Numerical investigation of entropy generation in a parabolic trough receiver at different concentration ratios

This paper presents results of a numerical analysis of entropy generation in a parabolic trough receiver at different concentration ratios, inlet temperatures and flow rates. Using temperature dependent thermal properties of the heat transfer fluid, the entropy generation due to heat transfer across a finite temperature difference and entropy generation due to fluid friction in the receiver has been determined. Results show a reduction in the entropy generation rate as the inlet temperature increases and an increase in the entropy generation rate as the concentration ratio increases. Results further show that, there is an optimal flow rate at which the entropy generated is a minimum, for every combination of concentration ratio and inlet temperature. The optimal flow rates at which the entropy generated is minimum are presented for different flow rate and concentration ratio, and the results are the same irrespective of the inlet temperature considered. For the range of inlet temperatures, flow rates and concentration ratios considered, the Bejan number, which measures the contribution of entropy generation due to heat transfer irreversibility to the total entropy generation rate is about 1 at low flow rates and is between 0 and 0.24 at the highest flow rate.

[1]  Daniel M. Blake,et al.  Mechanism of Hydrogen Formation in Solar Parabolic Trough Receivers , 2008 .

[2]  Graham L. Morrison,et al.  Optimization of parabolic trough solar collector system , 2006 .

[3]  Josua P. Meyer,et al.  Operating conditions of an open and direct solar thermal Brayton cycle with optimised cavity receive , 2011 .

[4]  Todd A. Jankowski,et al.  Minimizing entropy generation in internal flows by adjusting the shape of the cross-section , 2009 .

[5]  Naser Sahiti,et al.  Entropy generation minimization of a double-pipe pin fin heat exchanger , 2008 .

[6]  Josua P. Meyer,et al.  Thermodynamic optimisation of the integrated design of a small‐scale solar thermal Brayton cycle , 2012 .

[7]  Weeratunge Malalasekera,et al.  An introduction to computational fluid dynamics - the finite volume method , 2007 .

[8]  Roydon Andrew Fraser,et al.  Flow, thermal, and entropy generation characteristics inside a porous channel with viscous dissipation , 2005 .

[9]  Eckhard Lüpfert,et al.  Advances in Parabolic Trough Solar Power Technology , 2002 .

[10]  Markus Eck,et al.  Determination of temperature distribution on parabolic trough receivers , 2006 .

[11]  Josua P. Meyer,et al.  Minimum entropy generation due to heat transfer and fluid friction in a parabolic trough receiver with non-uniform heat flux at different rim angles and concentration ratios , 2014 .

[12]  K. R. Kumar,et al.  Thermal analysis of solar parabolic trough with porous disc receiver , 2009 .

[13]  Eckhard Lüpfert,et al.  Experimental Analysis of Overall Thermal Properties of Parabolic Trough Receivers , 2008 .

[14]  Timothy A. Moss,et al.  Field Survey of Parabolic Trough Receiver Thermal Performance , 2006 .

[15]  V. Dudley,et al.  Test results, Industrial Solar Technology parabolic trough solar collector , 1995 .

[16]  T. H. Ko,et al.  A numerical study on entropy generation induced by turbulent forced convection in curved rectangular ducts with various aspect ratios , 2009 .

[17]  A. Bejan.  Entropy Generation Minimization: The Method of Thermodynamic Optimization of Finite-Size Systems and Finite-Time Processes , 1995 .

[18]  C. Kutscher,et al.  Heat-Loss Testing of Solel's UVAC3 Parabolic Trough Receiver , 2008 .

[19]  S. Kalogirou.  Solar Energy Engineering: Processes and Systems , 2009 .

[20]  Heinz Herwig,et al.  Entropy generation minimization in turbulent mixed convection flows , 2007 .

[21]  Ya-Ling He,et al.  A MCRT and FVM coupled simulation method for energy conversion process in parabolic trough solar collector , 2011 .

[22]  N. Parlak,et al.  Second law analysis of water flow through smooth microtubes under adiabatic conditions , 2011 .

[23]  Jun Wang,et al.  An optimized model and test of the China’s first high temperature parabolic trough solar receiver , 2010 .

[24]  Hal Gurgenci,et al.  Heat transfer and entropy generation optimization of forced convection in porous-saturated ducts of rectangular cross-section , 2007 .

[25]  A. A. Ozalp,et al.  Entropy analysis of laminar-forced convection in a pipe with wall roughness , 2009 .

[26]  D. Kearney,et al.  Test results: SEGS LS-2 solar collector , 1994 .

[27]  Ahmet Z. Sahin,et al.  Irreversibilities in various duct geometries with constant wall heat flux and laminar flow , 1998 .

[28]  M.R.H. Nobari,et al.  A numerical investigation of entropy generation in the entrance region of curved pipes at constant w , 2011 .

[29]  H. Herwig,et al.  Direct and indirect methods of calculating entropy generation rates in turbulent convective heat transfer problems , 2006 .

[30]  D. Spalding,et al.  A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flows , 1972 .

[31]  Josua P. Meyer,et al.  Thermodynamic optimisation and computational analysis of irreversibilities in a small-scale wood-fired circulating fluidised bed adiabatic combustor , 2014 .

[32]  Yu Qiu,et al.  A detailed nonuniform thermal model of a parabolic trough solar receiver with two halves and two inactive ends , 2015 .

[33]  A. Bejan.  A Study of Entropy Generation in Fundamental Convective Heat Transfer , 1979 .

[34]  Josua P. Meyer,et al.  Optimum performance of the small-scale open and direct solar thermal Brayton cycle at various environmental conditions and constraints☆ , 2012 .

[35]  H. Herwig,et al.  Local entropy production in turbulent shear flows: a high-Reynolds number model with wall functions , 2004 .

[36]  Henry Price,et al.  Reducing the Cost of Energy From Parabolic Trough Solar Power Plants , 2003 .

[37]  J. Muñoz,et al.  Analysis of internal helically finned tubes for parabolic trough design by CFD tools , 2011 .

[38]  A. S. Hegazy.  Thermal performance of a parabolic trough collector with a longitudinal externally finned absorber , 1995 .

[39]  K. Ravi Kumar,et al.  Numerical Investigation of Energy-Efficient Receiver for Solar Parabolic Trough Concentrator , 2008 .

[40]  Hongguang Jin,et al.  Experimental investigation on a parabolic trough solar collector for thermal power generation , 2010 .

[41]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[42]  R. Forristall,et al.  Heat Transfer Analysis and Modeling of a Parabolic Trough Solar Receiver Implemented in Engineering Equation Solver , 2003 .

[43]  Yong Gao,et al.  A semantic geographical knowledge wiki system mashed up with Google Maps , 2010 .

[44]  J. Meyer,et al.  Heat transfer and thermodynamic performance of a parabolic trough receiver with centrally placed perforated plate inserts , 2014 .

[45]  H. Oztop,et al.  An analysis of entropy generation through a circular duct with different shaped longitudinal fins for laminar flow , 2005 .

[46]  Bengt Sundén,et al.  Effect of aspect ratio on entropy generation in a rectangular cavity with differentially heated vertical walls , 2008 .