Design of a Knee Exoskeleton Using Foot Pressure and Knee Torque Sensors

This study presents the development of a modular knee exoskeleton system that supports the knee joints of hemiplegic patients. The device is designed to realize the polycentric motion of real human knees using a four-bar linkage and to minimize its total weight. In order to determine the user's intention, force-sensitive resistors (FSRs) in the user's insole, a torque sensor on the robot knee joint, and an encoder in the motor are used. The control algorithm is based on a finite state machine (FSM), where the force control, position control and virtual damping control are applied in each state. The proposed hardware design and algorithm are verified by performing experiments on the standing walking and sitting motion controls while wearing the knee exoskeleton.

[1]  Lauri Bishop,et al.  A wearable robotic knee orthosis for gait training: a case-series of hemiparetic stroke survivors , 2012, Prosthetics and orthotics international.

[2]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[3]  K Manal,et al.  Knee moment profiles during walking: errors due to soft tissue movement of the shank and the influence of the reference coordinate system. , 2002, Gait & posture.

[4]  Toshiki Kobayashi,et al.  Kinetic Gait Analysis Using a Low-Cost Insole , 2013, IEEE Transactions on Biomedical Engineering.

[5]  Michael Greene.  Four Bar Linkage Knee Analysis , 2011 .

[6]  Homayoon Kazerooni,et al.  The development and testing of a human machine interface for a mobile medical exoskeleton , 2011, 2011 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[7]  Jerry E. Pratt,et al.  The RoboKnee: an exoskeleton for enhancing strength and endurance during walking , 2004, IEEE International Conference on Robotics and Automation, 2004. Proceedings. ICRA '04. 2004.

[8]  H. Kawamoto,et al.  Power assist method for HAL-3 using EMG-based feedback controller , 2003, SMC'03 Conference Proceedings. 2003 IEEE International Conference on Systems, Man and Cybernetics. Conference Theme - System Security and Assurance (Cat. No.03CH37483).

[9]  Ken Endo,et al.  A Quasi-Passive Leg Exoskeleton for Load-Carrying Augmentation , 2007, Int. J. Humanoid Robotics.

[10]  A. Randolph,et al.  Reliability of measurements of pressures applied on the foot during walking by a computerized insole sensor system. , 2000, Archives of physical medicine and rehabilitation.

[11]  Jun-Ho Oh,et al.  Adjustment of Home Posture of Biped Humanoid Robot Using Sensory Feedback Control , 2008, J. Intell. Robotic Syst..

[12]  Adam Zoss,et al.  Mobile Exoskeleton for Spinal Cord Injury: Development and Testing , 2011 .

[13]  Olivier Lambercy,et al.  Design of a wearable perturbator for human knee impedance estimation during gait , 2013, 2013 IEEE 13th International Conference on Rehabilitation Robotics (ICORR).

[14]  Volkan Patoglu,et al.  AssistOn-Knee: A self-aligning knee exoskeleton , 2013, 2013 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[15]  Robert W. Horst,et al.  A bio-robotic leg orthosis for rehabilitation and mobility enhancement , 2009, 2009 Annual International Conference of the IEEE Engineering in Medicine and Biology Society.

[16]  Richard Volpe,et al.  A theoretical and experimental investigation of explicit force control strategies for manipulators , 1993, IEEE Trans. Autom. Control..

[17]  S. Gard,et al.  The Influence of Four‐Bar Linkage Knees on Prosthetic Swing‐Phase Floor Clearance , 1996 .

[18]  Franziska Hoffmann.  Design Of Machinery An Introduction To The Synthesis And Analysis Of Mechanisms And Machines , 2016 .

[19]  Aaron M. Dollar,et al.  Design of a quasi-passive knee exoskeleton to assist running , 2008, 2008 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[20]  R.W. Horst,et al.  FlexCVA: A Continuously Variable Actuator for Active Orthotics , 2006, 2006 International Conference of the IEEE Engineering in Medicine and Biology Society.

[21]  Jun-Ho Oh,et al.  Adaptive walking pattern generation and balance control of the passenger-carrying biped robot, HUBO FX-1, for variable passenger weights , 2011, Auton. Robots.

[22]  Günter Hommel,et al.  A Human--Exoskeleton Interface Utilizing Electromyography , 2008, IEEE Transactions on Robotics.

[23]  M P Kadaba,et al.  Measurement of lower extremity kinematics during level walking , 1990, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[24]  P. Cochat,et al.  Et al , 2008, Archives de pediatrie : organe officiel de la Societe francaise de pediatrie.

[25]  Günter Hommel,et al.  Predicting the intended motion with EMG signals for an exoskeleton orthosis controller , 2005, 2005 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[26]  Jennifer M Scarvell,et al.  Development of the concepts of knee kinematics. , 2003, Archives of physical medicine and rehabilitation.

[27]  Conor James Walsh,et al.  An autonomous, underactuated exoskeleton for load-carrying augmentation , 2006, 2006 IEEE/RSJ International Conference on Intelligent Robots and Systems.