The automatic control of boundary-layer transition : experiments and computation

In recent years there has been an increasing interest in the control of boundary-layer transition through the use of wall suction. In the current work suction is provided through one or more suction panels situated close to the leading edge of a plate. Experiments show that boundary-layer pressure fluctuation measurements can be used to identify the position of transition. Transition can be maintained at a desired location with minimum power consumption by employing an automatic adaptive feedback control loop which regulates the suction flow rates of two independent suction panels. This can be expressed as a constrained optimization problem. To allow the suction flow rates to be updated, a modified least mean squares algorithm is used within the control loop. Experimental measurements show that the control algorithm allows fast and stable convergence towards the optimum suction distribution for a double suction panel configuration. Numerical simulations have also been performed. The two-dimensional boundary layer was calculated allowing the viscous boundary layer to interact with the inviscid outer flow. Following linear stability theory the spatial growth rates are calculated by solving an Orr-Sommerfeld type eigenvalue problem, with the streamwise location of transition predicted via theeN -method. Applying the same optimization strategy as in the experiments, good qualitative agreement between computations and experiments was found. The optimization algorithm has been applied to computer models where the relation between suction flow rates and transition location is described by an empirical analytical function. This shows that the controller can in principle be applied to systems with more than two suction panels.