al.  Smart sensor interfaces , 1996, 1996 IEEE International Symposium on Circuits and Systems. Circuits and Systems Connecting the World. ISCAS 96.

[11]  Kensall D. Wise,et al.  A batch-processed vacuum-sealed capacitive pressure sensor , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[12]  K.D. Wise,et al.  Microelectromechanical systems: interfacing electronics to a non-electronic world , 1996, International Electron Devices Meeting. Technical Digest.

[13]  Kensall D. Wise,et al.  The coming opportunities in microsensor systems , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.

[14]  Kensall D. Wise,et al.  Digital compensation of high-performance silicon pressure transducers , 1990 .

[15]  Gerard C. M. Meijer,et al.  A microcontroller-based self-calibration technique for a smart capacitive angular-position sensor , 1997 .

[16]  Ping Tak Peter Tang,et al.  Table-lookup algorithms for elementary functions and their error analysis , 1991, [1991] Proceedings 10th IEEE Symposium on Computer Arithmetic.

[17]  Kristin L. Wood,et al.  Feasibility of micro power supplies for MEMS , 1997 .

[18]  R. A. Powers.  Batteries for low power electronics , 1995, Proc. IEEE.

[19]  K. Najafi,et al.  Low power, wide range threshold acceleration sensing system , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[20]  Nader Najafi,et al.  ANALYSIS OF SENSOR / ACTUATOR BUS INTEROPERABILITY STANDARD ALTERNATIVES FOR SEMICONDUCTOR MANUFACTURING , 1994 .

[21]  Kensall D. Wise,et al.  A High-accuracy Multi-element Silicon Barometric Pressure Sensor , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[22]  G.C.M. Meijer,et al.  A self-calibration technique for a smart capacitive angular-position sensor , 1996, Quality Measurement: The Indispensable Bridge between Theory and Reality (No Measurements? No Science! Joint Conference - 1996: IEEE Instrumentation and Measurement Technology Conference and IMEKO Tec.

[23]  Noboru Yamazoe,et al.  Humidity sensors: Principles and applications , 1986 .

[24]  M. L. Nagy,et al.  A capacitive sensing integrated circuit for detection of micromotor critical angles , 1997, IEEE J. Solid State Circuits.

[25]  Kensall D. Wise.  Integrated microinstrumentation systems: smart peripherals for distributed sensing and control , 1993, 1993 IEEE International Solid-State Circuits Conference Digest of Technical Papers.

[26]  Anantha P. Chandrakasan,et al.  Low-power CMOS digital design , 1992 .

[27]  Gabor C. Temes,et al.  High-accuracy circuits for on-chip capacitance ratio testing or sensor readout , 1994 .

[28]  Khalil Najafi,et al.  A Low-power Wireless Microinstrumentation System For Environmental Monitoring , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[29]  Ir C.J. Koomen.  Technologies for the Multimedia City , 1995, ESSDERC '95: Proceedings of the 25th European Solid State Device Research Conference.

[30]  Hae-Seung Lee,et al.  An adaptive calibration technique for micromachined pressure sensors , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[31]  Kensall D. Wise,et al.  An organization and interface for sensor-driven semiconductor process control systems , 1990 .

[32]  J. E. Brignell.  Sensors in distributed instrumentation systems , 1986 .

[33]  Bedrich J. Hosticka.  CMOS sensor systems , 1998 .

[34]  Eric Vittoz,et al.  A Low-Voltage CMOS Bandgap Reference , 1978, ESSCIRC 78: 4th European Solid State Circuits Conference - Digest of Technical Papers.

[35]  Gabriel M. Rebeiz,et al.  Micromachined devices for wireless communications , 1998, Proc. IEEE.

[36]  K. Najafi,et al.  A bulk silicon dissolved wafer process for microelectromechanical devices , 1992 .

[37]  Johan H. Huijsing,et al.  Integrated smart sensors , 1992 .

[38]  Kensall D. Wise.  Device and technology challenges for integrated sensors , 1995, 1995 53rd Annual Device Research Conference Digest.

[39]  Euisik Yoon,et al.  An integrated mass flow sensor with on-chip CMOS interface circuitry , 1992 .

[40]  Gerard C. M. Meijer.  Thermal sensors based on transistors , 1986 .

[41]  O. Neyroud,et al.  A low-voltage CMOS bandgap reference , 1979, IEEE Journal of Solid-State Circuits.

[42]  Kensall D. Wise,et al.  MOS SWITCHED-CAPACITOR READOUT AMPLIFIER FOR CAPACITIVE PRESSURE SENSORS. , 1983 .

[43]  Tadahiro Kuroda,et al.  Low power CMOS digital design for multimedia processors , 1999, ICVC '99. 6th International Conference on VLSI and CAD (Cat. No.99EX361).

[44]  K. D. Wise.  Integrated Microsystems: Device and Technology Challenges , 1995, ESSDERC '95: Proceedings of the 25th European Solid State Device Research Conference.