Design and Characterization of 60-GHz Integrated Lens Antennas Fabricated Through Ceramic Stereolithography

Three integrated lens antennas made in Alumina and built through ceramic stereolithography are designed, fabricated and characterized experimentally in the 60-GHz band. Linear corrugations are integrated on the lens surface to reduce the effects of multiple internal reflections and improve the antenna performance. The lenses are excited by Alumina-filled WR-15 waveguides with an optimized dielectric impedance matching taper in E-plane. The main characteristics of the first two prototypes with corrugations of variable size are compared to those of a smooth lens without corrugation (third prototype). Experimentally their reflection coefficient is smaller than -10 dB between 55 GHz and 65 GHz, and their radiation characteristics (main beam, side lobe level, cross-polarization level) are very stable versus frequency. In particular, at the center frequency (60 GHz), the total antenna loss (including feed loss) is smaller than 0.9 dB and the radiation efficiency exceeds 80%.

[1]  Bernard Jecko,et al.  New kind of microstrip antenna: the monopolar wire-patch antenna , 1994 .

[2]  S. Delage,et al.  Narrow Ka Bandpass Filters Made Of High Permittivity Ceramic By Layer-By-Layer Polymer Stereolithography , 2006, 2006 European Microwave Conference.

[3]  R. Sauleau,et al.  Very Broadband Extended Hemispherical Lenses: Role of Matching Layers for Bandwidth Enlargement , 2009, IEEE Transactions on Antennas and Propagation.

[4]  Junji Yamauchi,et al.  Singly-fed patch antenna radiating a circularly polarised conical beam , 1990 .

[5]  L. Le Coq,et al.  Compact Ka-Band Lens Antennas for LEO Satellites , 2008, IEEE Transactions on Antennas and Propagation.

[6]  J. M. Fernández,et al.  Circularly polarized omnidirectional millimeter wave monopole with parasitic strip elements , 2007 .

[7]  Peter S. Excell,et al.  New circularly-polarised conical-beam microstrip patch antenna array for short-range communication systems , 2009 .

[8]  L. Le Coq,et al.  Optimization of Reduced-Size Smooth-Walled Conical Horns Using BoR-FDTD and Genetic Algorithm , 2010, IEEE Transactions on Antennas and Propagation.

[9]  D. L. Wu,et al.  Omnidirectional circularly-polarized conformal microstrip array for telemetry applications , 1995, IEEE Antennas and Propagation Society International Symposium. 1995 Digest.

[10]  Kin‐Lu Wong,et al.  Reconfigurable Square-Ring Patch Antenna With Pattern Diversity , 2007, IEEE Transactions on Antennas and Propagation.

[11]  Peter S. Excell,et al.  A new design of horizontally polarizedand dual-polarized uniplanar conical beam antennas for HIPERLAN , 2003 .

[12]  D. Baillargeat,et al.  Ceramic Layer-By-Layer Stereolithography for the Manufacturing of 3-D Millimeter-Wave Filters , 2007, IEEE Transactions on Microwave Theory and Techniques.

[13]  Linda P. B. Katehi,et al.  MEMS and Si micromachined circuits for high-frequency applications , 2002 .

[14]  R. Sauleau,et al.  Performance of reduced size substrate lens antennas for Millimeter-wave communications , 2005, IEEE Transactions on Antennas and Propagation.

[15]  W.Y. Liu,et al.  Membrane-supported CPW with mounted active devices , 2001, IEEE Microwave and Wireless Components Letters.

[16]  Yang Hao,et al.  Directive millimetrewave antennas using freeformed ceramic metamaterials in planar and cylindrical forms , 2008, 2008 IEEE Antennas and Propagation Society International Symposium.

[17]  Dominique Baillargeat,et al.  Fabrication of Millimeter Wave Components Via Ceramic Stereo- and Microstereolithography Processes , 2008 .

[18]  Gabriel M. Rebeiz,et al.  Double-slot antennas on extended hemispherical dielectric lenses , 1992 .

[19]  R. Sauleau,et al.  Design and Optimization of Three-Dimensional Integrated Lens Antennas With Genetic Algorithm , 2007, IEEE Transactions on Antennas and Propagation.

[20]  S. Maci,et al.  High-frequency analysis of integrated dielectric lens antennas , 2004, IEEE Transactions on Antennas and Propagation.

[21]  Hiroyuki Fujita,et al.  Polydimethylsiloxane membranes for millimeter-wave planar ultra flexible antennas , 2006 .

[22]  P. Maagt,et al.  Effect of internal reflections on the radiation properties and input impedance of integrated lens antennas-comparison between theory and measurements , 2001 .

[23]  J. Takada,et al.  Circularly polarised conical beam radial line slot antenna , 1994 .

[24]  W.J. Chappell,et al.  Applications of layer-by-layer polymer stereolithography for three-dimensional high-frequency components , 2004, IEEE Transactions on Microwave Theory and Techniques.

[25]  K. Luk,et al.  A wideband circularly polarized conical-beam patch antenna , 2006, IEEE Transactions on Antennas and Propagation.

[26]  K. Sarabandi,et al.  Design of 3-D Monolithic MMW Antennas Using Ceramic Stereolithography , 2007, IEEE Transactions on Antennas and Propagation.

[27]  G.V. Eleftheriades,et al.  Design and characterization of single and multiple beam MM-wave circularly polarized substrate lens antennas for wireless communications , 1999, IEEE Antennas and Propagation Society International Symposium. 1999 Digest. Held in conjunction with: USNC/URSI National Radio Science Meeting (Cat. No.99CH37010).

[28]  Kin-Lu Wong,et al.  A low-profile omnidirectional circularly polarized antenna for WLAN access point , 2004 .

[29]  George V. Eleftheriades,et al.  Design and characterization of single and multiple beam MM-wave circularly polarized substrate lens antennas for wireless communications , 1999, IEEE Antennas and Propagation Society International Symposium. 1999 Digest. Held in conjunction with: USNC/URSI National Radio Science Meeting (Cat. No.99CH37010).

[30]  A. Mortazawi,et al.  A compact millimeter-wave horn antenna array fabricated through layer-by-layer stereolithography , 2008, 2008 IEEE Antennas and Propagation Society International Symposium.

[31]  R. Sauleau,et al.  A complete procedure for the design and optimization of arbitrarily shaped integrated lens antennas , 2006, IEEE Transactions on Antennas and Propagation.

[32]  Kenichi Sato,et al.  A plate Luneberg lens with the permittivity distribution controlled by hole density , 2001 .

[33]  A. Rolland,et al.  Assessment of FDTD Accuracy in the Compact Hemielliptic Dielectric Lens Antenna Analysis , 2008, IEEE Transactions on Antennas and Propagation.

[34]  Aleksandar Nesic,et al.  Circularly polarised printed antenna with conical beam , 1998 .

[35]  Yang Hao,et al.  Fabrication of electromagnetic crystals by extrusion freeforming , 2008 .

[36]  Junji Yamauchi,et al.  A low-profile conical beam loop antenna with an electromagnetically coupled feed system , 2000 .

[37]  H. Kawakami,et al.  Research on circularly polarized conical-beam antennas , 1997 .

[38]  Integration of single-mode photonic crystal waveguides to monolithic MMW subsystems constructed using ceramic stereolithography , 2007, 2007 IEEE Antennas and Propagation Society International Symposium.

[39]  R. Sauleau,et al.  Electrically-Small Shaped Integrated Lens Antennas: A Study of Feasibility in $Q$-Band , 2007, IEEE Transactions on Antennas and Propagation.

[40]  R. Sauleau,et al.  A new accurate design method for millimeter-wave homogeneous dielectric substrate lens antennas of arbitrary shape , 2005, IEEE Transactions on Antennas and Propagation.

[41]  J. Huang,et al.  Circularly polarized conical patterns from circular microstrip antennas , 1984 .

[42]  Kin-Lu Wong,et al.  A broadband low-profile cylindrical monopole antenna top loaded with a shorted cross patch , 2002 .

[43]  R. Sauleau,et al.  Small Hemielliptic Dielectric Lens Antenna Analysis in 2-D: Boundary Integral Equations Versus Geometrical and Physical Optics , 2008, IEEE Transactions on Antennas and Propagation.

[44]  N. Alford,et al.  Sintered alumina with low dielectric loss , 1996 .