论文信息 - Calculation of the rolling pressure distribution and force in wire flat rolling process

Calculation of the rolling pressure distribution and force in wire flat rolling process

Abstract In this study a slab analysis is developed to predict the rolling pressure distribution and rolling force in the wire flat rolling process. In the slab analysis the variations of width of contact area between the rolls and wire during rolling is considered. Two differential equations are derived and solved using a modified Eulerian numerical method. The effects of friction coefficient, reduction in height and yield stress of wire on the rolling pressure distribution and rolling force are assessed. It is found that in the flat rolling of wire, there exists a maximum in the pressure distribution similar to that of the strip rolling process. Also, the effects of friction coefficient, reduction in height and yield stress on the neutral angle are investigated. It is observed that by increasing the reduction in height and friction coefficient, the neutral angle is increased and the yield stress has no effect on the neutral angle. A good agreement is found between the calculated and measured rolling force.

Mohsen Kazeminezhad | A. Karimi Taheri | A. Taheri | M. Kazeminezhad

[1] R. B. Sims. The Calculation of Roll Force and Torque in Hot Rolling Mills , 1954 .

[2] Mohsen Kazeminezhad,et al. A theoretical and experimental investigation on wire flat rolling process using deformation pattern , 2005 .

[3] Betzalel Avitzur. An Upper-Bound Approach to Cold-Strip Rolling , 1964 .

[4] Hugh Ford,et al. The Calculation of Roll Force and Torque in Cold Strip Rolling with Tensions , 1948 .

[5] Roumen Iankov,et al. Finite element simulation of profile rolling of wire , 2003 .

[6] G. Rowe. An introduction to the principles of metalworking , 1965 .

[7] T. C. Firbank,et al. A suggested slip-line field for cold rolling with slipping friction , 1965 .

[8] Robert E. Johnson. Shape forming and lateral spread in sheet rolling , 1991 .

[9] Zb. Pater,et al. Determination of the contact area between the rolling tools and the workpiece in cross rolling process , 1994 .

[10] Mohsen Kazeminezhad,et al. An experimental investigation on the deformation behavior during wire flat rolling process , 2005 .

[11] Terry Sheppard,et al. Parameters affecting lateral deformation in slabbing mills , 1981 .

[12] Björn Carlsson,et al. The contact pressure distribution in flat rolling of wire , 1998 .

[13] E. Orowan,et al. The Calculation of Roll Pressure in Hot and Cold Flat Rolling , 1943 .