An experimental investigation of heat transfer enhancement in minichannel: Combination of nanofluid and micro fin structure techniques

Abstract This work experimentally studied the single-phase heat transfer and pressure drop characteristics by using two heat transfer enhancement techniques (micro fin structure and nanofluids) in multiport minichannel flat tube (MMFT). MMFT consisted of numerous parallel rectangular minichannels and is widely used in industry as the heat transfer unit of a heat exchanger. Firstly, the enhanced heat transfer performances by individually using one enhancement technique were investigated by testing Nusselt number, friction factor and performance evaluation criterion (PEC). In this section, five MMFTs with different micro fin numbers (N = 0, 1, 2, 3 and 4) and nanofluids with three volume concentrations ( φ  = 0.005%, 0.01% and 0.1%) were used as test sections and working fluids respectively. Secondly, the experiments using two combined enhancement technique were performed. By using conjunctively two enhancement techniques, Nusselt number increases by up to 158% at about Re  = 3600 and the maximum PEC value can reach 2.0 at Re  = 5150. Finally, an optimal heat transfer scheme was proposed based on test data.

[1]  R. Pease,et al.  High-performance heat sinking for VLSI , 1981, IEEE Electron Device Letters.

[2]  Wei Liu,et al.  Enhancing heat transfer in the core flow by using porous medium insert in a tube , 2010 .

[3]  Debjyoti Banerjee,et al.  Experimental study of forced convective heat transfer of nanofluids in a microchannel , 2012 .

[4]  C. Kleinstreuer,et al.  Thermal performance of nanofluid flow in microchannels , 2008 .

[5]  S. Eiamsa-ard,et al.  Single-phase heat transfer of CuO/water nanofluids in micro-fin tube equipped with dual twisted-tapes , 2012 .

[6]  S. Wongwises,et al.  A comparison of the heat transfer performance and pressure drop of nanofluid-cooled heat sinks with different miniature pin fin configurations , 2015 .

[7]  Ali Akbar Abbasian Arani,et al.  Experimental investigation of diameter effect on heat transfer performance and pressure drop of TiO2–water nanofluid , 2013 .

[8]  M. Ashjaee,et al.  Hydrodynamics and Heat Transfer Characteristics of a Miniature Plate Pin-Fin Heat Sink Utilizing Al2O3–Water and TiO2–Water Nanofluids , 2015 .

[9]  P. Promvonge,et al.  Heat Transfer Behavior in a Square Duct with Tandem Wire Coil Element Insert , 2012 .

[10]  Chinaruk Thianpong,et al.  Thermal performance evaluation of heat exchangers fitted with twisted-ring turbulators ☆ , 2012 .

[11]  Mohammad Ali Akhavan-Behabadi,et al.  Pressure drop and heat transfer augmentation due to coiled wire inserts during laminar flow of oil inside a horizontal tube , 2010 .

[12]  B. Sahin,et al.  Experimental investigation of heat transfer and pressure drop characteristics of Al2O3–water nanofluid , 2013 .

[13]  M. Khoshvaght-Aliabadi,et al.  Experimental analysis of thermal–hydraulic performance of copper–water nanofluid flow in different plate-fin channels , 2014 .

[14]  A. Koşar,et al.  Forced convective heat transfer across a pin fin micro heat sink , 2005 .

[15]  G. Batchelor.  The effect of Brownian motion on the bulk stress in a suspension of spherical particles , 1977, Journal of Fluid Mechanics.

[16]  A. Bontemps,et al.  Effects of Geometrical and Thermophysical Parameters on Heat Transfer Measurements in Small-Diameter Channels , 2006 .

[17]  Dong Liu,et al.  Experimental study on liquid flow and heat transfer in micro square pin fin heat sink , 2011 .

[18]  Bengt Sundén,et al.  On further enhancement of single-phase and flow boiling heat transfer in micro/minichannels , 2014 .

[19]  Jung-Yeul Jung,et al.  Forced convective heat transfer of nanofluids in microchannels , 2009 .

[20]  Yanhua Diao,et al.  Thermal-Hydraulic Performance of SiC-Water and Al2O3-Water Nanofluids in the Minichannel , 2016 .

[21]  Yanhua Diao,et al.  Experimental study of TiO2–water nanofluid flow and heat transfer characteristics in a multiport minichannel flat tube , 2014 .

[22]  Clement Kleinstreuer,et al.  Concentration photovoltaic–thermal energy co-generation system using nanofluids for cooling and heating , 2014 .

[23]  Ralph L. Webb,et al.  Performance evaluation criteria for use of enhanced heat transfer surfaces in heat exchanger design , 1981 .

[24]  W. Qu,et al.  Liquid Single-Phase Flow in an Array of Micro-Pin-Fins—Part I: Heat Transfer Characteristics , 2008 .

[25]  W. Chen,et al.  An experimental study on thermal performance of Al2O3/water nanofluid in a minichannel heat sink , 2013 .

[26]  R. Shah.  Laminar Flow Forced convection in ducts , 1978 .

[27]  Y. Diao,et al.  An experimental study on fluid flow and heat transfer in a multiport minichannel flat tube with micro-fin structures , 2015 .

[28]  Dong Liu,et al.  Single-Phase Thermal Transport of Nanofluids in a Minichannel , 2011 .

[29]  Wenhua Yu,et al.  The Role of Interfacial Layers in the Enhanced Thermal Conductivity of Nanofluids: A Renovated Maxwell Model , 2003 .

[30]  Stéphane Colin,et al.  Heat Transfer in Microchannels—2012 Status and Research Needs , 2013 .

[31]  Zelin Xu,et al.  Mathematical Modeling and Computer Simulations of Nanofluid Flow with Applications to Cooling and Lubrication , 2016 .

[32]  A. Abdel-azim.  Fundamentals of Heat and Mass Transfer , 2011 .

[33]  A. Koşar,et al.  Thermal-hydraulic performance of MEMS-based pin fin heat sink , 2006 .

[34]  Rahman Saidur,et al.  Investigating the Heat Transfer Performance and Thermophysical Properties of Nanofluids in a Circular Micro-channel , 2013 .

[35]  S. Chou,et al.  Enhanced Thermal Transport in Microchannel Using Oblique Fins , 2012 .

[36]  Palani Sivashanmugam,et al.  Heat transfer and pressure drop studies in a circular tube fitted with straight full twist , 2009 .