Analysis of the thermal environment inside the furnace of a dynamic mechanical analyser

[1]  J. Saja,et al.  Improvement of the measurement process used for the dynamic mechanical characterisation of polyolefin foams in compression , 2001 .

[2]  J. Wolfrum,et al.  Dynamical Mechanical Thermo Analysis of High Performance Composites-Influences and Problems , 2000 .

[3]  I. Krupa,et al.  Thermal lag and its practical consequence in the dynamic mechanical analysis of polymers , 2000 .

[4]  K. Kociba.  Temperature Calibration of TMAs Using Modulated Temperature and Curie Temperature Reference Standards , 2000 .

[5]  P. Lee-Sullivan,et al.  Guidelines for performing storage modulus measurements using the TA Instruments DMA 2980 three-point bend mode. I. Amplitude effects , 2000 .

[6]  J. Mano,et al.  Temperature correction of dynamic mechanical and thermomechanical analysers during heating, cooling and isothermal experiments , 2000 .

[7]  J. Schawe,et al.  Expansion and Shrinkage of Fibers: Load- and temperature modulated TMA measurements temperature calibration of fiber attachments , 2000 .

[8]  J. Mano.  Stress release in oriented HIPS as observed by dynamic mechanical analysis , 1999 .

[9]  S. Canevarolo,et al.  Temperature calibration of a dynamic-mechanical thermal analyser , 1998 .

[10]  畠山 立子,et al.  Thermal Analysis: Fundamentals and Applications to Polymer Science , 1994 .

[11]  R. Seyler,et al.  Temperature Calibration of Thermomechanical Analyzers: Part II—An Interlaboratory Test of the Calibration Procedure , 1992 .

[12]  R. Seyler,et al.  Temperature Calibration of Thermomechanical Analyzers: Part I—The Development of a Standard Method , 1992 .

[13]  T. Leonard,et al.  An investigation into DMTA clamping problems , 1992 .

[14]  J. R. White,et al.  Polymer characterization : physical techniques , 1989 .