Improvements in numerical simulation of the SPR process using a thermo-mechanical finite element analysis

Self-piercing riveting (SPR) has been widely used over recent years in the automotive industry to join lightweight aluminium structures. However, the extensive experimental trials needed to assess the feasible rivet/die combinations within a body in white assembly facility present a serious constraint for the application of this process on a large manufacturing scale. Therefore, having a virtual tool able to assess or predict the feasibility of a rivet/die combination is of primary importance for the automotive industry. In this study, a 2D axisymmetric model based on thermo-mechanical finite element analysis (FEA) was proposed to simulate the SPR process using material data determined at a strain rate of 1 s−1 and temperatures ranging from ambient to 300 °C. The increase in temperature due to friction and plastic deformation was numerically investigated using simufact.forming™ software. The effects of thermal softening and strain hardening at different strain rates were characterized for the substrate material (aluminium alloy AA5754) and their influence on the numerical simulation assessed. Accounting for these parameters led to a significantly higher level of correlation between simulation and experimental results for a number of different SPR joint configurations representative of industrial applications.

[1]  W Voelkner,et al.  Present and future developments of metal forming: selected examples , 2000 .

[2]  J. F. Archard,et al.  The temperature of rubbing surfaces , 1959 .

[3]  Stefania Bruschi,et al.  Effect of warm forming conditions on AZ31B flow behaviour and microstructural characteristics , 2011 .

[4]  Yohei Abe,et al.  Plastic Joining of Ultra High Strength Steel and Aluminium Alloy Sheets by Self Piercing Rivet , 2006 .

[5]  John E. Carsley,et al.  Forming of aluminum alloys at elevated temperatures – Part 1: Material characterization , 2006 .

[6]  A. Pandey,et al.  Negative to positive strain rate sensitivity in 5xxx series aluminum alloys: Experiment and constitutive modeling , 2014 .

[7]  Xiaocong He,et al.  Self-pierce riveting for sheet materials: State of the art , 2008 .

[8]  K. Chan,et al.  Strain rate sensitivity of a high-strain-rate superplastic Al6061/20SiCW composite under uniaxial and equibiaxial tension , 2001 .

[9]  Geoffrey Davies.  Chapter 2 – Design and material utilization , 2012 .

[10]  G. Taylor,et al.  The Heat Developed during Plastic Extension of Metals , 1925 .

[11]  M. Langseth,et al.  Self-piercing riveting process: An experimental and numerical investigation , 2006 .

[12]  M. Langseth,et al.  Self-piercing riveting connections using aluminium rivets , 2010 .

[13]  Pierre-Olivier Bouchard,et al.  Numerical modeling of self-pierce riveting—From riveting process modeling down to structural analysis , 2008 .

[14]  G. Casalino,et al.  On the numerical modelling of the multiphysics self piercing riveting process based on the finite element technique , 2008, Adv. Eng. Softw..

[15]  Fahrettin Ozturk,et al.  Review of warm forming of aluminum-magnesium alloys , 2008 .

[16]  Fabrizio Micari,et al.  Joining by plastic deformation , 2013 .

[17]  John E. Carsley,et al.  Forming of AA5182-O and AA5754-O at elevated temperatures using coupled thermo-mechanical finite element models , 2007 .

[18]  Li Han,et al.  A comparison of the mechanical behaviour of self-piercing riveted and resistance spot welded aluminium sheets for the automotive industry , 2010 .