A Nonresonant Self-Synchronizing Inductively Coupled 0.18- $\mu $ m CMOS Power Receiver and Charger

While the functionality of emerging wireless microsensors, cellular phones, and biomedical implants, to name a few, is on the rise, their dimensions continue to shrink. This is unfortunate because smaller batteries exhaust quicker. Not surprisingly, recharging batteries wirelessly is becoming increasingly popular today. Still, small pickup coils cannot harness much, so induced EMF voltages vEMF.S are low. Modern receivers can resonate these low input voltages to rectifiable levels, but only with a finely tuned capacitor that resonates at megahertz when on-chip and at kilohertz when off-chip. In other words, resonant rectifiers are sensitive to frequency and dissipate considerable switching power when integrated on-chip. Unluckily, excluding the resonant capacitor requires a control signal that synchronizes switching events to the transmitter's operating frequency. The 0.18-μm CMOS prototype presented here derives this synchronizing signal from the coupled vEMF.S by counting the number of pulses of a higher-frequency clock across a half cycle during a calibration phase and using that number to forecast half-cycle crossings. This way, the prototyped IC switches every half cycle to draw up to 557 μW from 46.6 to 585-mVPK signals with 38%-84% efficiency across 1.0-5.0 cm.

[1]  Rahul Sarpeshkar,et al.  Feedback Analysis and Design of RF Power Links for Low-Power Bionic Systems , 2007, IEEE Transactions on Biomedical Circuits and Systems.

[2]  Gabriel A. Rincón-Mora,et al.  180-nm CMOS Wideband Capacitor-Free Inductively Coupled Power Receiver and Charger , 2013, IEEE Journal of Solid-State Circuits.

[3]  Frederick Warren Grover,et al.  Inductance Calculations: Working Formulas and Tables , 1981 .

[4]  Tadahiro Kuroda,et al.  1W 3.3V-to-16.3V boosting wireless power transfer circuits with vector summing power controller , 2011, IEEE Asian Solid-State Circuits Conference 2011.

[5]  G.A. Covic,et al.  Self tuning pick-ups for inductive power transfer , 2008, 2008 IEEE Power Electronics Specialists Conference.

[6]  Orlando Lazaro,et al.  Increasing Electrical Damping in Energy-Harnessing Transducers , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[7]  Shuenn-Yuh Lee,et al.  A Low-Power 13.56 MHz RF Front-End Circuit for Implantable Biomedical Devices , 2013, IEEE Transactions on Biomedical Circuits and Systems.

[8]  Milan M. Jovanovic,et al.  A contactless electrical energy transmission system for portable-telephone battery chargers , 2003, IEEE Trans. Ind. Electron..

[9]  Kristofer S. J. Pister,et al.  SoC Issues for RF Smart Dust , 2006, Proceedings of the IEEE.

[10]  Chi-Ying Tsui,et al.  A 13.56MHz fully integrated 1X/2X active rectifier with compensated bias current for inductively powered devices , 2013, 2013 IEEE International Solid-State Circuits Conference Digest of Technical Papers.

[11]  Pengfei Li,et al.  A Wireless Power Interface for Rechargeable Battery Operated Medical Implants , 2007, IEEE Transactions on Circuits and Systems II: Express Briefs.

[12]  Maysam Ghovanloo,et al.  An adaptive reconfigurable active voltage doubler/rectifier for extended-range inductive power transmission , 2012, 2012 IEEE International Solid-State Circuits Conference.

[13]  Gert Cauwenberghs,et al.  Power harvesting and telemetry in CMOS for implanted devices , 2004, IEEE Transactions on Circuits and Systems I: Regular Papers.

[14]  Robert Puers,et al.  Inductive Powering: Basic Theory and Application to Biomedical Systems , 2009 .

[15]  P. Glenn Gulak,et al.  Maximum Achievable Efficiency in Near-Field Coupled Power-Transfer Systems , 2012, IEEE Transactions on Biomedical Circuits and Systems.

[16]  Elena A. Lomonova,et al.  Contactless energy transfer , 2011 .

[17]  David Blaauw,et al.  Circuit Design Advances for Wireless Sensing Applications , 2010, Proceedings of the IEEE.

[18]  Seulki Lee,et al.  A 5.2 mW Self-Configured Wearable Body Sensor Network Controller and a 12 $\mu$ W Wirelessly Powered Sensor for a Continuous Health Monitoring System , 2010, IEEE Journal of Solid-State Circuits.

[19]  Aiguo Patrick Hu,et al.  Optimal coupling condition of IPT system for achieving maximum power transfer , 2009 .

[20]  Tadahiro Kuroda,et al.  A 0.025–0.45 W 60%-Efficiency Inductive-Coupling Power Transceiver With 5-Bit Dual-Frequency Feedforward Control for Non-Contact Memory Cards , 2012, IEEE Journal of Solid-State Circuits.

[21]  Robert Puers,et al.  Omnidirectional Inductive Powering for Biomedical Implants , 2008 .

[22]  Maysam Ghovanloo,et al.  An Adaptive Reconfigurable Active Voltage Doubler/Rectifier for Extended-Range Inductive Power Transmission , 2012, IEEE Transactions on Circuits and Systems II: Express Briefs.

[23]  Maysam Ghovanloo,et al.  An Integrated Power-Efficient Active Rectifier With Offset-Controlled High Speed Comparators for Inductively Powered Applications , 2011, IEEE Transactions on Circuits and Systems I: Regular Papers.

[24]  David Blaauw,et al.  A cubic-millimeter energy-autonomous wireless intraocular pressure monitor , 2011, 2011 IEEE International Solid-State Circuits Conference.

[25]  Gyu-Hyeong Cho,et al.  A resonant regulating rectifier (3R) operating at 6.78 MHz for a 6W wireless charger with 86% efficiency , 2013, 2013 IEEE International Solid-State Circuits Conference Digest of Technical Papers.

[26]  Tadahiro Kuroda,et al.  1-W 3.3–16.3-V Boosting Wireless Power Transfer Circuits With Vector Summing Power Controller , 2012, IEEE Journal of Solid-State Circuits.

[27]  Orlando Lazaro,et al.  Inductively Coupled 180-nm CMOS Charger With Adjustable Energy-Investment Capability , 2013, IEEE Transactions on Circuits and Systems II: Express Briefs.