Applicability of the minimum entropy generation method for optimizing thermodynamic cycles

Entropy generation is often used as a figure of merit in thermodynamic cycle optimizations. In this paper, it is shown that the applicability of the minimum entropy generation method to optimizing output power is conditional. The minimum entropy generation rate and the minimum entropy generation number do not correspond to the maximum output power when the total heat into the system of interest is not prescribed. For the cycles whose working medium is heated or cooled by streams with prescribed inlet temperatures and prescribed heat capacity flow rates, it is theoretically proved that both the minimum entropy generation rate and the minimum entropy generation number correspond to the maximum output power when the virtual entropy generation induced by dumping the used streams into the environment is considered. However, the minimum principle of entropy generation is not tenable in the case that the virtual entropy generation is not included, because the total heat into the system of interest is not fixed. An irreversible Carnot cycle and an irreversible Brayton cycle are analysed. The minimum entropy generation rate and the minimum entropy generation number do not correspond to the maximum output power if the heat into the system of interest is not prescribed.

[1]  Govind Maheshwari,et al.  Performance analysis of endoreversible combined Carnot cycles based on new maximum efficient power (MEP) approach , 2010 .

[2]  Ibrahim Dincer,et al.  Cost and Entropy Generation Minimization of a Cross-Flow Plate Fin Heat Exchanger Using Multi-Objective Genetic Algorithm , 2011 .

[3]  汪浩,et al.  Optimization criteria of a Bose Brayton heat engine , 2012 .

[4]  Ramesh K. Shah,et al.  Entropy generation extrema and their relationship with heat exchanger effectiveness: Number of transfer unit behavior for complex flow arrangements , 2004 .

[5]  Cai Guobiao,et al.  Scaling of heat transfer in gas–gas injector combustor , 2011 .

[6]  Kyaw Thu,et al.  A second law analysis and entropy generation minimization of an absorption chiller , 2011 .

[7]  Ning Pan,et al.  A comparison of optimization theories for energy conservation in heat exchanger groups , 2011 .

[8]  Xingang Liang,et al.  Computation of effectiveness of two-stream heat exchanger networks based on concepts of entropy generation, entransy dissipation and entransy-dissipation-based thermal resistance , 2012 .

[9]  XinGang Liang,et al.  Analyses of entransy dissipation, entropy generation and entransy–dissipation-based thermal resistance on heat exchanger optimization , 2012 .

[10]  D. T. Reindl,et al.  The Relationship of Optimum Heat Exchanger Allocation and Minimum Entropy Generation Rate for Refrigeration Cycles , 1998 .

[11]  Ning Pan,et al.  Optimization principles for convective heat transfer , 2009 .

[12]  Tanmay Basak,et al.  Entropy generation due to natural convection in discretely heated porous square cavities , 2011 .

[13]  XueTao Cheng,et al.  Application of entransy to optimization design of parallel thermal network of thermal control system in spacecraft , 2011 .

[14]  Xiaodong Qian,et al.  Analysis of entransy dissipation in heat exchangers , 2011 .

[15]  Wen-Quan Tao,et al.  Effectiveness–thermal resistance method for heat exchanger design and analysis , 2010 .

[16]  Yasin Ust,et al.  The Effects of Cycle Temperature and Cycle Pressure Ratios on the Performance of an Irreversible Otto Cycle , 2011 .

[17]  A. S. Adavbiele,et al.  Optimization of Thermofluid Systems with Second Law , 2010 .

[18]  John H. Lienhard,et al.  Effect of entropy generation on the performance of humidification-dehumidification desalination cycles , 2010 .

[19]  A. Bejan.  Advanced Engineering Thermodynamics , 1988 .

[20]  Ronan K. McGovern,et al.  Entropy Generation Analysis of Desalination Technologies , 2011, Entropy.

[21]  Mingtian Xu,et al.  Second law analysis of curved rectangular channels , 2011 .

[22]  Cha'o-Kuang Chen,et al.  The Effect of Thermal Radiation on Entropy Generation Due to Micro-Polar Fluid Flow Along a Wavy Surface , 2011, Entropy.

[23]  S. Ray,et al.  Performance optimisation of laminar fully developed flow through square ducts with rounded corners , 2011 .

[24]  Tu Zhan-Chun.  Recent advance on the efficiency at maximum power of heat engines , 2012 .

[25]  Ammar Ben Brahim,et al.  Entropy Generation at Natural Convection in an Inclined Rectangular Cavity , 2011, Entropy.