Effects of mineral admixtures on the thermal expansion properties of hardened cement paste

Abstract Concrete is a heterogeneous composite material with multiple components that have different thermal expansion properties. Internal stresses are generated if the concrete is rapidly heated or cooled, causing cracking in the micro- or macro-scale. If the coefficient of thermal expansion (CTE) of hardened cement pastes (HCP) is adapted, the thermal stress caused by the mismatch of thermal expansion properties of the components can be mitigated. The effects of the commonly used mineral admixtures (fly ash, ground granulated blast furnace slag and silica fume) on the thermal expansion properties of HCP are investigated. The thermal dilation rates (TDR) of HCP in which Portland cement is partially replaced with mineral admixtures are tested with a dilatometer and the CTE are derived. Replacing Portland cement with mineral admixtures is found to lower the CTE of HCP, which is beneficial for mitigating the thermal mismatch between the HCP and the aggregates. The extent of this lowering effect increases with the increasing replacement proportions of mineral admixtures in the pastes. Through quantitative determination of the porosity and the amount of portlandite in the paste and microscopic observations, it is revealed that the effects of the mineral admixtures are mainly due to the change of the porosity and the amounts of hydration products in the pastes.

[1]  Marta Castellote,et al.  Composition and microstructural changes of cement pastes upon heating, as studied by neutron diffraction , 2004 .

[2]  C. Atiş.  Heat evolution of high-volume fly ash concrete , 2002 .

[3]  S L Meyers,et al.  THERMAL EXPANSION CHARACTERISTICS OF HARDENED CEMENT PASTE AND OF CONCRETE , 1951 .

[4]  R. L. Sharma,et al.  The influence of mineral additives on the strength and porosity of OPC mortar , 2000 .

[5]  C. Alonso,et al.  Dehydration and rehydration processes of cement paste exposed to high temperature environments , 2004 .

[6]  J. Sulem,et al.  The Effect of Undrained Heating on a Fluid-saturated Hardened Cement Paste , 2008, 0810.1810.

[7]  David A Lange,et al.  Thermal dilation and internal relative humidity of hardened cement paste , 2005 .

[8]  Edward B. Roessler,et al.  Introduction to Probability and Statistics , 1961, The Mathematical Gazette.

[9]  Ø. Bjøntegaard,et al.  Coefficient of thermal expansion of cement paste and concrete: Mechanisms of moisture interaction , 2006 .

[10]  L. Daemen,et al.  Anisotropic thermal expansion and hydrogen bonding behavior of portlandite: A high-temperature neutron diffraction study , 2007 .

[11]  S. Agarwal,et al.  Physicochemical, mineralogical, and morphological characteristics of concrete exposed to elevated temperatures , 2002 .

[12]  C. Tang,et al.  Thermal induced stress and associated cracking in cement-based composite at elevated temperatures––Part I: Thermal cracking around single inclusion , 2004 .

[13]  A. Neville.  Properties of Concrete , 1968 .

[14]  Alain Ehrlacher,et al.  The use of thermal analysis in assessing the effect of temperature on a cement paste , 2005 .

[15]  C. Bei-bei.  Investigation on Thermal Deformation Divergence Between Components of Cement-basted Materials , 2007 .

[16]  I. Swainson,et al.  Internal stress within hardened cement paste induced through thermal mismatch: Calcium hydroxide versus calcium silicate hydrate , 2001 .

[17]  M. Pigeon,et al.  Influence of key parameters on drying shrinkage of cementitious materials , 1999 .

[18]  C. Tang,et al.  Numerical tests of thermal cracking induced by temperature gradient in cement-based composites under thermal loads , 2007 .

[19]  A. Alshamsi,et al.  Microsilica and ground granulated blast furnace slag effects on hydration temperature , 1997 .

[20]  F. Wittmann,et al.  Experimental study of thermal expansion of hardened cement paste , 1974 .