A holistic approach to the exploitation of simulation in solid investment casting

Abstract The ultimate aim of casting simulation is to recommend process parameter values that result in the best possible casting quality. However, commercial casting simulation is currently used as a trial-and-error tool, mostly comparing between possible scenarios with no guarantee of realism. Three techniques are presented to overcome these discrepancies for solid investment casting of jewellery as a test bed. The first technique consists in recording temperature versus time profiles by thermocouples embedded in the casting. These profiles are used as calibration reference regarding the overall heat transfer coefficient at the melt-mould interface in simulation. The second technique consists in metallographic validation of simulation findings in terms of correlating microstructure and defects of the casting with simulation results concerning temperature distribution and porosity. The third technique consists in introducing genetic algorithms as an optimization tool. A small number of simulation sample runs link process parameters of interest, such as mould temperature and melt temperature, with results characterizing casting quality, e.g. porosity. These samples are used to train a neural network, thereby creating a generalized meta-model of the process, which is directly used as the fitness function of the genetic algorithm. Combining the three techniques described above caters for realistic and practical casting process planning using commercially available casting simulation software as a tool.

[1]  M. Krishnan,et al.  Determination of the interfacial heat transfer coefficient h in unidirectional heat flow by Beck`s non linear estimation procedure , 1996 .

[2]  Carlos Alexandre dos Santos,et al.  Determination of transient interfacial heat transfer coefficients in chill mold castings , 2001 .

[3]  George-Christopher Vosniakos,et al.  Simulation-based selection of optimum pressure die-casting process parameters using neural nets and genetic algorithms , 2006 .

[4]  W. S. Rapson.  The metallurgy of the coloured carat gold alloys , 1990 .

[5]  Francis K. H. Lau,et al.  A study of the interfacial heat transfer between an iron casting and a metallic mould , 1998 .

[6]  H. M. Hosseini,et al.  Using genetic algorithm and artificial neural network analyses to design an Al–Si casting alloy of minimum porosity , 2006 .

[7]  George-Christopher Vosniakos,et al.  Optimizing feedforward artificial neural network architecture , 2007, Eng. Appl. Artif. Intell..

[8]  Rajesh Ransing,et al.  Casting shape optimisation via process modelling , 2000 .

[9]  Dorothea Heiss-Czedik,et al.  An Introduction to Genetic Algorithms. , 1997, Artificial Life.

[10]  Laurene V. Fausett,et al.  Fundamentals Of Neural Networks , 1994 .

[11]  Aj Norwood,et al.  Analysis of cooling channels performance , 2004, Int. J. Comput. Integr. Manuf..

[12]  David J. Browne,et al.  Use of experiment and an inverse method to study interface heat transfer during solidification in the investment casting process , 2000 .

[13]  N. A. El-Mahallawy,et al.  Estimation of air gap and heat transfer coefficient at different faces of Al and Al–Si castings solidifying in permanent mould , 2001 .

[14]  J. A. Spim,et al.  Metal–mold heat transfer coefficients during horizontal and vertical Unsteady-State solidification of Al–Cu and Sn–Pb Alloys , 2004 .

[15]  Laurene V. Fausett,et al.  Fundamentals Of Neural Networks , 1993 .

[16]  H G Zhang,et al.  Computer Aided Design of Feeders for Castings , 1994 .