Thermoeconomic design and optimization of frost-free refrigerators

Abstract An optimization methodology aiming at energy and cost savings in frost-free refrigerators is advanced. A steady-state simulation model was devised and its predictions for energy consumption were compared with experimental data obtained elsewhere, with differences not exceeding a +/− 9% error band. The model was used to find out the evaporator air flow rate, the number of evaporator and condenser fins, the compressor size and efficiency, and the insulation thicknesses of both fresh- and frozen-food compartments which yield the minimum energy consumption when the total cost is constrained. The optimization led to a refrigeration system with energy consumption 18% lower than that observed for the baseline system without any cost penalty. The system performance for four different compressors, including a high efficiency, a large capacity and a variable-speed one, was also analyzed. For the refrigerator under analysis, it was found that, to ensure an economically feasible design, the variable-speed compressor should not cost 26% more than a single-speed one with the same piston displacement.

[1]  Christian J.L. Hermes,et al.  Simulation-based design and optimization of refrigeration cassettes☆ , 2011 .

[2]  L. Ploug-S⊘rensen,et al.  Improvements in the Modeling and Simulation of Refrigeration Systems: Aerospace Tools Applied to a Domestic Refrigerator , 1997 .

[3]  W. B. Gosney.  Principles of Refrigeration , 1982 .

[4]  W. F. Stoecker,et al.  Refrigeration and air conditioning , 1958 .

[5]  Christian J.L. Hermes,et al.  COP-based optimization of accelerated flow evaporators for household refrigeration applications , 2011 .

[6]  S. Touber,et al.  Simulation model of a vapor compression refrigeration system , 1983 .

[7]  Zhijiu Chen,et al.  Dynamic simulation and optimal matching of a small-scale refrigeration system , 1991 .

[8]  Christian J.L. Hermes,et al.  PREDICTION OF THE ENERGY CONSUMPTION OF HOUSEHOLD REFRIGERATORS AND FREEZERS VIA STEADY-STATE SIMULATION , 2009 .

[9]  Cezar O.R. Negrão,et al.  A semi-empirical model for the unsteady-state simulation of reciprocating compressors for household refrigeration applications , 2011 .

[10]  Christian J.L. Hermes,et al.  A FIRST-PRINCIPLES SIMULATION MODEL FOR THE START-UP AND CYCLING TRANSIENTS OF HOUSEHOLD REFRIGERATORS , 2008 .

[11]  Susan W. Stewart,et al.  Finned-Tube Heat Exchanger Optimization Methodology , 2005 .

[12]  L. Kuijpers,et al.  Cycling losses in domestic appliances: an experimental and theoretical analysis , 1992 .

[13]  Cezar O.R. Negrão,et al.  Energy and cost savings in household refrigerating appliances: A simulation-based design approach , 2011 .

[14]  C. K. Rice.  The effect of void fraction correlation and heat flux assumption on refrigerant charge inventory predictions , 1987 .

[15]  Christian J.L. Hermes,et al.  A heat transfer correlation for natural draft wire-and-tube condensers , 2009 .

[16]  Pradeep Bansal,et al.  Modelling and optimisation of wire-and-tube condenser , 2003 .

[17]  Jamil A. Khan,et al.  Design and multi-objective optimization of heat exchangers for refrigerators , 2007 .

[18]  Christian J.L. Hermes,et al.  Modeling of non-adiabatic capillary tube flows : A simplified approach and comprehensive experimental validation , 2008 .

[19]  Christian J.L. Hermes,et al.  A study of the air-side heat transfer and pressure drop characteristics of tube-fin 'no-frost' evaporators , 2009 .