Effect of strain ageing on the mechanical properties of partially damaged structural mild steel

Abstract This paper addresses the strain ageing effects on the mechanical properties of the partially damaged structural mild steel. Since repairing partly damaged structures may not occur immediately, the strain ageing effect can significantly influence the structural behaviour. The changes due to this effect have not so far been considered in the civil engineering design guidelines. In order to investigate strain ageing effects, two-stage experimental tests are carried out on the mild-steel specimens. In the first stage, partial damage is made using quasi-static loading. During the second stage, the strength and ductility of the specimens are examined after 2 and 7 days ‘ageing’ at room temperature and the results are compared with the corresponding no-age samples. The microstructure of the specimens is examined using scanning electron microscopy (SEM). To illustrate the effect of strain ageing on the global behaviour of steel structures, a numerical example is provided in which strain ageing impacts on loading capacity and deflection of a steel beam. Finally, the stress–strain relation of partially damaged mild-steel material incorporating strain ageing effects is expressed by calibrating the parameters of Ramberg–Osgood model.

[1]  Robert E. Reed-Hill,et al.  Physical Metallurgy Principles , 1972 .

[2]  Amin Heidarpour,et al.  Mechanical properties of partially damaged structural steel induced by high strain rate loading at elevated temperatures - An experimental investigation , 2015 .

[3]  Berthold Scholtes,et al.  Cyclic stress–strain behavior and damage of tool steel AISI H11 under isothermal and thermal fatigue conditions , 2010 .

[4]  Amin Heidarpour,et al.  Inelastic local buckling of curved plates with or without thickness-tapered sections using finite strip method , 2012 .

[5]  U. F. Kocks,et al.  The strain dependence of static and dynamic strain-aging , 1982 .

[6]  Sven Vandeputte,et al.  Competition between grain boundary segregation and Cottrell atmosphere formation during static strain aging in ultra low carbon bake hardening steels , 2004 .

[7]  M. Weaver,et al.  Activation energy calculations for discontinuous yielding in Inconel 718SPF , 2001 .

[8]  A. Heidarpour,et al.  Local buckling of thin and moderately thick variable thickness viscoelastic composite plates , 2011 .

[9]  Amin Heidarpour,et al.  A multi-objective optimization approach to the parameter determination of constitutive plasticity models for the simulation of multi-phase load histories , 2014 .

[10]  Frédéric Barlat,et al.  Strain rate dependent tensile behavior of advanced high strength steels: Experiment and constitutive modeling , 2013 .

[11]  R. Honeycombe.  Steels, Microstructure and Properties , 1982 .

[12]  B. M. Gonzalez,et al.  Kinetics of strain aging in drawn pearlitic steels , 1998 .

[13]  H. Conrad,et al.  Deformation mechanisms in commercial Ti (0.5 at. pct oineq) at intermediate and high temperatures (0.3 - 0.6 tinm) , 1973 .

[14]  Amin Heidarpour,et al.  Inelastic initial local buckling of skew thin thickness-tapered plates with and without intermediate supports using the isoparametric spline finite strip method , 2011 .

[15]  Amin Heidarpour,et al.  Stress–strain–temperature relation for cyclically-damaged structural mild steel , 2014 .

[16]  Amin Heidarpour,et al.  Beam–column element for non-linear dynamic analysis of steel members subjected to blast loading , 2011 .

[17]  F. Appel,et al.  Strain ageing in γ(TiAl)-based titanium aluminides due to antisite atoms , 2002 .

[18]  O. Bouaziz,et al.  Microstructure based modeling for the mechanical behavior of ferrite–pearlite steels suitable to capture isotropic and kinematic hardening , 2008 .

[19]  D. G. Morris,et al.  Static strain ageing of L12 Al3Ti-based alloys , 1994 .

[20]  C. Schwink,et al.  Characteristics of dynamic strain ageing in binary f.c.c. copper alloys—I. Results on solid solutions of CuAl , 1997 .