论文信息 - Blue light emitting diode internal and injection efficiency

Blue light emitting diode internal and injection efficiency

A simple experimental method of light emitting diode (LED) injection efficiency (IE) determination was suggested. IE and internal quantum efficiency (IQE) calculation is an actual and difficult problem in LED science. In this paper IE and IQE of blue LEDs were determined separately. The method is based on electroluminescence data fitting by the modified rate equation model. Efficiency droop caused by Auger recombination and poor injection were taken into account. Only one reasonable assumption was accepted during the calculations: IE tends to 1 at low current densities.

[1] Han-Youl Ryu,et al. Rate equation analysis of efficiency droop in InGaN light-emitting diodes , 2009 .

[2] Lai Wang,et al. Study on Injection Efficiency in InGaN/GaN Multiple Quantum Wells Blue Light Emitting Diodes , 2008 .

[3] Xing Li,et al. GaN-Based Light-Emitting Diodes: Efficiency at High Injection Levels , 2010, Proceedings of the IEEE.

[4] Georgy G. Zegrya,et al. Auger recombination in semiconductor quantum wells , 1998 .

[5] K. Streubel,et al. Status of high efficiency and high power ThinGaN®‐LED development , 2009 .

[6] R. I. Gorbunov,et al. Effect of the joule heating on the quantum efficiency and choice of thermal conditions for high-power blue InGaN/GaN LEDs , 2006 .

[7] Michael R. Krames,et al. Carrier distribution in (0001)InGaN∕GaN multiple quantum well light-emitting diodes , 2008 .

[8] B. Hahn,et al. High-Power and High-Efficiency InGaN-Based Light Emitters , 2010, IEEE Transactions on Electron Devices.

[9] D. A. Zakheim,et al. Analysis of the causes of the decrease in the electroluminescence efficiency of AlGaInN light-emitting-diode heterostructures at high pumping density , 2006 .

[10] Tobias Meyer,et al. New developments in green LEDs , 2009 .

[11] Ronald A. Arif,et al. Current injection efficiency induced efficiency-droop in InGaN quantum well light-emitting diodes , 2010, DRC 2010.