A new model based on experimental results for the thermal characterization of bricks

Abstract The development of fast and reliable protocols to determine the characteristics of building materials is of importance in order to develop environmentally friendly houses with an efficient energy design. In this article heat flux evolution on different types of clay and concrete bricks has been studied using a guarded hot-plate. The studied bricks were purchased from local commercially available sources and included a solid face brick and a range of honeycombed and perforated bricks. From the data collected a new model to study heat flux is proposed. This model is based on the shape of the typical sigmoidal curves observed for the time dependent heat flux evolution. The model allows the calculation of the thermal resistance (R) and the heat flux in the steady-state (φ∞). The model also calculates two new parameters, tB and τB. tB represents the time at which half φ∞ is attained. This parameter (tB) has additionally been found to be dependent on the thermal diffusivity and the geometric characteristics of the brick.

[1]  P. J. García Nieto,et al.  Non-linear thermal analysis of light concrete hollow brick walls by the finite element method and experimental validation , 2006 .

[2]  P. T. Tsilingiris,et al.  Thermal flywheel effects on the time varying conduction heat transfer through structural walls , 2003 .

[3]  Abdelkarim Aït-Mokhtar,et al.  Measurement of thermal conductivity, thermal diffusivity and heat capacity of highly porous building materials using transient plane source technique , 2001 .

[4]  P. J. García Nieto,et al.  Nonlinear thermal optimization of external light concrete multi-holed brick walls by the finite element method , 2008 .

[5]  Constantinos A. Balaras,et al.  Heating energy consumption and resulting environmental impact of European apartment buildings , 2005 .

[6]  Thomas Boermans,et al.  Mitigation of CO2 Emissions from the EU-15 Building Stock. Beyond the EU Directive on the Energy Performance of Buildings (9 pp) , 2006 .

[7]  Jean Castaing-Lasvignottes,et al.  Second law analysis of periodic heat conduction through a wall , 2005 .

[8]  Constantinos A. Balaras,et al.  Potential for energy conservation in apartment buildings , 2000 .

[9]  P. J. García Nieto,et al.  Non-linear thermal optimization and design improvement of a new internal light concrete multi-holed brick walls by FEM , 2008 .

[10]  J. Saastamoinen.  Unsteady state temperature fields in a slab induced by line sources , 2007 .

[11]  Robert R. Zarr,et al.  A History of Testing Heat Insulators at the National Institute of Standards and Technology , 2001 .

[12]  Paki Turgut,et al.  A simple dynamic measurement technique for comparing thermal insulation performances of anisotropic building materials , 2007 .

[13]  Stephen Pessiki,et al.  Thermal performance evaluation of precast concrete three-wythe sandwich wall panels , 2006 .

[14]  Toshimitsu Hata,et al.  Thermal constants of wood during the heating process measured with the laser flash method , 1998, Journal of Wood Science.

[15]  P. J. García Nieto,et al.  Analysis and optimization of the heat-insulating light concrete hollow brick walls design by the finite element method , 2007 .

[16]  Philippe Girard,et al.  Thermophysical characterisation of tropical wood used as building materials: With respect to the basal density , 2006 .

[17]  Lei Li,et al.  Numerical thermal optimization of the configuration of multi-holed clay bricks used for constructing building walls by the finite volume method , 2008 .

[18]  G. León,et al.  Thermal characterization of pine wood by photoacoustic and photothermal techniques , 2000, Holz als Roh- und Werkstoff.

[19]  Ya Feng,et al.  Thermal design standards for energy efficiency of residential buildings in hot summer/cold winter zones , 2004 .