Parallel distribution transformer loss reductions: A proposed method and experimental validation

Abstract Transformers in electrical distribution systems for buildings and industries are set up to ensure the continuity of supply. Modern distribution transformers are reaching increasingly higher levels of energy efficiency but contribute to between 16% and 40% of the energy losses associated with electrical distribution systems. This paper examines and proposes a method to reduce losses in transformation systems and thus to reduce the associated emission of greenhouse gases (GHGs). This paper proposes a method of system optimization for transformers in parallel, called Parallel Losses Optimization (PLO), and is applicable to existing or future facilities and is adaptable to any type of transformer system. The method has been validated in 12 real facilities of different power and efficiency levels. Reductions in the losses of the studied transformers were up to 41% with respect to the initial losses. This demonstrates the beneficial operation of the PLO method proposed in this paper in a wide range of existing transformers or for future installations. The research has obtained patent pending status P201101267 in Spain.

[1]  Ieee Standards Board.  IEEE loss evaluation guide for power transformers and reactors , 1992 .

[2]  Johan Driesen,et al.  Reducing losses in distribution transformers , 2002 .

[3]  J. F. Baranowski,et al.  An alternative evaluation of distribution transformers to achieve the lowest TOC , 1991, Proceedings of the 1991 IEEE Power Engineering Society Transmission and Distribution Conference.

[4]  Benoît Iung,et al.  Predictive maintenance in intelligent-control-maintenance-management system for hydroelectric generating unit , 2004 .

[5]  S. Y. Merritt,et al.  No-load versus load loss , 2003 .

[6]  D. F. Binns,et al.  Economic design of a 50 kVA distribution transformer. Part 2: Effect of different core steels and loss capitalisations , 1986 .

[7]  S. D. Sudhoff,et al.  A Power Electronic-Based Distribution Transformer , 2002, IEEE Power Engineering Review.

[8]  Daichi Azuma,et al.  Impacts of amorphous metal-based transformers on energy efficiency and environment , 2008 .

[9]  N. Bianchi,et al.  Rotor Losses Measurements in an Axial Flux Permanent Magnet Machine , 2011, IEEE Transactions on Energy Conversion.

[10]  Pavlos S. Georgilakis.  Differential evolution solution to transformer no-load loss reduction problem , 2009 .

[11]  Prasad Enjeti,et al.  Analysis and design of electronic transformers for electric power distribution system , 1997 .

[12]  Yi-Ming Wei,et al.  An overview of current research on EU ETS: Evidence from its operating mechanism and economic effect , 2010 .

[13]  Koosuke Harada,et al.  Intelligent transformer , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[14]  Tomás Gómez,et al.  Impact of distributed generation on distribution investment deferral , 2006 .

[15]  Pavlos S. Georgilakis.  Decision support system for evaluating transformer investments in the industrial sector , 2007 .

[16]  Michael Kurrat,et al.  Efficient integration of distributed generation for meeting the increased load demand , 2011 .

[17]  Giri Venkataramanan,et al.  Power electronic transformers for utility applications , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[18]  H. Braunstein,et al.  Distribution Transformer Loss Evaluation: I - Proposed Techniques , 1981, IEEE Transactions on Power Apparatus and Systems.

[19]  Paul R. Rasmusson.  Transformer Economic Evaluation , 1984, IEEE Transactions on Industry Applications.

[20]  Paul S Moses,et al.  Dynamic Modeling of Three-Phase Asymmetric Power Transformers With Magnetic Hysteresis: No-Load and Inrush Conditions , 2010, IEEE Transactions on Energy Conversion.

[21]  Nadarajah Mithulananthan,et al.  AN ANALYTICAL APPROACH FOR DG ALLOCATION IN PRIMARY DISTRIBUTION NETWORK , 2006 .

[22]  Guohe Huang,et al.  A two-stage inexact-stochastic programming model for planning carbon dioxide emission trading under uncertainty , 2010 .

[23]  Brian K. Johnson,et al.  An AC-AC power converter for custom power applications , 1996 .

[24]  Sakti Prasad Ghoshal,et al.  Optimal sizing and placement of distributed generation in a network system , 2010 .

[25]  M. Marchesoni,et al.  AC locomotive conversion systems without heavy transformers: is it a practicable solution? , 2002, Industrial Electronics, 2002. ISIE 2002. Proceedings of the 2002 IEEE International Symposium on.

[26]  B. Mathiesen,et al.  100% Renewable energy systems, climate mitigation and economic growth , 2011 .

[27]  Barry W. Kennedy.  Energy Efficient Transformers , 1997 .

[28]  Pavlos S. Georgilakis,et al.  A Review of Transformer Losses , 2009 .

[29]  R. Ramakumar,et al.  An approach to quantify the technical benefits of distributed generation , 2004, IEEE Transactions on Energy Conversion.

[30]  C.J. Nochumson.  Considerations in application and selection of unit substation transformers , 2001, Conference Record of 2001 Annual Pulp and Paper Industry Technical Conference (Cat. No.01CH37209).

[31]  H. Braunstein,et al.  Distribution Transformer Loss Evaluation: II - Load Characteristics and System Cost Parameters , 1981, IEEE Transactions on Power Apparatus and Systems.