Squeeze film damping and stiffening in circular CMUT with air-filled cavity: Influence of the lateral venting boundary conditions and the bias voltage

The present paper deals with the analysis of the squeeze film effects in circular capacitive micromachined ultrasound transducers (CMUT) operating in air, with emphasis on improved bandwidth. Firstly, a 1D analytical approach based on parallel plate approximation is recalled. The opposing influences of the electrostatic softening and the squeeze film stiffening make the resonant frequency dependent on the bias voltage with respect to air spring constant to mechanical spring constant ratio. In a second part, FEM models using COMSOL Multiphysics® are built to analyze the influences of the plate flexibility and the lateral venting boundary conditions on the squeeze film effects. The associated numerical results show that viscous losses are involved in sealed air-filled cavities. Moreover, the dimensionless elastic and viscous damping forces do not depend on the lateral venting boundary conditions for high squeeze number range, usual for CMUT operation. Finally, 2D full coupled simulations of flexible CMUT are compared with experimental data. Thus, the squeeze film damping increases bandwidth of air-coupled CMUTs with both sealed and laterally vented cavities.

[1]  M. Kupnik,et al.  CMUTs for air coupled ultrasound with improved bandwidth , 2011, 2011 IEEE International Ultrasonics Symposium.

[2]  T. Veijola,et al.  Equivalent-circuit model of the squeezed gas film in a silicon accelerometer , 1995 .

[3]  F. Levent Degertekin,et al.  A nonlinear lumped model for ultrasound systems using CMUT arrays , 2015, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control.

[4]  Kwan Kyu Park,et al.  Finite element analysis of CMUTs with pressurized cavities , 2012, 2012 IEEE International Ultrasonics Symposium.

[5]  Kevin C. Boyle,et al.  Non-contact thermoacoustic detection of embedded targets using airborne-capacitive micromachined ultrasonic transducers , 2015 .

[6]  Abdullah Atalar,et al.  Designing transmitting CMUT cells for airborne applications , 2014, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control.

[7]  H. Koymen,et al.  Equivalent circuit-based analysis of CMUT cell dynamics in arrays , 2013, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[8]  O. Oralkan,et al.  Optimum design of circular CMUT membranes for high quality factor in air , 2008, 2008 IEEE Ultrasonics Symposium.

[9]  Stephen Pessiki,et al.  Resonant capacitive MEMS acoustic emission transducers , 2006 .

[10]  S. Jennings,et al.  The mean free path in air , 1988 .

[11]  B.T. Khuri-Yakub,et al.  Calculation and measurement of electromechanical coupling coefficient of capacitive micromachined ultrasonic transducers , 2003, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[12]  Omer Oralkan,et al.  Capacitive micromachined ultrasonic transducers for medical imaging and therapy , 2011, Journal of micromechanics and microengineering : structures, devices, and systems.

[13]  Giosue Caliano,et al.  An accurate model for capacitive micromachined ultrasonic transducers , 2002, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[14]  Kwan Kyu Park,et al.  Bandwidth and sensitivity optimization in CMUTs for airborne applications , 2014, 2014 IEEE International Ultrasonics Symposium.

[15]  Maurice Beck,et al.  Correlation in instruments: cross correlation flowmeters , 1981 .

[16]  Kwan Kyu Park,et al.  3-D airborne ultrasound synthetic aperture imaging based on capacitive micromachined ultrasonic transducers. , 2013, Ultrasonics.

[17]  R. Pratap,et al.  Analytical Evaluation of Squeeze Film Forces in a CMUT With Sealed Air-Filled Cavity , 2011, IEEE Sensors Journal.

[18]  William M. D. Wright,et al.  A tethered front-plate electrode CMUT for broadband air-coupled ultrasound , 2013, 2013 IEEE International Ultrasonics Symposium (IUS).

[19]  Mohan D. Rao,et al.  Analytical modeling of squeeze film damping for rectangular elastic plates using Green's functions , 2010 .

[20]  J. J. Blech On Isothermal Squeeze Films , 1983 .

[21]  W. Wright,et al.  Improving the bandwidth of air coupled capacitive ultrasonic transducers using selective networks , 2008, 2008 IEEE Ultrasonics Symposium.

[22]  M. Bellaredj,et al.  Anodic bonding using SOI wafer for fabrication of capacitive micromachined ultrasonic transducers , 2014 .

[23]  I. B. Crandall The Air-Damped Vibrating System: Theoretical Calibration of the Condenser Transmitter , 1918 .

[24]  D. Certon,et al.  A multiscale model for array of capacitive micromachined ultrasonic transducers. , 2010, The Journal of the Acoustical Society of America.

[25]  B.T. Khuri-Yakub,et al.  Analytically calculating membrane displacement and the equivalent circuit model of a circular CMUT cell , 2008, 2008 IEEE Ultrasonics Symposium.

[26]  F. Teston,et al.  Fast time-domain modeling of fluid-coupled cMUT cells: from the single cell to the 1-D linear array element , 2013, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control.

[27]  Dong-Kyun Kim,et al.  Performance and reliability of new CMUT design with improved efficiency , 2013 .

[28]  Robert B. Darling,et al.  Compact analytical modeling of squeeze film damping with arbitrary venting conditions using a Green's function approach , 1998 .

[29]  Hohyun Lee,et al.  Enhanced thermoelectric figure of merit in nanostructured n-type silicon germanium bulk alloy , 2008 .

[30]  Abdullah Atalar,et al.  Bilateral CMUT Cells and Arrays: Equivalent Circuits, Diffraction Constants, and Substrate Impedance , 2017, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control.

[31]  A. S. Savoia,et al.  A CMUT probe for medical ultrasonography: from microfabrication to system integration , 2012, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[32]  S. G. Sweeney Improving the Bandwidth of Air Coupled Capacitive Ultrasonic Transducers Using Selective Networks , 2009 .

[33]  Minhang Bao,et al.  Squeeze film air damping in MEMS , 2007 .

[34]  F. Teston,et al.  A finite difference model For cMUT devices , 2005, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.